Development of a new fracture test to identify the critical energy release rate: The Tensile Flexure test on Notched Specimen

被引：5

作者：

Vandellos, Thomas ^{[1
]}

Hautier, Mathieu ^{[1
]}

Carrere, Nicolas ^{[1
]}

Huchette, Cedric ^{[1
]}

机构：

[1] Off Natl Etud & Rech Aerosp, F-92322 Chatillon, France

来源：

ENGINEERING FRACTURE MECHANICS | 2012年 / 96卷

关键词：

Delamination; Fiber reinforced materials; Toughness testing; Fracture mechanics; I+II INTERLAMINAR FRACTURE; MODE-II; DELAMINATION FRACTURE; COMPOSITES; TOUGHNESS; BEAM;

D O I：

10.1016/j.engfracmech.2012.09.026

中图分类号：

O3 [力学];

学科分类号：

08 ; 0801 ;

摘要：

Delamination is one of the most critical damage mechanisms in laminated composites. A fracture test, referenced in the following as Tensile Flexure test on Notched Specimen, is proposed in this work to characterize the propagation of delamination. After the description of the experimental procedure, experimental results on carbon/epoxy specimens are presented to describe the capabilities and advantages of the test to characterize delamination. Then, a new propagation law is proposed to describe the evolution of the fracture toughness. Finally, a non-deterministic analysis is performed to determine the influence of the measured parameters on the toughness identification. (C) 2012 Elsevier Ltd. All rights reserved.

引用

页码：641 / 655

页数：15

共 50 条

[21] The over-notched flexure test method for determining the fracture toughness and bridging law of laminates
Wang, Ziming
Gong, Yu
Chen, Junwei
Yan, Lewei
Ding, Zhaohu
Zhang, Yongxiang
Hu, Ning
ENGINEERING FRACTURE MECHANICS, 2024, 301
[22] Energy Release Rate Formulations for Non-conventional Fracture Test Geometries
Chaudhari, Tejas S.
Mathews, Nidhin G.
Mishra, Ashwini K.
Sahasrabuddhe, Hrushikesh P.
Jaya, B. Nagamani
JOM, 2021, 73 (06) : 1597 - 1606
[23] Energy Release Rate Formulations for Non-conventional Fracture Test Geometries
Tejas S. Chaudhari
Nidhin G. Mathews
Ashwini K. Mishra
Hrushikesh P. Sahasrabuddhe
B. Nagamani Jaya
JOM, 2021, 73 : 1597 - 1606
[24] FRACTURES AND ENERGY OF FRACTURE OF TENSILE AND IMPACT TEST SAMPLES
KNIZHNIK, GS
METAL SCIENCE AND HEAT TREATMENT, 1975, 17 (1-2) : 174 - 178
[25] A New Flattened Cylinder Specimen for Direct Tensile Test of Rock
Rao, Qiuhua
Liu, Zelin
Ma, Chunde
Yi, Wei
Xie, Weibin
SENSORS, 2021, 21 (12)
[26] Development of Stress Intensity Factor Equation for the Notched Ring Test (NRT) Specimen
Pyo, Sooho
Choi, Sunwoong
KOREAN JOURNAL OF MATERIALS RESEARCH, 2014, 24 (02): : 87 - 92
[27] On the instantaneous energy release rate of the end-notch flexure adhesive joint specimen
Alfredsson, KS
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 2004, 41 (16-17) : 4787 - 4807
[28] Critical energy release rate for interface delamination of asymmetrical specimen
Ma, Mingze
Yao, Weixing
Li, Piao
COMPOSITE STRUCTURES, 2020, 237
[29] A test for the rate effect on concrete fracture energy
Rericha, P
STRUCTURES UNDER SHOCK AND IMPACT V, 1998, 2 : 461 - 470
[30] Mode II fracture toughness evaluation using four point bend, end notched flexure test
Martin, RH
Davidson, BD
PLASTICS RUBBER AND COMPOSITES, 1999, 28 (08) : 401 - 406

← 1 2 3 4 5 →