Characterisation and optimisation of PECVD SiNx as an antireflection coating and passivation layer for silicon solar cells

被引:106
|
作者
Wan, Yimao [1 ]
McIntosh, Keith R. [2 ]
Thomson, Andrew F. [1 ]
机构
[1] Australian Natl Univ, Res Sch Engn, Canberra, ACT 0200, Australia
[2] PV Lighthouse, Coledale, NSW 2515, Australia
基金
澳大利亚研究理事会;
关键词
CHEMICAL-VAPOR-DEPOSITION; QUALITY SURFACE PASSIVATION; P-TYPE; PLASMA DEPOSITION; BULK PASSIVATION; NITRIDE; RECOMBINATION; FILMS; INTERFACE; INJECTION;
D O I
10.1063/1.4795108
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
In this work, we investigate how the film properties of silicon nitride (SiNx) depend on its deposition conditions when formed by plasma enhanced chemical vapour deposition (PECVD). The examination is conducted with a Roth & Rau AK400 PECVD reactor, where the varied parameters are deposition temperature, pressure, gas flow ratio, total gas flow, microwave plasma power and radio-frequency bias voltage. The films are evaluated by Fourier transform infrared spectroscopy to determine structural properties, by spectrophotometry to determine optical properties, and by capacitance-voltage and photoconductance measurements to determine electronic properties. After reporting on the dependence of SiNx properties on deposition parameters, we determine the optimized deposition conditions that attain low absorption and low recombination. On the basis of SiNx growth models proposed in the literature and of our experimental results, we discuss how each process parameter affects the deposition rate and chemical bond density. We then focus on the effective surface recombination velocity S-eff, which is of primary importance to solar cells. We find that for the SiNx prepared in this work, 1) Seff does not correlate universally with the bulk structural and optical properties such as chemical bond densities and refractive index, and 2) Seff depends primarily on the defect density at the SiNx-Si interface rather than the insulator charge. Finally, employing the optimized deposition condition, we achieve a relatively constant and low Seff, UL on low-resistivity (<= 1.1 Omega cm) p-and n-type c-Si substrates over a broad range of n = 1.85-4.07. The results of this study demonstrate that the trade-off between optical transmission and surface passivation can be circumvented. Although we focus on photovoltaic applications, this study may be useful for any device for which it is desirable to maximize light transmission and surface passivation. Copyright 2013 Author(s). This article is distributed under a Creative Commons Attribution 3.0 Unported License. [http://dx.doi.org/10.1063/1.4795108]
引用
收藏
页数:14
相关论文
共 50 条
  • [1] Nanopatterned SiNx Broadband Antireflection Coating for Planar Silicon Solar Cells
    Cordaro, Andrea
    Tabernig, Stefan Wil
    Pollard, Michael
    Yi, Chuqi
    Alarcon-Llado, Esther
    Hoex, Bram
    Polman, Albert
    [J]. PHYSICA STATUS SOLIDI A-APPLICATIONS AND MATERIALS SCIENCE, 2023, 220 (05):
  • [2] Optical properties of PECVD and UVCVD SiNx:H antireflection coatings for silicon solar cells
    Lelièvre, JF
    Kaminski, A
    Boyeauk, JP
    Monna, R
    Lemiti, M
    [J]. Conference Record of the Thirty-First IEEE Photovoltaic Specialists Conference - 2005, 2005, : 1111 - 1114
  • [3] Double-layer antireflection coating of MgF2/SiNx for crystalline silicon solar cells
    Dhungel, Suresh Kumar
    Yoo, Jinsu
    Kim, Kyunghae
    Jung, Sungwook
    Ghosh, Somnath
    Yi, Junsin
    [J]. JOURNAL OF THE KOREAN PHYSICAL SOCIETY, 2006, 49 (03) : 885 - 889
  • [4] Stability of SiNX/SiNX double stack antireflection coating for single crystalline silicon solar cells
    Lee, Youngseok
    Gong, Daeyeong
    Balaji, Nagarajan
    Lee, Youn-Jung
    Yi, Junsin
    [J]. NANOSCALE RESEARCH LETTERS, 2012, 7 : 1 - 6
  • [5] Porous silicon layer as antireflection coating in solar cells
    Panek, P
    Lipinski, M
    Czternastek, H
    [J]. OPTO-ELECTRONICS REVIEW, 2000, 8 (01) : 57 - 59
  • [6] Stability of SiNX/SiNX double stack antireflection coating for single crystalline silicon solar cells
    Youngseok Lee
    Daeyeong Gong
    Nagarajan Balaji
    Youn-Jung Lee
    Junsin Yi
    [J]. Nanoscale Research Letters, 7
  • [7] Microwave PECVD system for SiNx:H antireflection coatings and hydrogen passivation on multicrystalline silicon
    Fourmond, E
    Lemiti, M
    Trassy, C
    Laugier, A
    [J]. HIGH TEMPERATURE MATERIAL PROCESSES, 2003, 7 (02): : 231 - 240
  • [8] FRONT SURFACE PASSIVATION OF SILICON SOLAR-CELLS WITH ANTIREFLECTION COATING
    CROTTY, G
    DAUD, T
    KACHARE, R
    [J]. JOURNAL OF APPLIED PHYSICS, 1987, 61 (08) : 3077 - 3079
  • [9] Optimisation of SiNx:H layer for multicrystalline silicon solar cells
    Lipinski, M
    Zieba, P
    Jonas, S
    Kluska, S
    Sokolowski, M
    Czternastek, H
    [J]. OPTO-ELECTRONICS REVIEW, 2004, 12 (01) : 41 - 44
  • [10] Optimisation of antireflection coating properties of porous silicon for multicrystalline silicon solar cells
    Strehlke, S
    Sarti, D
    Polgar, O
    Fried, M
    LevyClement, C
    [J]. PROCEEDINGS OF THE SYMPOSIUM ON PHOTOELECTROCHEMISTRY, 1997, 97 (20): : 278 - 288