DendroCT - Dendrochronology without damage

The paper describes an evaluation of the applicability of computer tomography in archaeological dendrochronology. Two different computer tomographs were tested, a Siemens Somatom Emotion single slice scanner developed for medical use, and a Nikon Metrology model XT H 225 LC, which is an industrial type scanner. Both scanners were tested against air-dried, archaeological oak wood, and more limited experiments were made with waterlogged archaeological oak wood and archaeological oak wood which had been treated with high-molecular polyethyleneglycol as a conservation treatment. After scanning the resulting imagery were measured and analysed for dendrochronology using off-the-shelf software for handling and measuring on the images and the specialist programme DENDRO for the dendrochronological analyses. The results showed that only the industrial scanner produced sufficiently clear imagery to allow for dendrochronological analyses. In the scans it was possible to separate tree-rings down to 0.2 mm width, and it was possible to identify the sapwood-heartwood border when sufficient sapwood rings were present. It was found, however, that a visual inspection of the object was required to distinguish between sapwood and decayed wood. Comparisons between direct measurements of tree-rings and measurements based on CT-imagery revealed no significant differences. The scanning and subsequent dating of more than 90 objects showed that dendrochronological dating based on CT-scanning has a success rate equal to conventional dating, albeit more time consuming. The attempts to scan waterlogged and PEG-impregnated archaeological oak wood were unsuccessful, due to a low degree of contrast between the water/PEG and the preserved wood. The experiments were too limited to exclude, however, that a successful protocol can be developed also for these types of materials. (C) 2012 Istituto Italian di Dendrocronologia. Published by Elsevier GmbH. All rights reserved.