Dynamic gear loads due to coupled lateral, torsional and axial vibrations in a helical geared system

In this paper we investigate the rotordynamics of a geared system with coupled lateral, torsional and axial vibrations, with a view reward understanding the severe vibration problems that occurred on a 28-MW turboset consisting of steam turbine, double helical gear and generator. The new dynamic model of the shaft line was based oil the most accurate simulation of the static shaft lines, which are influenced by variable steam forces and load-dependent gear forces. The gear forces determine the static shaft position in the bearing shell. Each speed and load condition results in a new static bending line which defines the boundary condition for the dynamic vibration calculation of the coupled lateral, torsional and axial systems. Rigid disks and distributed springs were used for shaft line modeling. The tooth contact was modeled by distributed springs acting normally on the flank surfaces of both helices. A finite element method with distributed mass was used for lateral and torsional vibrations. It was coupled to a lumped mass model describing the axial vibrations. The forced vibrations due to unbalances and static transmission errors were calculated. The eigenvalue problem was solved by means of a stability analysis showing the special behavior of the coupled system examined. The calculation was successfully applied, and the source of the vibration problem could be located as being a gear-related transmission error. Several redesign proposals lend to a reliable and satisfactory vibrational behavior of the turboset.