High local power densities permissible at Siemens pressurized water reactors

被引:2
|
作者
Kuehnel, K [1 ]
Richter, KD [1 ]
Drescher, G [1 ]
Endrizzi, I [1 ]
机构
[1] Siemens Nucl Power GMBH, D-91050 Erlangen, Germany
关键词
core monitoring; departure from nucleate boiling; core transient analysis;
D O I
10.13182/NT02-A3258
中图分类号
TL [原子能技术]; O571 [原子核物理学];
学科分类号
0827 ; 082701 ;
摘要
Operating nuclear fuel to higher discharge burnups reduces not only fuel cycle costs but also the volume of radioactive waste requiring disposal. In pressurized water reactors (PWRs), high local power densities are a prerequisite for achieving a high batch burnup. The range of maximum power densities that can be exploited for in-core fuel management and operational flexibility is restricted by the limiting conditions for operation obtained from analyses of anticipated operational occurrences and hypothetical accidents. Since utilities mainly use available margins for implementing advanced in-core fuel management strategies or for power uprating, a suitable parameter for making a rough comparison of the present thermal-hydraulic design status of different PWRs is the maximum local heat flux achieved during actual cycles under steady-state full-power conditions. A comparison between Siemens PWRs and the PWR designs of other vendors shows that the maximum local power densities during steady-state operation are usually higher in Siemens PWRs. The main reasons why higher power densities are permissible can usually be attributed to different core surveillance concepts (instrumentation and control) in conjunction with different control assembly management schemes. Moreover, two representative studies conducted with a new methodology using the three-dimensional neutronics/thermal-hydraulics coupled code PANBOX for core transient analysis present additional margins. Especially in plants using the Siemens core surveillance concept, the new methodology yields significant additional margins for PWRs to be operated with even higher permissible local power densities. The additional departure from nucleate boiling ratio (DNBR) margin gained in the representative studies was 0.38. However, utilization of this additional margin is accompanied by larger void fractions within the upper section of the hot channel during normal operation. Therefore, increasing steady-state maximum power densities has to be done gradually while collecting and evaluating operating experience each time. Depending on the specific circumstances at a plant, the gained margin can be utilized not only for more economical core loading patterns (improved low-leakage loading and/or elimination of burnable absorbers) or power uprating but also, in Siemens PWRs, to eliminate having to readjust the DNBR limitation circuit for one or more cycles. Although the concept presented here is specifically tailored to Siemens PWRs, it is obvious that the application of a three-dimensional neutronics/thermal-hydralilics coupled code could also provide significant benefits for non-Siemens PWRs as well.
引用
收藏
页码:73 / 83
页数:11
相关论文
共 50 条
  • [11] HIGH CONVERSION RATIO PLUTONIUM RECYCLE IN PRESSURIZED WATER REACTORS
    EDLUND, MC
    ANNALS OF NUCLEAR ENERGY, 1975, 2 (11-1) : 801 - 807
  • [12] Generation III pressurized water reactors and China's nuclear power
    Wang, Yong
    Ma, Ji-en
    Fang, You-tong
    Journal of Zhejiang University-SCIENCE A, 2016, 17 (11): : 911 - 922
  • [13] Design of a fuzzy model predictive power controller for pressurized water reactors
    Na, Man Gyun
    Hwang, In Joon
    Lee, Yoon Joon
    IEEE TRANSACTIONS ON NUCLEAR SCIENCE, 2006, 53 (03) : 1504 - 1514
  • [14] 1300 MW NUCLEAR-POWER STATION UNTERWESER WITH A SIEMENS PRESSURIZED WATER REACTOR
    EMONTS, H
    SCHOMER, E
    ATOMWIRTSCHAFT-ATOMTECHNIK, 1973, 18 (05): : 226 - 231
  • [15] Study on load follow for nuclear power plant with pressurized water reactors
    Wu, Guowei
    Tao, Jin
    Hedongli Gongcheng/Nuclear Power Engineering, 1998, 19 (05): : 394 - 397
  • [16] High-power-density annular fuel for pressurized water reactors: Manufacturing costs and economic benefits
    Lahoda, Edward
    Mazzoccoli, Jason
    Beccherle, Julien
    NUCLEAR TECHNOLOGY, 2007, 160 (01) : 112 - 134
  • [17] RADIOLOGICAL SURVEILLANCE AT PRESSURIZED WATER REACTORS
    BRINCK, W
    KOLDE, H
    KRIEGER, H
    KAHN, B
    TRANSACTIONS OF THE AMERICAN NUCLEAR SOCIETY, 1972, 15 (02): : 640 - +
  • [18] LOAD FOLLOWING IN PRESSURIZED WATER REACTORS
    MCWHIRTE.AD
    BEVILACQ.F
    MECHANICAL ENGINEERING, 1970, 92 (12) : 55 - &
  • [19] CARTRIDGE FILTRATION IN PRESSURIZED WATER REACTORS
    BROOKS, NS
    CHOW, ER
    CHEMICAL ENGINEERING PROGRESS, 1975, 71 (12) : 62 - 69
  • [20] PHYSICS OF OPERATING PRESSURIZED WATER REACTORS
    MCFARLAN.AF
    TRANSACTIONS OF THE AMERICAN NUCLEAR SOCIETY, 1969, 12 (02): : 643 - &