Wettability and droplet energetics on micro-scale wavy and V-grooved surfaces

被引:4
|
作者
Khan, Ikram [1 ]
Rahman, Ashiqur [1 ]
机构
[1] Bangladesh Univ Engn & Technol, Dept Mech Engn, Dhaka 1000, Bangladesh
关键词
Anisotropic wetting; Wetting transition; Droplet stability; Surface evolver; Surface roughness; Micro V-Grooved surface; Micro-wavy surface; CONTACT-ANGLE HYSTERESIS; ANISOTROPIC WETTING PROPERTIES; SLIDING BEHAVIOR; WATER; SHAPE; TEMPERATURE; FABRICATION; TRANSITION; DRAINAGE; IMPACT;
D O I
10.1016/j.rineng.2022.100791
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The wetting physics and wetting transition on micro-wavy and micro V-grooved surfaces of similar topographic scales are investigated and compared with an emphasis on the droplet stability and anisotropic wetting that promotes liquid drainage. To develop 3D models of liquid droplets and to assess the morphology and spreading of liquid droplets across a wide range of parametric space, Surface Evolver (SE) has been used. The effect of roughness parameters of micro V-grooved surfaces such as groove height, groove width, pillar width, and groove angle on the wetting behavior is analyzed and compared to the same for the corresponding dimensional variation of pitch, amplitude, and depth of the asperities of micro-wavy surfaces. For all the comparable configurations, surfaces with micro-wavy textures exhibit higher wettability and smaller stable droplets than micro V-grooved surfaces. In addition, after specific threshold values of the aforementioned topographic parameters, the Cassie -Wenzel wetting transition is observed. Although wettability on micro-scale wavy and V-grooved surfaces have been widely examined because of their obvious importance, comparison of wetting physics and droplet ener-getics on them for similar roughness scale has not been conducted before. Therefore, the developed model may be useful in designing micro-structured V-grooved and wavy surfaces with tunable directional wetting properties.
引用
收藏
页数:13
相关论文
共 50 条
  • [41] Study on micro-scale 3D numerical modeling and droplet deposition of plain weave fabric
    Xiao, Yuan
    Zhang, Chengkun
    Li, Qian
    Yang, Pengcheng
    He, Dan
    [J]. JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2022, 36 (04) : 1739 - 1748
  • [42] Forced convection and pressure drop in a horizontal triangular-sectional duct with V-grooved (i.e. orthogonal to the mean flow) inner surfaces
    Leung, CW
    Chen, S
    Wong, TT
    Probert, SD
    [J]. APPLIED ENERGY, 2000, 66 (03) : 199 - 211
  • [43] A new CHF model for enhanced pool boiling heat transfer on surfaces with micro-scale roughness
    Li, Ran
    Huang, Zhongwei
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2017, 109 : 1084 - 1093
  • [44] Identification of micro-scale calorimetric devicesPart V. Basic properties for gas–solid reactions
    C. Auguet
    J. L. Seguin
    F. Martorell
    F. Moll
    V. Torra
    J. Lerchner
    [J]. Journal of Thermal Analysis and Calorimetry, 2006, 86 : 521 - 529
  • [45] Suppression of frost layer growth on glass or copper surfaces with micro-scale lattice-patterned grooves
    Yonezawa, Sho
    Agui, Haruka
    Ohkubo, Hidetoshi
    Hagiwara, Yoshimichi
    [J]. INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2019, 106 : 33 - 40
  • [46] Stretchable micro-scale concentrator photovoltaic module with 15.4% efficiency for three-dimensional curved surfaces
    Sato, Daisuke
    Masuda, Taizo
    Araki, Kenji
    Yamaguchi, Masafumi
    Okumura, Kenichi
    Sato, Akinori
    Tomizawa, Ryota
    Yamada, Noboru
    [J]. COMMUNICATIONS MATERIALS, 2021, 2 (01)
  • [47] Stretchable micro-scale concentrator photovoltaic module with 15.4% efficiency for three-dimensional curved surfaces
    Daisuke Sato
    Taizo Masuda
    Kenji Araki
    Masafumi Yamaguchi
    Kenichi Okumura
    Akinori Sato
    Ryota Tomizawa
    Noboru Yamada
    [J]. Communications Materials, 2
  • [48] Effect of Sintering Temperature on the Porosity and Microhardness of the Micro-scale 3-D Porous Gradient Surfaces
    Ozturk, B.
    Cora, O. N.
    Koc, M.
    [J]. PROCEEDINGS OF THE 8TH INTERNATIONAL CONFERENCE ON MULTI-MATERIAL MICRO MANUFACTURE (4M 2011), 2011, : 176 - 179
  • [49] Cyclic softening behavior of Ti-6Al-4V alloy at macro and micro-scale
    Han, Fengbo
    Tang, Bin
    Kou, Hongchao
    Li, Jinshan
    Deng, Ying
    Feng, Yong
    [J]. MATERIALS LETTERS, 2016, 185 : 115 - 118
  • [50] Binding force measurement between micro-scale flat surfaces in aqueous environment by force-sensing piezoresistive micro-cantilevers
    Onoe, H
    Gel, M
    Hoshino, K
    Matsumoto, K
    Shimoyama, I
    [J]. MEMS 2005 Miami: Technical Digest, 2005, : 16 - 19