Reliability of Bluetooth Technology for Travel Time Estimation

被引:22
|
作者
Araghi, Bahar Namaki [1 ]
Olesen, Jonas Hammershoj [2 ]
Krishnan, Rajesh [3 ]
Christensen, Lars Torholm [4 ]
Lahrmann, Harry [1 ]
机构
[1] Aalborg Univ, Dept Planning & Dev, Traff Res Grp, DK-9000 Aalborg, Denmark
[2] COWI, Aalborg, Denmark
[3] Univ London Imperial Coll Sci Technol & Med, Ctr Transport Studies, London, England
[4] BLIP Syst AS, Vodskov, Denmark
关键词
Bluetooth Technology; Detection Zone; Discovery Procedure; Travel Time Estimation;
D O I
10.1080/15472450.2013.856727
中图分类号
U [交通运输];
学科分类号
08 ; 0823 ;
摘要
A unique Bluetooth-enabled device may be detected several times or not at all when it passes a sensor location. This depends mainly on the strength and speed of a transmitting device, discovery procedure, location of the device relative to the Bluetooth sensor, the Bluetooth sensor's ping cycle (0.1s), the size and shape of the sensor's detection zone, and the time span for which the Bluetooth-enabled device is within the detection zone. The influences of size of Bluetooth sensor detection zones and Bluetooth discovery procedure on multiple detection events have been mentioned in previous research. However, their corresponding impacts on accuracy and reliability of estimated travel time have not been evaluated. In this study, a controlled field experiment is conducted to collect both Bluetooth and global positioning system (GPS) data for 1000 trips to be used as the basis for evaluation. Data obtained by GPS logger are used to calculate actual travel time, referred to as ground truth, and to geo-code the Bluetooth detection events. In this setting, reliability is defined as the percentage of devices captured per trip during the experiment. It is found that, on average, Bluetooth-enabled devices will be detected 80% of the time while passing a sensor location. The impact of location ambiguity caused by the size of the detection zone is evaluated using geo-coded Bluetooth data. Results show that more than 80% of the detection events are recorded within the range of 100m from the sensor center line. It is also shown that short-range antennas detect Bluetooth-enabled devices in a location closer to the sensor, thus providing a more accurate travel time estimate. However, the smaller the size of the detection zone, the lower is the penetration rate, which could itself influence the accuracy of estimates. Therefore, there has to be a trade-off between acceptable level of location ambiguity and penetration rate for configuration and coverage of the antennas.
引用
收藏
页码:240 / 255
页数:16
相关论文
共 50 条
  • [1] Mode-Specific Travel Time Estimation Using Bluetooth Technology
    Araghi, Bahar Namaki
    Krishnan, Rajesh
    Lahrmann, Harry
    [J]. JOURNAL OF INTELLIGENT TRANSPORTATION SYSTEMS, 2016, 20 (03) : 219 - 228
  • [2] Evaluation of Bluetooth Detectors in Travel Time Estimation
    Jedwanna, Krit
    Boonsiripant, Saroch
    [J]. SUSTAINABILITY, 2022, 14 (08)
  • [3] Accuracy of Travel Time Estimation Using Bluetooth Technology: Case Study Limfjord Tunnel Aalborg
    Araghi, Bahar Namaki
    Pedersen, Kristian Skoven
    Christensen, Lars Torholm
    Krishnan, Rajesh
    Lahrmann, Harry
    [J]. INTERNATIONAL JOURNAL OF INTELLIGENT TRANSPORTATION SYSTEMS RESEARCH, 2015, 13 (03) : 166 - 191
  • [4] Estimation of value of travel time reliability
    Nam, D
    Park, D
    Khamkongkhun, A
    [J]. JOURNAL OF ADVANCED TRANSPORTATION, 2005, 39 (01) : 39 - 61
  • [5] Estimation of Travel Time Based on Bluetooth MAC Address Identification
    Li, Qiangwei
    Chen, Lufeng
    Huang, Yun
    Wang, Yingzhi
    Mao, Yongbo
    [J]. INFORMATION TECHNOLOGY AND INTELLIGENT TRANSPORTATION SYSTEMS, VOL 1, 2017, 454 : 645 - 651
  • [6] Bluetooth Traffic Monitoring Systems for Travel Time Estimation on Freeways
    Vinagre Diaz, Juan Jose
    Rodriguez Gonzalez, Ana Belen
    Richard Wilby, Mark
    [J]. IEEE TRANSACTIONS ON INTELLIGENT TRANSPORTATION SYSTEMS, 2016, 17 (01) : 123 - 132
  • [7] Empirical Study of Travel Time Estimation and Reliability
    Li, Ruimin
    Chai, Huajun
    Tang, Jin
    [J]. MATHEMATICAL PROBLEMS IN ENGINEERING, 2013, 2013
  • [8] Evaluating Advancements in Bluetooth Technology for Travel Time and Segment Speed Studies
    Cotten, Drew
    Codjoe, Julius
    Loker, Matthew
    [J]. TRANSPORTATION RESEARCH RECORD, 2020, 2674 (04) : 193 - 204
  • [9] Investigation with Bluetooth Sensors of Bicycle Travel Time Estimation on a Short Corridor
    Mei, Zhenyu
    Wang, Dianhai
    Chen, Jun
    [J]. INTERNATIONAL JOURNAL OF DISTRIBUTED SENSOR NETWORKS, 2012,
  • [10] Estimation of the value of travel time and of travel time reliability for heterogeneous drivers in a road network
    Teppei Kato
    Kenetsu Uchida
    William H. K. Lam
    Agachai Sumalee
    [J]. Transportation, 2021, 48 : 1639 - 1670