High-temperature behavior of SiO2 at grain boundaries in TZP

被引:19
|
作者
Ikuhara, Y [1 ]
Nagai, Y [1 ]
Yamamoto, T [1 ]
Sakuma, T [1 ]
机构
[1] Univ Tokyo, Dept Mat Sci, Bunkyo Ku, Tokyo 1138656, Japan
关键词
tetragonal zirconia polycrystal (TZP); silica glass; segregation; TEM in-situ observation; grain boundary; electron energy-loss spectroscopy (EELS); molecular orbital calculation (MO);
D O I
10.1023/A:1008777500697
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The chemical reaction between SiO2 and tetragonal zirconia polycrystal (TZP) was directly observed using a TEM in-situ heating technique in order to understand the behavior of SiO2 in TZP at high temperatures. Their dynamic interaction was recorded up to about 1400 degrees C using a CCD camera-video system connected to the TEM. Most of SiO2 phase dissolved into the ZrO2 grains above 1300 degrees C. On the other hand, during cooling from the high temperature to around 400 degrees C, amorphous SiO2 reprecipitated from the surface of ZrO2 grains and formed a thin layer around the ZrO2 grains. This result agrees well with the fact that silicon segregates in the vicinity of grain boundaries in SiO2-doped TZP. In order to confirm the grain boundary segregation at high temperatures, we investigated grain boundaries in quenched specimens by high resolution electron microscopy (HREM), energy dispersive X-ray spectroscopy (EDS) and electron energy-loss spectroscopy (EELS). It was found that no amorphous phase was present between two adjacent grains in the quenched samples. EDS analysis revealed that silicon segregated at the grain boundaries and that the segregation layer was wider than that in as-sintered specimens. The electron energy loss near edge structure (ELNES) of O K-edge was measured from both grain boundary and grain interior in quenched specimen, and their spectra were interpreted by a first principles molecular-orbital (MO) calculation using the discrete-variational (DV)-X alpha method.
引用
收藏
页码:77 / 84
页数:8
相关论文
共 50 条
  • [21] High-temperature plastic behavior of TZP-Ni cermets
    Morales-Rodriguez, Ana
    Bravo-Leon, Alfonso
    Dominguez-Rodriguez, Arturo
    Jimenez-Melendo, Manuel
    JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2008, 91 (02) : 500 - 507
  • [22] High-temperature tensile ductility in TZP and TiO2-doped TZP
    Kondo, T.
    Takigawa, Y.
    Sakuma, T.
    Materials Science and Engineering A, 1997, A231 (1-2): : 163 - 169
  • [23] HIGH-TEMPERATURE DEFORMATION AND FRACTURE-BEHAVIOR OF CU-SIO2 BICRYSTALS WITH [011] TWIST BOUNDARIES
    MIURA, H
    SAIJO, K
    SAKAI, T
    JOURNAL OF THE JAPAN INSTITUTE OF METALS, 1995, 59 (09) : 889 - 893
  • [24] High-temperature tensile ductility in TZP and TiO2-doped TZP
    Kondo, T
    Takigawa, Y
    Sakuma, T
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1997, 231 (1-2): : 163 - 169
  • [25] HIGH-TEMPERATURE REACTION AND DEFECT CHEMISTRY AT THE SI/SIO2 INTERFACE
    HOFMANN, K
    RUBLOFF, GW
    LIEHR, M
    YOUNG, DR
    APPLIED SURFACE SCIENCE, 1987, 30 (1-4) : 25 - 31
  • [26] HIGH-TEMPERATURE DEPOSITION OF SIO2 ON HOT WIRES BY DECOMPOSITION OF TETRAETHOXYSILANE
    TILLER, HJ
    WIENKE, J
    MEYER, J
    JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 1994, 141 (02) : 514 - 518
  • [27] THEORY OF HIGH-TEMPERATURE OXIDE DECOMPOSITION AT THE SIO2/SI INTERFACE
    BRADLEY, RM
    JOURNAL OF APPLIED PHYSICS, 1987, 61 (02) : 545 - 548
  • [28] High-temperature stability of SiO2 oxide film on surface of SiC
    Yamaguchi S.
    Yusufu A.
    Shirahama T.
    Murakami Y.
    Onitsuka T.
    Uno M.
    Transactions of the Atomic Energy Society of Japan, 2019, 18 (04) : 219 - 225
  • [29] Effect of Zr doping on the high-temperature stability of SiO2 glass
    Cheng, Chunyu
    Li, Hejun
    Fu, Qiangang
    Guo, Liping
    Sun, Jia
    Yin, Xuemin
    COMPUTATIONAL MATERIALS SCIENCE, 2018, 147 : 81 - 86
  • [30] Investigation on high-temperature dielectric properties of SiO2 composite materials
    Zhang Liang
    Jin Haibo
    Cao Maosheng
    RARE METAL MATERIALS AND ENGINEERING, 2007, 36 : 515 - 518