Aging behavior of Y-TZP with bioglass addition and its impact on the flexural strength and osteoblastic cell response

被引:1
|
作者
Soubelet, Clara G. [1 ]
Albano, Maria P. [1 ]
Zuardi, Leonardo Raphael [2 ]
Martorano, Antonio Secco [3 ]
Spinola de Castro-Raucci, Larissa Moreira [3 ]
de Oliveira, Paulo Tambasco [2 ]
机构
[1] Consejo Nacl Invest Cient & Tecn, CCT La Plata, CICPBA, Ctr Tecnol Recursos Minerales & Ceram CETMIC, La Plata, Buenos Aires, Argentina
[2] Univ Sao Paulo FORP USP, Sch Dent Ribeirao Preto, Sao Paulo, Brazil
[3] Univ Ribeirao Preto UNAERP, Sao Paulo, Brazil
关键词
aging behavior; dental ceramics; flexural strength; osteoblastic cell response; Y-TZP with a refractory bioglass addition; LOW-TEMPERATURE DEGRADATION; IN-VITRO CHARACTERIZATION; STABILIZED ZIRCONIA; GRAIN-GROWTH; CERAMICS; TRANSFORMATION;
D O I
10.1111/ijac.13608
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Y-TZP containing Ca(2)P(2)O(7)are promising bioceramics with potential applications in dental implants and dentistry. These ceramics were developed by the introduction of a refractory sol-gel derived CaO-P2O5-SiO(2)bioglass into Y-TZP; Ca2P2O7, and ZrSiO(4)phases were formed in situ after sintering. The aging process of Y-TZP with different glass additions was studied. The effect of glass addition on the flexural strength and osteoblastic cell response of non-aged and aged Y-TZP was investigated. Y-TZP exhibited the most pronounced tetragonal (t) to monoclinic (m) transformation of zirconia (ZrO2) during aging; the addition of glass contents between 5 and 20 vol% improved the aging resistant of Y-TZP. Y-TZP flexural strength markedly decreased with increasing aging time; in contrast, the ceramics with glass did not alter their flexural strength upon aging. An increase in the Ca(2)P(2)O(7)content with increasing glass up to 10 vol%, promoted both the cell viability and the osteogenic differentiation of UMR-106 cells on non-aged and aged samples. The high micro-roughness of Y-TZP with 20 vol% glass after aging, limited the proliferation and the osteogenic potential of the cultures. Y-TZP with 10 vol% glass had the best combination of properties in terms of flexural strength and osteoblast cell response.
引用
收藏
页码:2792 / 2806
页数:15
相关论文
共 47 条
  • [41] Impact of high-speed sintering on translucency, phase content, grain sizes, and flexural strength of 3Y-TZP and 4Y-TZP zirconia materials
    Jansen, Jan Ulrich
    Luemkemann, Nina
    Letz, Inge
    Pfefferle, Regina
    Sener, Beatrice
    Stawarczyk, Bogna
    JOURNAL OF PROSTHETIC DENTISTRY, 2019, 122 (04): : 396 - 403
  • [42] Effect of 64S bioglass addition on sintering kinetic, flexural strength and osteoblast cell response of yttria-partially stabilized zirconia ceramics
    Stabile, Matias F.
    Soubelet, Clara G.
    Albano, Maria P.
    Rosa, Adalberto L.
    Spinola de Castro-Raucci, Larissa Moreira
    de Oliveira, Paulo Tambasco
    INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY, 2019, 16 (02) : 517 - 530
  • [43] Phase stability after aging and its influence on pin-on-disk wear properties of Ce-TZP/Al2O3 nanocomposite and conventional Y-TZP
    Tanaka, K
    Tamura, J
    Kawanabe, K
    Nawa, M
    Uchida, M
    Kokubo, T
    Nakamura, T
    JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART A, 2003, 67A (01) : 200 - 207
  • [44] Effects of core-to-dentin thickness ratio on the biaxial flexural strength, reliability, and fracture mode of bilayered materials of zirconia core (Y-TZP) and veneer indirect composite resins
    Su, Naichuan
    Liao, Yunmao
    Zhang, Hai
    Yue, Li
    Lu, Xiaowen
    Shen, Jiefei
    Wang, Hang
    JOURNAL OF PROSTHETIC DENTISTRY, 2017, 117 (01): : 150 - 157
  • [45] A new technique for incorporation of TiO2 nanotubes on a pre-sintered Y-TZP and its effect on bond strength as compared to conventional air-borne particle abrasion and silicatization TiO2 nanotubes application on pre-sintered Y-TZP
    Mezarina-Kanashiro, Franco Naoki
    Bronze-Uhle, Erika Soares
    Piola Rizzante, Fabio Antonio
    Lisboa-Filho, Paulo Noronha
    Sanches Borges, Ana Flavia
    Furuse, Adilson Yoshio
    DENTAL MATERIALS, 2022, 38 (08) : e220 - e230
  • [46] Effect of sintering temperature and low-temperature aging on microstructure and flexural strength of Fe2O3-doped 3Y-TZP ceramics fabricated by stereolithography-based additive manufacturing
    Wang, Li
    Jiao, Yang
    Yao, Lian
    Tang, Weizhe
    Dou, Rui
    CERAMICS INTERNATIONAL, 2023, 49 (23) : 37307 - 37315
  • [47] Addition of thermo-plastic polyurethane (TPU) to poly(methyl methacrylate) (PMMA) to improve its impact strength and to change its scratch behavior
    Seeger, Philipp
    Ratfisch, Rouven
    Moneke, Martin
    Burkhart, Thomas
    WEAR, 2018, 406 : 68 - 74