Effect of Flow Rate of Heat Transfer Fluid on the Charging Behaviour of Phase Change Material in a Hot Water Tank

被引：0

作者：

Naing, Thet Swe Aye ^{[1
]}

Mon, Mi Sandar ^{[1
]}

Nu, Soe Soe ^{[1
]}

机构：

[1] Yangon Technol Univ, Dept Mech Engn, Yangon, Myanmar

来源：

2016 13TH INTERNATIONAL CONFERENCE ON ELECTRICAL ENGINEERING/ELECTRONICS, COMPUTER, TELECOMMUNICATIONS AND INFORMATION TECHNOLOGY (ECTI-CON) | 2016年

关键词：

charging; thermal energy storage; stearic acid; phase change material; STORAGE MATERIALS; SYSTEM; ACID; PERFORMANCE;

D O I：

暂无

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

This paper presents an experimental investigation of the melting behavior of phase change material (PCM) to use in a solar domestic hot water tank. Commercial grade stearic acid is used as PCM packed in cylindrical copper tube and the hot water surrounding is used as heat transfer fluid (HTF) and sensible heat storage material. A detailed parametric investigation is performed for melting PCM in cylindrical shell of 33 mm in diameter by dividing three different layers along its axial direction. The melting behavior of the PCM in a vertical cylindrical tube with the change of flow rate of HTF is studied. The experimental results show that the melting duration in each layer of PCM is not the same. The melting duration of PCM in top layer is shorter than the bottom layer. It is also observed that the time required for complete melting is longer in lower flow rate of inlet HTF.

引用

页数：5

共 50 条

[1] Fluid Flow and Heat Transfer Characteristics of Microencapsulated Phase Change Material Slurry in Turbulent Flow
Taherian, Hessam
Alvarado, Jorge L.
Tumuluri, Kalpana
Thies, Curt
Park, Chan-Hyun
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME, 2014, 136 (06):
[2] Impact of using a heat transfer fluid pipe in a metal hydride-phase change material tank
Mellouli, S.
Askri, F.
Abhilash, E.
Ben Nasrallah, S.
APPLIED THERMAL ENGINEERING, 2017, 113 : 554 - 565
[3] Effect of Phase Change Material on The Heat Transfer Rate of Different Building Materials
Hasan, Mushfiq
Alam, Shahnur
Ahmed, Dewan Hasan
PROCEEDINGS OF THE 1ST INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING AND APPLIED SCIENCE (ICMEAS 2017), 2017, 1919
[4] Numerical study of transient behavior and heat transfer in a phase change material affected by heat transfer fluid flow parameters
Ahmadi O.
Majidi S.
Tari P.H.
Journal of Computational and Applied Research in Mechanical Engineering, 2021, 10 (02): : 461 - 472
[5] An optimization study on the performance of hot water tank integrated phase change material
Wu F.
Qi C.
Wang H.
Li A.
Li Z.
Jiao X.
Cheng Y.
Applied Thermal Engineering, 2023, 223
[6] Effect of specific heat of phase change material on heat charging or discharging performance
Li, Zhen
Zhang, Yinping
Jiang, Yi
Taiyangneng Xuebao/Acta Energiae Solaris Sinica, 2002, 23 (01): : 27 - 31
[7] Effect of phase change material on thermal stratification of solar hot water tank with a mantle: A numerical analysis
Izgi, Burak
Arslan, Mevluet
JOURNAL OF ENERGY STORAGE, 2022, 52
[8] Forced convection heat transfer in a slurry of phase change material in an agitated tank
Royon, L
Guiffant, G
Perrot, P
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2000, 27 (08) : 1057 - 1065
[9] Heat Transfer Characteristics of a Phase Change Material Fluid in Microchannels under Pulsating Flow Condition
Shuvo, Abdul Aziz
Morshed, A. K. M. M.
Emon, Shariful Alam
Tikadar, Amitav
Paul, Titan C.
PROCEEDINGS OF THE ASME SUMMER HEAT TRANSFER CONFERENCE, 2019, 2019,
[10] LAMINAR FLOW FORCED CONVECTION HEAT TRANSFER BEHAVIOR OF A PHASE CHANGE MATERIAL FLUID IN MICROCHANNELS
Kondle, Satyanarayana
Alvarado, Jorge L.
Marsh, Charles
Kessler, Dave
Stynoski, Peter
IMECE 2009: PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, VOL 9, PTS A-C, 2010, : 1305 - 1314

← 1 2 3 4 5 →