Bearing strength of pinned joints in woven fabric composites with small weaving angles

被引：21
|
作者：
Atas, Cesim [1 ]
机构：
[1] Dokuz Eylul Univ, Dept Mech Engn, TR-35100 Izmir, Turkey
来源：
COMPOSITE STRUCTURES | 2009年 / 88卷 / 01期
关键词：
Small weaving angle; Glass/epoxy composite; Pinned joint; Failure modes; MECHANICALLY FASTENED JOINTS; BOLT-HOLE CLEARANCE; FAILURE ANALYSIS; STACKING-SEQUENCE; CLAMPING LOADS; STRESS; PREDICTION;
D O I：
10.1016/j.compstruct.2008.04.002
中图分类号：
O3 [力学];
学科分类号：
08 ; 0801 ;
摘要：
Bearing strength of pinned joints in woven fabric composites with small weaving angles is examined experimentally in this study. Such woven fabrics, i.e. non-orthogonal fabrics, are not commercially available. Therefore, a step-by-step procedure for transforming an orthogonal fabric into a non-orthogonal fabric with small weaving angles is presented. Four different stacking sequences are chosen for comparison, considering ratios w/d = 3, 4 and e/d = 1, 2, 3. It is concluded that using layers with identical orientations may result in undesirable severe damage modes and small load carrying capacities in mechanically fastened joints of woven fabric composites with small weaving angles. A few recommendations regarding how to avoid premature failure, obtain bearing as the primary mode of failure and increase load carrying capacity can be found in the text and Section 5. (C) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码：40 / 45
页数：6
相关论文
共 50 条
  • [41] Numerical and experimental investigation on the load-bearing performance of plain-woven composites hybrid bonded-bolted joints
    Shi, Jianwei
    Yang, Xiaodong
    Chen, Xishuai
    Du, Kou
    Li, Cheng
    Yang, Yaxu
    POLYMER COMPOSITES, 2024, 45 (02) : 1195 - 1207
  • [42] Influence of fibre steering on the bearing performance of bolted joints in 3D printed pseudo-woven CFRP composites
    Li, Aonan
    Zhang, Haoqi
    Yang, Dongmin
    COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2024, 181
  • [43] Elastic properties, notched strength and fracture criterion in untreated woven jute-glass fabric reinforced polyester hybrid composites
    Ahmed, K. Sabeel
    Vijayarangan, S.
    Naidu, A. C. B.
    MATERIALS & DESIGN, 2007, 28 (08) : 2287 - 2294
  • [44] Bearing Stress at Failure of Double-Lap Hybrid Joints in Woven Fabric Kenaf Fiber Composite Plates under Quasi-static Loading
    Lee, Sim Yee
    Ahmad, Hilton
    INTERNATIONAL SYMPOSIUM ON CIVIL AND ENVIRONMENTAL ENGINEERING 2016 (ISCEE 2016), 2017, 103
  • [45] Breathable and impact-resistant shear thickening gel based three-dimensional woven fabric composites constructed by an efficient weaving strategy for wearable protective equipment
    Tan, Yuhao
    Ma, Yanxue
    Liu, Jingyan
    Liu, Zongjun
    Wu, Fengfan
    Li, Yuling
    COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2024, 177
  • [46] NUMERICAL AND EXPERIMENTAL EVALUATION OF CRYOGENIC TENSILE STRENGTH OF WOVEN FABRIC-REINFORCED GLASS/EPOXY COMPOSITES USING OPEN HOLE SPECIMENS
    Shindo, Yasuhide
    Watanabe, Shinya
    Takeda, Tomo
    Narita, Fumio
    Matsuda, Takuya
    Yamaki, Satoru
    JOURNAL OF MECHANICS OF MATERIALS AND STRUCTURES, 2011, 6 (1-4) : 545 - 556
  • [47] Influence of nanoparticle fillers content on the bearing strength behavior of glass fiber-reinforced epoxy composites pin joints
    Sekhon, Manjeet
    Saini, J. S.
    Singla, Gaurav
    Bhunia, H.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART L-JOURNAL OF MATERIALS-DESIGN AND APPLICATIONS, 2017, 231 (08) : 641 - 656
  • [48] The Bearing Strength of Pin Loaded Woven Composites Manufactured by Vacuum Assisted Resin Transfer Moulding and Hand Lay-Up Techniques
    Sevkat, Ercan
    Brahimi, Malek
    Berri, Sidi
    POLYMERS & POLYMER COMPOSITES, 2012, 20 (03): : 321 - 331
  • [49] The bearing strength of pin loaded woven composites manufactured by vacuum assisted resin transfer moulding and hand lay-up techniques
    Sevkat, Ercan
    Brahimi, Malek
    11TH INTERNATIONAL CONFERENCE ON THE MECHANICAL BEHAVIOR OF MATERIALS (ICM11), 2011, 10
  • [50] The compression-after-impact strength of woven and non-crimp fabric reinforced composites subjected to long-term water immersion ageing
    K. Berketis
    D. Tzetzis
    Journal of Materials Science, 2010, 45 : 5611 - 5623
12345