Swirling annular impinging jets under hysteretic behavior

被引：0
|
作者：
Travnicek, Z. [1 ]
Werner, E.
Marsik, F. [1 ]
Kordik, J. [1 ]
Simurda, D. [1 ]
机构：
[1] Inst Thermomech AS CR, Vvi, Prague 18200 8, Czech Republic
来源：
TURBULENCE, HEAT AND MASS TRANSFER 6 | 2009年
关键词：
D O I：
暂无
中图分类号：
TH [机械、仪表工业];
学科分类号：
0802 ;
摘要：
This paper is focused on an annular impinging jet under hysteretic behavior, and on a possibility to control this phenomenon by means of jet swirling. An experimental study was performed with air as the working fluid using flow visualization, hot wire anemometry and wall pressure measurements. The bistability and hysteresis were confirmed, and two different flowfield patterns were revealed under the same boundary conditions. It was found that weak swirling (S=0.03) decreases a tendency to bistability and hysteretic behavior. The Reynolds number effect was also identified: the bistability and hysteresis exist only at small Reynolds numbers, less than 3000.
引用
收藏
页码：497 / 500
页数：4
相关论文
共 50 条
  • [31] Flow and heat transfer characteristics of turbulent swirling impinging jets
    Ikhlaq, Muhammad
    Al-Abdeli, Yasir M.
    Khiadani, Mehdi
    APPLIED THERMAL ENGINEERING, 2021, 196
  • [32] Toward a vortex breakdown condition for swirling annular jets
    Stein, CF
    JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME, 1999, 121 (01): : 102 - 105
  • [33] Influence of the nozzle geometry on the hysteresis of annular swirling jets
    Vanierschot, M.
    Van den Bulck, E.
    COMBUSTION SCIENCE AND TECHNOLOGY, 2007, 179 (08) : 1451 - 1466
  • [34] Recirculation zones of unconfined and confined annular swirling jets
    Sheen, HJ
    Chen, WJ
    Jeng, SY
    AIAA JOURNAL, 1996, 34 (03) : 572 - 579
  • [35] Azimuthal flow patterns produced by annular swirling jets
    Adjovi, J.
    Foucault, E.
    JOURNAL OF VISUALIZATION, 2007, 10 (02) : 133 - 133
  • [36] Toward a vortex breakdown condition for swirling annular jets
    Department of Mathematics, Chalmers University of Technology, S-412 96 Göteborg, Sweden
    J Fluids Eng Trans ASME, 1 (102-105):
  • [37] Annular Impinging Jet Controlled by Radial Synthetic Jets
    Travnicek, Zdenek
    Tesar, Vaclav
    Brouckova, Zuzana
    Peszynski, Kazimierz
    HEAT TRANSFER ENGINEERING, 2014, 35 (16-17) : 1450 - 1461
  • [38] The effect of inflow conditions on the development of non-swirling versus swirling impinging turbulent jets
    Ahmed, Zahir U.
    Al-Abdeli, Yasir M.
    Matthews, Miccal T.
    COMPUTERS & FLUIDS, 2015, 118 : 255 - 273
  • [39] Erosion behaviour of AISI 310 stainless steel at 450 °C under turbulent swirling impinging jets
    Zaragoza-Granados, J.
    Gallardo-Hernandez, E. A.
    Vite-Torres, M.
    Sedano-de la Rosa, C.
    WEAR, 2019, 426 : 637 - 642
  • [40] Erosion-corrosion of X-52 steel pipe under turbulent swirling impinging jets
    Sedano-de la Rosa, C.
    Vite-Torres, M.
    Godinez-Salcedo, J. G.
    Gallardo-Hernandez, E. A.
    Cuamatzi-Melendez, R.
    Farfan-Cabrera, L. I.
    WEAR, 2017, 376 : 549 - 556
12345