INFLUENCE OF PROCESSING PARAMETERS AND DIFFERENT CONTENT OF TiB2 CERAMICS ON THE PROPERTIES OF COMPOSITES SINTERED BY HIGH PRESSURE - HIGH TEMPERATURE (HP-HT) METHOD

被引：23
|
作者：
Sulima, I. [1 ]
Jaworska, L. [1 ]
Figiel, P. [2 ]
机构：
[1] Pedag Univ, Inst Technol, PL-30084 Krakow, Poland
[2] Inst Adv Mfg Technol, PL-30011 Krakow, Poland
来源：
ARCHIVES OF METALLURGY AND MATERIALS | 2014年 / 59卷 / 01期
关键词：
high pressure-high temperature (HP-HT) sintering; titanium diboride (TiB2); austenitic stainless steel; properties; STAINLESS; MICROSTRUCTURE; BEHAVIOR;
D O I：
10.2478/amm-2014-0033
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
In this paper the properties of the austenitic stainless steel reinforced with various volume fractions of TiB2 ceramics have been studied. The high pressure- high temperature (HP-HT) method of sintering was applied to the formation of composites. Samples were sintered at pressure of 5 and 7 +/- 0.2 GPa and temperatures of 1273 K and 1573 K. For the tested materials, the relative density, Young's modulus and hardness were measured. In order to investigate the structure changes, the scanning electron microscope was used. The obtained results show that the temperature and pressure influence on the mechanical and physical properties of the investigated composites.
引用
收藏
页码：205 / 209
页数：5
相关论文
共 30 条
  • [21] Influence of the TiB2 content on the processability, microstructure and high-temperature tensile performance of a Ni-based superalloy by laser powder bed fusion
    Zhang, Zhenhua
    Han, Quanquan
    Liu, Zhongyi
    Wang, Xiaobo
    Wang, Liqiao
    Yang, Xusheng
    Ma, Teng
    Gao, Zhengjiang
    JOURNAL OF ALLOYS AND COMPOUNDS, 2022, 908
  • [22] Dynamic compression and high-temperature creep properties of Al2O3 and TiB2 in situ particulates reinforced aluminum matrix composites
    Jinshu Xuebao, 1 (93-97):
  • [23] Influence of the TiB2 content on the processability, microstructure and high-temperature tensile performance of a Ni-based superalloy by laser powder bed fusion
    Zhang, Zhenhua
    Han, Quanquan
    Liu, Zhongyi
    Wang, Xiaobo
    Wang, Liqiao
    Yang, Xusheng
    Ma, Teng
    Gao, Zhengjiang
    Journal of Alloys and Compounds, 2022, 908
  • [24] Influence of negative bias voltage and deposition temperature on microstructure and properties of superhard TiB2 coatings deposited by high power impulse magnetron sputtering
    Zhang, Teng Fei
    Gan, Bin
    Park, Seong-mo
    Wang, Qi Min
    Kim, Kwang Ho
    SURFACE & COATINGS TECHNOLOGY, 2014, 253 : 115 - 122
  • [25] Ultra-low shrinkage and high-strength porous TiB/TiB2 ceramics via low temperature in-situ reaction sintering combined with the freeze-drying method
    Zhong, Zhaoxin
    Zhang, Biao
    Zhang, Haoqian
    Wang, Yang
    Ye, Jian
    Ren, Yuhan
    Liu, Qiang
    Ye, Feng
    CERAMICS INTERNATIONAL, 2022, 48 (17) : 24496 - 24504
  • [26] Microstructures and mechanical properties of high-performance nacre-inspired Al-Si/TiB2 composites prepared by freeze casting and pressure infiltration
    Zhang, Wenxin
    Lin, Bo
    Tang, Yue
    Wang, Ying
    Zhang, Dabin
    Zhang, Weiwen
    CERAMICS INTERNATIONAL, 2021, 47 (12) : 16891 - 16901
  • [27] High temperature low cycle fatigue properties of Ti-45Al-2Nb-2Mn+0.8vol.% TiB2 and Ti-47Al-2Nb-2Mn+0.8vol. % TiB2 in situ gamma titanium aluminide composites
    Recina, V
    Nilsson, D
    GAMMA TITANIUM ALUMINIDES 1999, 1999, : 447 - 454
  • [28] Influence of Content of Al2O3 Nanoparticles on the Mechanical and High-temperature Oxidation Properties of Carbon Foam Composites
    Wang B.
    Luo X.
    Wang C.
    Zhou X.
    Hu Y.
    Fang E.
    Wang, Chen (1006171819@qq.com), 1600, Cailiao Daobaoshe/ Materials Review (34): : 18159 - 18164
  • [29] The Influence of Sintering Pressure on the Preparation, Friction Properties, and Magnetic Properties of Ti2AlC-TiC and Ti3AlC2-TiC Composites Under High-Pressure and High-Temperature
    Li, Liang
    Chen, Yuqi
    ADVANCES IN MATERIALS SCIENCE AND ENGINEERING, 2022, 2022
  • [30] Influence of the imidine content on the phase composition and magnetic properties of highly dispersed powders of high-entropy alloys AlCoCrCuxFeNi (x=0,1,2), obtained by the method of ultrasonic processing in a ball mill
    Perekos, Anatoliy Omelyanovych
    METALLOPHYSICS AND ADVANCED TECHNOLOGIES, 2022, 44 (09) : 1213 - 1227
123