Reliability of Bluetooth Technology for Travel Time Estimation

被引:22
|
作者
Araghi, Bahar Namaki [1 ]
Olesen, Jonas Hammershoj [2 ]
Krishnan, Rajesh [3 ]
Christensen, Lars Torholm [4 ]
Lahrmann, Harry [1 ]
机构
[1] Aalborg Univ, Dept Planning & Dev, Traff Res Grp, DK-9000 Aalborg, Denmark
[2] COWI, Aalborg, Denmark
[3] Univ London Imperial Coll Sci Technol & Med, Ctr Transport Studies, London, England
[4] BLIP Syst AS, Vodskov, Denmark
关键词
Bluetooth Technology; Detection Zone; Discovery Procedure; Travel Time Estimation;
D O I
10.1080/15472450.2013.856727
中图分类号
U [交通运输];
学科分类号
08 ; 0823 ;
摘要
A unique Bluetooth-enabled device may be detected several times or not at all when it passes a sensor location. This depends mainly on the strength and speed of a transmitting device, discovery procedure, location of the device relative to the Bluetooth sensor, the Bluetooth sensor's ping cycle (0.1s), the size and shape of the sensor's detection zone, and the time span for which the Bluetooth-enabled device is within the detection zone. The influences of size of Bluetooth sensor detection zones and Bluetooth discovery procedure on multiple detection events have been mentioned in previous research. However, their corresponding impacts on accuracy and reliability of estimated travel time have not been evaluated. In this study, a controlled field experiment is conducted to collect both Bluetooth and global positioning system (GPS) data for 1000 trips to be used as the basis for evaluation. Data obtained by GPS logger are used to calculate actual travel time, referred to as ground truth, and to geo-code the Bluetooth detection events. In this setting, reliability is defined as the percentage of devices captured per trip during the experiment. It is found that, on average, Bluetooth-enabled devices will be detected 80% of the time while passing a sensor location. The impact of location ambiguity caused by the size of the detection zone is evaluated using geo-coded Bluetooth data. Results show that more than 80% of the detection events are recorded within the range of 100m from the sensor center line. It is also shown that short-range antennas detect Bluetooth-enabled devices in a location closer to the sensor, thus providing a more accurate travel time estimate. However, the smaller the size of the detection zone, the lower is the penetration rate, which could itself influence the accuracy of estimates. Therefore, there has to be a trade-off between acceptable level of location ambiguity and penetration rate for configuration and coverage of the antennas.
引用
收藏
页码:240 / 255
页数:16
相关论文
共 50 条
  • [31] Reliability of Bluetooth Smart Technology for Indoor Localization System
    Kwiecien, Andrzej
    Mackowski, Michal
    Kojder, Marek
    Manczyk, Maciej
    [J]. COMPUTER NETWORKS, CN 2015, 2015, 522 : 444 - 454
  • [32] The Reliability of Travel Time Forecasting
    Yang, Menglong
    Liu, Yiguang
    You, Zhisheng
    [J]. IEEE TRANSACTIONS ON INTELLIGENT TRANSPORTATION SYSTEMS, 2010, 11 (01) : 162 - 171
  • [33] Road Network Running State Reliability Estimation Based on Travel Time Interval
    Xu, Bicheng
    Wu, Juyuan
    Fei, Kai
    [J]. CICTP 2023: INNOVATION-EMPOWERED TECHNOLOGY FOR SUSTAINABLE, INTELLIGENT, DECARBONIZED, AND CONNECTED TRANSPORTATION, 2023, : 2643 - 2652
  • [34] Estimation of travel time reliability using stochastic user equilibrium assignment sensitivity
    Cassir, C
    Bell, MGH
    [J]. TRANSPORTATION PLANNING: STATE OF THE ART, 2002, 64 : 69 - 84
  • [35] Multi-state Travel Time Reliability Model: Impact of Incidents on Travel Time Reliability
    Park, Sangjun
    Rakha, Hesham
    Guo, Feng
    [J]. 2011 14TH INTERNATIONAL IEEE CONFERENCE ON INTELLIGENT TRANSPORTATION SYSTEMS (ITSC), 2011, : 2106 - 2111
  • [37] Incorporation of Travel Time Reliability in Regional Travel Model
    Gupta, Surabhi
    Vovsha, Peter
    Dutta, Arup
    Livshits, Vladimir
    Zhang, Wang
    Zhu, Haidong
    [J]. TRANSPORTATION RESEARCH RECORD, 2018, 2672 (49) : 46 - 57
  • [38] Travel time reliability and the bimodal travel time distribution for an arterial road
    Susilawati
    Taylor, Michael A. P.
    Somenahalli, Sekhar
    [J]. ROAD & TRANSPORT RESEARCH, 2010, 19 (04): : 37 - 50
  • [39] Analysis of Freeway Travel Time Variability Using Bluetooth Detection
    Martchouk, Maria
    Mannering, Fred
    Bullock, Darcy
    [J]. JOURNAL OF TRANSPORTATION ENGINEERING, 2011, 137 (10) : 697 - 704
  • [40] Study on Travel Time Reliability Considering Route Travel Time Boundary
    Zhao, Lei
    Guan, Hongzhi
    Zhang, Xinjie
    Zhao, Pengfei
    Wang, Pengfei
    [J]. Huanan Ligong Daxue Xuebao/Journal of South China University of Technology (Natural Science), 2019, 47 (06): : 127 - 135