Impact of the volume change on the ageing effects in Cu-Al-Ni martensite: experiment and theory

被引:7
|
作者
Kosogor, Anna [1 ]
Xue, Dezhen [2 ]
Zhou, Yumei [2 ]
Ding, Xiangdong [2 ]
Otsuka, Kazuhiro [3 ]
L'vov, Victor A. [1 ,4 ]
Sun, Jun [2 ]
Ren, Xiaobing [2 ,3 ]
机构
[1] Inst Magnetism, UA-03142 Kiev, Ukraine
[2] Xi An Jiao Tong Univ, State Key Lab Mech Behav Mat, Frontier Inst Sci & Technol, Multidisciplinary Mat Res Ctr, Xian 710049, Peoples R China
[3] Natl Inst Mat Sci, Ferro Phys Grp, Tsukuba, Ibaraki 3050047, Japan
[4] Taras Shevchenko Univ, UA-01601 Kiev, Ukraine
基金
中国国家自然科学基金;
关键词
SHAPE-MEMORY ALLOYS; RUBBER-LIKE BEHAVIOR; MN-GA; HYDROSTATIC-PRESSURE; STABILIZATION; TRANSFORMATIONS; RELAXATION; MECHANISM; CRYSTALS; STRESS;
D O I
10.1088/0953-8984/25/33/335402
中图分类号
O469 [凝聚态物理学];
学科分类号
070205 ;
摘要
The time evolution of the physical properties of martensite during martensite ageing is traditionally explained by the symmetry-conforming short-range order (SC-SRO) principle, which requires the spatial configuration of crystal defects to follow the symmetry change of the host lattice. In the present study, we show that the volume change of the host lattice also contributes to the ageing effects in Cu-Al-Ni shape memory alloy besides the symmetry change. To substantiate this statement the gradual increase of the storage modulus with time at constant temperature was measured by dynamic mechanical analysis (DMA) and the experimental results were quantitatively described in the framework of the symmetry-conforming Landau theory of martensitic transformations in a crystal with defects. The comparison of experimental and theoretical results confirmed that the time dependence of the storage modulus is caused by two different physical mechanisms. Evaluations showing that the first mechanism is driven by the spontaneous symmetry change and the second mechanism is caused by the volume change after the martensitic transformation was carried out.
引用
收藏
页数:8
相关论文
共 50 条
  • [41] ELECTRON-MICROSCOPE STUDY OF THE MATRIX-MARTENSITE INTERFACE IN CU-AL-NI ALLOYS
    TADAKI, T
    KAKESHITA, T
    SHIMIZU, K
    JOURNAL DE PHYSIQUE, 1982, 43 (NC-4): : 191 - 196
  • [42] INTERNAL FRICTION IN CU-AL-NI ALLOYS IN TEMPERATURE RANGE OF FORMATION OF ELASTIC MARTENSITE CRYSTALS
    ARBUZOVA, IA
    GAVRILYU.VS
    KHANDROS, LG
    PHYSICS OF METALS AND METALLOGRAPHY-USSR, 1969, 27 (06): : 183 - &
  • [43] STACKING MODULATION OF STRESS-INDUCED MARTENSITE IN CU-AL-NI SINGLE-CRYSTALS
    MARTYNOV, VV
    KHANDROS, LG
    TKACHENKO, AV
    SCRIPTA METALLURGICA, 1983, 17 (10): : 1173 - 1176
  • [44] STACKING-FAULT MODULATION OF MARTENSITE FORMED IN CU-AL-NI ALLOY ON TENSILE LOADING
    MARTYNOV, VV
    TKACHENKO, AV
    KHANDROS, LG
    PHYSICS OF METALS, 1985, 6 (05): : 967 - 972
  • [45] Orientation dependence of σ-T phase diagrams for martensite transformations in Cu-Al-Ni single crystals
    Novak, V.
    Malimanek, J.
    Zarubova, N.
    Mechanical and corrosion properties. Series A, Key engineering materials, 1994, 97-98 : 419 - 424
  • [46] Identification of 6R martensite in aged Cu-Al-Ni after pseudoelastic mechanical cycles
    Bubani, F. De Castro
    Panizo, M. Mosquera
    Zelaya, E.
    Gastien, R.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2023, 941
  • [47] Non-classical austenite-martensite interfaces observed in single crystals of Cu-Al-Ni
    Seiner, H.
    Landa, M.
    PHASE TRANSITIONS, 2009, 82 (11) : 793 - 807
  • [48] UNUSUAL STRAIN RECOVERY IN LAMBDA-1-' MARTENSITE SINGLE VARIANT OF CU-AL-NI ALLOY
    ICHIKAWA, T
    OTANI, N
    MIYAZAKI, S
    OTSUKA, K
    SCRIPTA METALLURGICA, 1989, 23 (08): : 1329 - 1334
  • [49] THERMAL CYCLING EFFECTS IN A CU-AL-NI SHAPE MEMORY ALLOY
    NAKATA, Y
    TADAKI, T
    SHIMIZU, K
    TRANSACTIONS OF THE JAPAN INSTITUTE OF METALS, 1985, 26 (09): : 646 - 652
  • [50] Precipitation sequence during ageing in β1 phase of Cu-Al-Ni shape memory alloy
    Bouabdallah, Mabrouk
    Baguenane-Benalia, Ghalia
    Saadi, Amar
    Cheniti, Hicham
    Gachon, Jean-Claude
    Patoor, Etienne
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2013, 112 (01) : 279 - 283