Forced convective heat transfer by swirling impinging jets issuing from nozzles equipped with twisted tapes

被引：52
|
作者：
Nanan, K. [1 ]
Wongcharee, K. [2 ]
Nuntadusit, C. [3 ]
Eiamsa-ard, S. [1 ]
机构：
[1] Mahanakorn Univ Technol, Fac Engn, Dept Mech Engn, Bangkok 10530, Thailand
[2] Mahanakorn Univ Technol, Fac Engn, Dept Chem Engn, Bangkok 10530, Thailand
[3] Prince Songkla Univ, Fac Engn, Dept Mech Engn, Hat Yai 90112, Songkhla, Thailand
来源：
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER | 2012年 / 39卷 / 06期
关键词：
Impinging jet; Round jet; Heat transfer; Swirling jet; TRANSFER ENHANCEMENT; THERMAL PERFORMANCE; TUBE; FLOW; FIELD;
D O I：
10.1016/j.icheatmasstransfer.2012.05.002
中图分类号：
O414.1 [热力学];
学科分类号：
摘要：
Forced convective heat transfer on the impinged plate associated with swirling impinging jets (SIJ) issuing from nozzles inserted by twisted tapes has been investigated. Swirling impingement jets with several swirl rates were generated by twisted tapes at different twist ratios (y/W = 3, 4, 5, and 6). The experiments were performed by locating nozzle at 4 different jet-to-plate spacings of L/D = 2, 4, 6 and 8. A jet Reynolds number varied between 4000 and 16000. Attributing to a high momentum transfer rate, an efficient heat transfer was obtained by using the jet with a small jet-to-plate spacing and the twist tape with a large twist ratio at high Reynolds number. At small jet-to-plate spacings (L/D = 2 and 4), swirling impinging jets gave higher heat transfer rate than conventional impinging jets while at large jet-to-plate spacings (L/D = 6 and 8), the opposed result was obtained. Over the range examined, only SIJ induced by the twisted tape at a twist ratio of 6 consistently provided higher average Nusselt numbers than CIJ. (C) 2012 Elsevier Ltd. All rights reserved.
引用
收藏
页码：844 / 852
页数：9
相关论文
共 50 条
  • [21] Flow and heat transfer characteristics of a swirling impinging jet issuing from a threaded nozzle
    Xu, Liang
    Yang, Tao
    Sun, Yanhua
    Xi, Lei
    Gao, Jianmin
    Li, Yunlong
    Li, Jibao
    CASE STUDIES IN THERMAL ENGINEERING, 2021, 25
  • [22] Experimental investigation on heat transfer from square jets issuing from perforated nozzles
    Muvvala, Pullarao
    Balaji, C.
    Venkateshan, S. P.
    HEAT AND MASS TRANSFER, 2017, 53 (07) : 2363 - 2375
  • [23] Experimental investigation on heat transfer from square jets issuing from perforated nozzles
    Pullarao Muvvala
    C. Balaji
    S. P. Venkateshan
    Heat and Mass Transfer, 2017, 53 : 2363 - 2375
  • [24] Heat transfer characteristics of swirling and non-swirling impinging turbulent jets
    Ahmed, Zahir U.
    Al-Abdeli, Yasir M.
    Guzzomi, Ferdinando G.
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 102 : 991 - 1003
  • [25] On coherent structures and heat transfer in strongly swirling impinging jets
    Abdurakipov, S.
    Sharaborin, D.
    XXXVI SIBERIAN THERMOPHYSICAL SEMINAR (STS 36), 2020, 1677
  • [26] Heat transfer rate and uniformity in multichannel swirling impinging jets
    Ianiro, Andrea
    Cardone, Gennaro
    APPLIED THERMAL ENGINEERING, 2012, 49 : 89 - 98
  • [27] Flow and heat transfer characteristics of turbulent swirling impinging jets
    Ikhlaq, Muhammad
    Al-Abdeli, Yasir M.
    Khiadani, Mehdi
    APPLIED THERMAL ENGINEERING, 2021, 196
  • [28] Forced convective heat transfer on a horizontal circular cylinder due to multiple impinging circular jets
    Csernyei, Christopher
    Straatman, Anthony G.
    APPLIED THERMAL ENGINEERING, 2016, 105 : 290 - 303
  • [29] Forced convective two phase flow analysis in a circular tube equipped with twisted tapes
    Omeroglu, Gokhan
    Comakli, Omer
    Karagoz, Sendogan
    Manay, Eyuphan
    Energy Education Science and Technology Part A: Energy Science and Research, 2012, 30 (SPEC .ISS.1): : 561 - 572
  • [30] Transient heat transfer characteristics of swirling and non-swirling turbulent impinging jets
    Ikhlaq, Muhammad
    Al-Abdeli, Yasir M.
    Khiadani, Mehdi
    EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2019, 109
12345