Trailing-edge jet control of leading-edge vortices of a delta wing

被引:31
|
作者
Shih, C [1 ]
Ding, Z [1 ]
机构
[1] FLORIDA STATE UNIV,TALLAHASSEE,FL 32316
关键词
D O I
10.2514/3.13252
中图分类号
V [航空、航天];
学科分类号
08 ; 0825 ;
摘要
The effect of using a trailing-edge Set to control the leading-edge vortices of a delta wing is investigated experimentally in a water towing tank facility, The Reynolds number, based on the freestream velocity and the root chord, is 9.8 x 10(3), Both static and dynamic (pitching-up) conditions are tested, For the dynamic cases, the wing is pitched from 10- to 45-deg angle of attack with pitch rates varied from 0.043 to 0.26. From the dye flow visualization, it is shown that a downward vectored trailing-edge jet can significantly delay the vortex breakdown on a delta wing, Strong asymmetric breakdown of the leading-edge vortices can be induced by arranging the vectored jet in an asymmetric configuration, Transient pitching motion delays the onset of the vortex breakdown, The initial delay is independent of the pitch rate, Also, the use of jet control is found to be effective for the dynamic cases, During the initial pitching-up period, the use of jet control has a dominant influence on the propagation of the vortex breakdown, In general, with jet control, the propagation of the vortex breakdown slows down, From instantaneous particle image velocimetry measurements, a quasiperiodic variation of the leading-edge vorticity field is detected before the vortex breakdown, This variation appears to relate to the strong interaction between the separating shear layer, the secondary vortex, and the primary vortex, Along the vortex axis, the velocity distribution changes from a jet-type profile to a wake-type profile, signifying the onset of vortex breakdown.
引用
收藏
页码:1447 / 1457
页数:11
相关论文
共 50 条
  • [41] Aeroacoustic interaction between owl-inspired trailing-edge fringes and leading-edge serrations
    Rong, Jiaxin
    Liu, Hao
    PHYSICS OF FLUIDS, 2022, 34 (01)
  • [42] Characteristics of Laminar Separation Bubble With Varying Leading-Edge Shapes and Deflections of the Trailing-Edge Flap
    Sarvankar, Sumit S.
    Sarkar, Drik
    Arasu, Adrin Issai
    Mistry, Chetankumar Sureshbhai
    Vadlamani, Nagabhushana Rao
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2024, 146 (10):
  • [43] CHARACTERISTICS OF LAMINAR SEPARATION BUBBLE WITH VARYING LEADING-EDGE SHAPES AND DEFLECTIONS OF THE TRAILING-EDGE FLAP
    Sarvankar, Sumit S.
    Sarkar, Drik
    Mistry, Chetankumar Sureshbhai
    Vadlamani, Nagabhushana Rao
    PROCEEDINGS OF ASME 2023 GAS TURBINE INDIA CONFERENCE, GTINDIA2023, 2023,
  • [44] Aerodynamic performance of GAW-1 airfoil leading-edge and trailing-edge variable camber
    Lu W.
    Tian Y.
    Liu P.
    Wang T.
    Zhang L.
    Hangkong Xuebao/Acta Aeronautica et Astronautica Sinica, 2016, 37 (02): : 437 - 450
  • [45] SPANWISE CAMBERED DELTA WING WITH LEADING-EDGE SEPARATION
    FERNANDEZ, J
    HOLLA, VS
    JOURNAL OF AIRCRAFT, 1977, 14 (03): : 276 - 282
  • [46] INVESTIGATION OF DELTA-WING LEADING-EDGE DEVICES
    RAO, DM
    JOHNSON, TD
    JOURNAL OF AIRCRAFT, 1981, 18 (03): : 161 - 167
  • [47] SYNTHESIS OF THE THICKNESS EFFECT IN THE CASE OF FLOW PAST A SLENDER DELTA WING WITH LEADING-EDGE VORTICES
    RAY, AK
    SHARMA, S
    ACTA MECHANICA, 1979, 33 (1-2) : 69 - 80
  • [48] NAVIER STOKES COMPUTATION OF TRANSONIC VORTICES OVER A ROUND LEADING-EDGE DELTA-WING
    MULLER, B
    RIZZI, A
    INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS, 1989, 9 (08) : 943 - 962
  • [49] Quantitative Visualization of the Leading-edge Vortices on a Delta Wing by Using Pressure-sensitive Paint
    Egami, Y.
    Iijima, Y.
    Amao, Y.
    Asai, K.
    Fuji, A.
    Teduka, N.
    Kameda, M.
    JOURNAL OF VISUALIZATION, 2001, 4 (02) : 139 - 150
  • [50] NUMERICAL MODELING OF THE EFFECTS OF LEADING-EDGE EROSION AND TRAILING-EDGE DAMAGE ON WIND TURBINE LOADS AND PERFORMANCE
    Papi, Francesco
    Cappugi, Lorenzo
    Bianchini, Alessandro
    Perez-Becker, Sebastian
    PROCEEDINGS OF THE ASME TURBO EXPO: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, VOL 12, 2020,