Experimental study on particulate emission of a diesel engine fueled with blended ethanol-dodecanol-diesel

被引:54
|
作者
Di, Yage [1 ,2 ]
Cheung, C. S. [1 ]
Huang, Zuohua [2 ]
机构
[1] Hong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hong Kong, Peoples R China
[2] Xi An Jiao Tong Univ, State Key Lab Multiphase Flow Power Engn, Xian 710049, Peoples R China
关键词
Ethanol; Ultra low sulfur diesel; Diesel ethanol blends; Particulate matter; Particle size distribution; Diesel oxidation catalyst; COMBUSTION CHARACTERISTICS; EXHAUST EMISSIONS; AIR-POLLUTION; PERFORMANCE; SIZE; PARTICLES;
D O I
10.1016/j.jaerosci.2008.09.004
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
Experiments were conducted on a 4-cylinder direct-injection diesel engine which has a compressing ratio of 19, using ultra low sulfur diesel blended with ethanol using 1-1.5% by volume of 1-dodecanol as the solvent to investigate the particulate emissions of the engine under five engine loads and at engine speeds of 1800 and 2400 rev/min. Blended fuels containing 6.1%, 12.2%, 18.2% and 24.2% by volume of ethanol, corresponding to 2%, 4%, 6% and 8% by mass of oxygen in the blended fuel, were used. At both engine speeds, with an increase in ethanol in the fuel, the smoke opacity, the particulate mass concentration and the total number of nano-size particles are all reduced. A diesel oxidation catalyst (Finnkat) was used and found to further reduce particulate emission, The smoke opacity, the particulate mass concentration and the total number concentration at 2400 rev/rnin are higher than those at 1800 rev/min. (C) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码:101 / 112
页数:12
相关论文
共 50 条
  • [41] An experimental study on the combustion characteristics and emission of diesel engine fueled with diesel fuel and its blends with methanol and DME
    Zhu, Jianjun
    Wang, Tie
    Zhang, Cuiping
    Qiche Gongcheng/Automotive Engineering, 2011, 33 (09): : 761 - 766
  • [42] Experimental study on spray and emission characteristics of a diesel engine fueled with preheated bio-oils and diesel fuel
    Anh Tuan Hoang
    ENERGY, 2019, 171 (795-808) : 795 - 808
  • [43] Experimental study on combustion and emission characteristics of a diesel engine fueled with diesel-gasoline-iso-butanol blends
    Li, Song
    Liu, Jinping
    Wang, Fei
    Wang, Junchang
    Wei, Mingrui
    Yang, Shuwen
    FUEL, 2019, 255
  • [44] Investigation on the combustion characteristics and particulate emissions from a diesel engine fueled with diesel-biodiesel-ethanol blends
    Tse, H.
    Leung, C. W.
    Cheung, C. S.
    ENERGY, 2015, 83 : 343 - 350
  • [45] Performance and Emission Characteristics of Diesel Engine Fueled with Ethanol-Diesel Blends in Different Altitude Regions
    Lei, Jilin
    Bi, Yuhua
    Shen, Lizhong
    JOURNAL OF BIOMEDICINE AND BIOTECHNOLOGY, 2011,
  • [46] Effect of the fuel additives on particle emission characteristics of diesel engine fueled with ethanol-diesel blends
    School of Automobile and Traffic Engineering, Jiangsu University, Zhenjiang 212013, China
    Res. Environ. Sci., 12 (1268-1275):
  • [47] Investigation of performance, combustion and emission characteristics in a diesel engine fueled with methanol/ethanol/nHeptane/diesel blends
    Vargun, Mustafa
    Yilmaz, Ilker Turgut
    Sayin, Cenk
    ENERGY, 2022, 257
  • [48] Effect of compression ratio on the performance, combustion and emission of DI diesel engine fueled with ethanol - Diesel blend
    Gnanamoorthi, V.
    Devaradjane, G.
    JOURNAL OF THE ENERGY INSTITUTE, 2015, 88 (01) : 19 - 26
  • [49] Experimental study on performance and emissions characteristics of single cylinder diesel engine with ethanol and biodiesel blended fuels with diesel
    Bhurat, Swapnil Sureshchandra
    Pandey, Shyam
    Chintala, Venkateswarlu
    Ranjit, P. S.
    MATERIALS TODAY-PROCEEDINGS, 2019, 17 : 220 - 226
  • [50] Experimental Investigation of Diesel Engine Fueled with Jatropha Oil Blend with Ethanol
    Vibhanshu, Vipul
    Kumar, Naveen
    Mishra, Chinmaya
    Sinha, Sunil
    Pali, Harveer Singh
    Bansal, Sidharth
    SAE INTERNATIONAL JOURNAL OF FUELS AND LUBRICANTS, 2013, 6 (03) : 951 - 958