Effect of Flow Rate of Heat Transfer Fluid on the Charging Behaviour of Phase Change Material in a Hot Water Tank

被引：0

作者：

Naing, Thet Swe Aye ^{[1
]}

Mon, Mi Sandar ^{[1
]}

Nu, Soe Soe ^{[1
]}

机构：

[1] Yangon Technol Univ, Dept Mech Engn, Yangon, Myanmar

来源：

2016 13TH INTERNATIONAL CONFERENCE ON ELECTRICAL ENGINEERING/ELECTRONICS, COMPUTER, TELECOMMUNICATIONS AND INFORMATION TECHNOLOGY (ECTI-CON) | 2016年

关键词：

charging; thermal energy storage; stearic acid; phase change material; STORAGE MATERIALS; SYSTEM; ACID; PERFORMANCE;

D O I：

暂无

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

This paper presents an experimental investigation of the melting behavior of phase change material (PCM) to use in a solar domestic hot water tank. Commercial grade stearic acid is used as PCM packed in cylindrical copper tube and the hot water surrounding is used as heat transfer fluid (HTF) and sensible heat storage material. A detailed parametric investigation is performed for melting PCM in cylindrical shell of 33 mm in diameter by dividing three different layers along its axial direction. The melting behavior of the PCM in a vertical cylindrical tube with the change of flow rate of HTF is studied. The experimental results show that the melting duration in each layer of PCM is not the same. The melting duration of PCM in top layer is shorter than the bottom layer. It is also observed that the time required for complete melting is longer in lower flow rate of inlet HTF.

引用

页数：5

共 50 条

[31] Experimental study on heat release of phase change ball based on stratified hot water storage tank
Fang G.
Zhang Z.
Lian X.
Tan X.
Taiyangneng Xuebao/Acta Energiae Solaris Sinica, 2022, 43 (07): : 191 - 196
[32] Photovoltaic/thermal integrated air source heat pump hot water system with phase change tank
Wang, Fang
Liu, Mengwei
Guo, Wenliang
Liu, Xianfei
Zhang, Jun
Li, Jicheng
Hu, Guangyu
Yin, Jian
RENEWABLE ENERGY, 2025, 240
[33] Heat and flow analysis of a water droplet on hydrophobic and hydrophilic phase change material
Al-Sharafi, Abdullah
Yilbas, Bekir S.
Ali, H.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2018, 122 : 749 - 764
[34] Analysis of Heat and Mass Transfer During Charging and Discharging in a Metal Hydride - Phase Change Material Reactor
Lewis, Swaraj D.
Chippar, Purushothama
JOURNAL OF ENERGY STORAGE, 2021, 33
[35] Water siingle-phase fluid flow and heat transfer in capillary tubes
Bucci, A
Celata, GP
Cumo, M
Serra, E
Zummo, G
FIRST INTERNATIONAL CONFERENCE ON MICROCHANNELS AND MINICHANNELS, 2003, : 319 - 326
[36] Study the effect of hot fluid flow rate and carbon nanotube–water on the performance of nanofluid in gasketed plate heat exchanger
Omid Ramezani Azqandi
Masoud Mollaee
Saeed Mollaee
Mojtaba Behnam Taghadossi
Sajjad Sabet Birjandi
Journal of Thermal Analysis and Calorimetry, 2023, 148 : 12185 - 12193
[37] Effect of surface structure on fluid flow and heat transfer in cold and hot wall nanochannels
Qin, Shiyi
Chen, Zhanxiu
Wang, Qing
Li, Wenguang
Xing, Hewei
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2024, 151
[38] Flow and heat transfer behaviors of phase change material slurries in a horizontal circular tube
Wang, Xichun
Niu, Jianlei
Li, Yi
Wang, Xin
Chen, Binjiao
Zeng, Ruolang
Song, Qingwen
Zhang, Yinping
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2007, 50 (13-14) : 2480 - 2491
[39] Numerical study of the influence of the convective heat transfer on the dynamical behaviour of a phase change material wall
David, Damien
Kuznik, Frederic
Roux, Jean-Jacques
APPLIED THERMAL ENGINEERING, 2011, 31 (16) : 3117 - 3124
[40] Transient behavior of fluid flow and heat transfer with phase change in vertical porous channels
Li, H. Y.
Leong, K. C.
Jin, L. W.
Chai, J. C.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2010, 53 (23-24) : 5209 - 5222

← 1 2 3 4 5 →