The impact of an MPL on water management of an operating PEMFC using synchrotron X-ray radiography

被引:0
|
作者
Lee, J. [1 ]
Hinebaugh, J. [1 ]
Bazylak, A. [1 ]
机构
[1] Univ Toronto, Dept Mech & Ind Engn, Fac Appl Sci & Engn, Toronto, ON M5S 3G8, Canada
关键词
MEMBRANE FUEL-CELLS; GAS-DIFFUSION LAYER; MICROPOROUS LAYER; POROUS LAYER; TRANSPORT; PERFORMANCE; GDL;
D O I
暂无
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
High quality through-plane images of an operating polymer electrolyte membrane fuel cell (PEMFC) were visualized by employing synchrotron X-ray radiography to quantify liquid water in gas diffusion layers (GDL). Two types of GDLs, Toray carbon paper with and without micro-porous layers (MPLs), were employed and imaged during the operation. Performance data and x-ray images of these GDLs are compared to determine the impact of an MPL on water management. At low current density (<0.4A/cm(2)) under high stoichiometric ratio, the MPL has little overall effect, but may behave as a diffusion barrier for reactants. At higher current density (0.6A/m(2)) and under low stoichiometric ratios, the MPL is observed to significantly affect the water management of the PEMFC and is credited for increased cell performance.
引用
收藏
页码:205 / 212
页数:8
相关论文
共 50 条
  • [41] Visualization of water on through-plane direction of GDL using X-ray radiography
    Kim, Jongrok
    Kim, TaeJoo
    Je, Junho
    Kaviany, Massoud
    Son, Sang Young
    Kim, MooHwan
    6TH INTERNATIONAL SYMPOSIUM ON MULTIPHASE FLOW, HEAT MASS TRANSFER AND ENERGY CONVERSION, 2010, 1207 : 101 - +
  • [42] Investigation of water accumulation and discharge behaviors with variation of current density in PEMFC by high-resolution soft X-ray radiography
    Deevanhxay, Phengxay
    Sasabe, Takashi
    Tsushima, Shohji
    Hirai, Shuichiro
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2011, 36 (17) : 10901 - 10907
  • [43] Point x-ray source using graphite nanofibers and its application to x-ray radiography
    Matsumoto, T
    Mimura, H
    APPLIED PHYSICS LETTERS, 2003, 82 (10) : 1637 - 1639
  • [44] The impact of operating parameters and system architecture on the water management of a multifunctional PEMFC system
    Werner, Claudia
    Busemeyer, Lucas
    Kallo, Josef
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2015, 40 (35) : 11595 - 11603
  • [45] Observation of Damage Initiation for Trans-laminar Fracture Using in situ Fast Synchrotron X-ray Radiography and ex situ X-ray Computed Tomography
    Xu, Xiaodong
    Leung, Nathanael
    Jargalsaikhan, Urangua
    Bongaers, Evi
    Sui, Tan
    APPLIED COMPOSITE MATERIALS, 2024, 31 (03) : 765 - 774
  • [46] Observation of Damage Initiation for Trans-laminar Fracture Using in situ Fast Synchrotron X-ray Radiography and ex situ X-ray Computed Tomography
    Xiaodong Xu
    Nathanael Leung
    Urangua Jargalsaikhan
    Evi Bongaers
    Tan Sui
    Applied Composite Materials, 2024, 31 : 765 - 774
  • [47] In situ and real-time analysis of TGZM phenomena by synchrotron X-ray radiography
    Thi, H. Nguyen
    Reinhart, G.
    Buffet, A.
    Schenk, T.
    Mangelinck-Noel, N.
    Jung, H.
    Bergeon, N.
    Billia, B.
    Hartwig, J.
    Baruchel, J.
    JOURNAL OF CRYSTAL GROWTH, 2008, 310 (11) : 2906 - 2914
  • [48] In situ electrical resistivity and viscosity measurements of iron alloys under pressure using synchrotron X-ray radiography
    Pommier, A.
    Leinenweber, K.
    Pirotte, H.
    Yu, T.
    Wang, Y.
    HIGH PRESSURE RESEARCH, 2021, 41 (01) : 1 - 13
  • [49] Growth and interaction of dendritic equiaxed grains: In situ characterization by synchrotron X-ray radiography
    Bogno, A.
    Nguyen-Thi, H.
    Reinhart, G.
    Billia, B.
    Baruchel, J.
    ACTA MATERIALIA, 2013, 61 (04) : 1303 - 1315
  • [50] Observation of the initiation and propagation of solidification cracks by means of in situ synchrotron X-ray radiography
    Aveson, J. W.
    Reinhart, G.
    Billia, B.
    Nguyen-Thi, H.
    Mangelinck-Noel, N.
    Lafford, T. A.
    Vie, C. A.
    Baruchel, J.
    Stone, H. J.
    MCWASP XIII: INTERNATIONAL CONFERENCE ON MODELING OF CASTING, WELDING AND ADVANCED SOLIDIFICATION PROCESSES, 2012, 33