Fatigue of cord-rubber composites: II. Strain-based failure criteria

被引:13
|
作者
Lee, BL [1 ]
Ku, BH [1 ]
Liu, DS [1 ]
Hippo, PK [1 ]
机构
[1] Penn State Univ, Dept Engn Sci & Mech, University Pk, PA 16802 USA
来源
RUBBER CHEMISTRY AND TECHNOLOGY | 1998年 / 71卷 / 05期
关键词
D O I
10.5254/1.3538515
中图分类号
O63 [高分子化学(高聚物)];
学科分类号
070305 ; 080501 ; 081704 ;
摘要
Fatigue failure mechanisms under low-frequency loading and their dependence on the strain properties were assessed for the rubber matrix composite of bias aircraft tire carcass reinforced by nylon cords as weill as two model rubber composites reinforced by steel wire cables. Under cyclic tension at constant stress amplitude, these angle-plied, cord-rubber composite laminates exhibited localized damage in the form of cord-matrix debonding, matrix cracking, and delamination. The process of fatigue damage accumulation in the cord-rubber composite laminate was accompanied by a steady increase of cyclic strain (dynamic creep) and moderate temperature changes. The fatigue life was found to be linearly proportional to the inverse of the dynamic creep rate, i.c., the time required to increase cyclic strain by a unit amount. Regardless of the associated level of stress amplitude or fatigue life, the gross failure under low-frequency loading occurred when the total strain accumulation, i.c., cumulative creep strain, reached the static failure strain. The use of higher stress amplitude resulted in a decrease of fatigue life by simply shortening the time to reach the critical level of strain for gross failure. This observation indicates that the damage initiation and eventual structural failure of angle-plied, cord-rubber composite laminates are "strain-controlled" processes. These critical strain properties appear to be controlled by the process of interfacial failure between the cord and matrix. Under static tension, the strain levels for cord matrix debonding and gross failure of composite laminates showed no significant dependence on the level of carbon black loading of the matrix compound, despite the fact that carbon black loading strongly affected the modulus, strength and strain properties of the matrix, Also the number of debonding sites around the cut ends of cords increased at almost the same rate as the static strain increased regardless of the variation of matrix properties.
引用
收藏
页码:866 / 888
页数:23
相关论文
共 50 条
  • [41] Fatigue life prediction of cord-rubber composite structures based on progressive damage analysis
    Jha, Niraj Kumar
    Nackenhorst, Udo
    ENGINEERING COMPUTATIONS, 2018, 35 (06) : 2215 - 2233
  • [42] Three-dimensional micromechanical modeling of cord-rubber composites
    Kocak, S
    Pidaparti, RMV
    MECHANICS OF COMPOSITE MATERIALS AND STRUCTURES, 2000, 7 (01): : 19 - 34
  • [43] Effect of Interface in Three-phase Cord-Rubber Composites
    Kim, Jong-Kuk
    Yum, Young-Jin
    TRANSACTIONS OF THE KOREAN SOCIETY OF MECHANICAL ENGINEERS A, 2009, 33 (11) : 1249 - 1255
  • [44] Modelling of cord-rubber composites of bellow air-springs
    von Eitzen, A.
    Weltin, U.
    Brueger, T.
    Steinweger, T.
    Flamm, M.
    CONSTITUTIVE MODELS FOR RUBBER VIII, 2013, : 631 - 636
  • [45] Study on constitutive model and failure criterion of cord-rubber composite
    Zhang, FF
    Fan, ZH
    Du, XW
    Kuang, ZB
    JOURNAL OF ELASTOMERS AND PLASTICS, 2004, 36 (04): : 351 - 362
  • [46] VISUALIZATION OF TEXTILE REINFORCING MATERIALS IN CORD-RUBBER COMPOSITES AFTER DISSOLUTION OF THE RUBBER WITH PERACIDS
    VANBLOKLAND, PHGM
    RUBBER CHEMISTRY AND TECHNOLOGY, 1986, 59 (04): : 574 - 579
  • [47] Mechanical properties of cord-rubber composites and tire finite element analysis
    Tan, HF
    Du, XW
    Wei, YT
    Yum, YJ
    VEHICLE SYSTEM DYNAMICS, 2003, 40 : 161 - 174
  • [48] An investigation of intelligent tires using multiscale modeling of cord-rubber composites
    Behroozinia, Pooya
    Taheri, Saied
    Mirzaeifar, Reza
    MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES, 2018, 46 (02) : 168 - 183
  • [49] Strain-based failure criteria for rocks: State of the art and recent advances
    Kwasniewski, M.
    Takahashi, M.
    ROCK MECHANICS IN CIVIL AND ENVIRONMENTAL ENGINEERING, 2010, : 45 - +
  • [50] An anisotropic hyperelastic constitutive model with shear interaction for cord-rubber composites
    Peng, Xiongqi
    Guo, Guodong
    Zhao, Ning
    COMPOSITES SCIENCE AND TECHNOLOGY, 2013, 78 : 69 - 74