Measurement of alternating and rotational magnetostrictions of Non-oriented silicon steel sheets

被引:5
|
作者
Dou, Yu [1 ]
Li, Yongjian [1 ]
Yue, Shuaichao [1 ]
Li, Yang [2 ]
Zhu, Jianguo [3 ]
机构
[1] Hebei Univ Technol, State Key Lab Reliabil & Intelligence Elect Equipm, Tianjin 300130, Peoples R China
[2] Tsinghua Univ, Dept Elect Engn, Beijing 100084, Peoples R China
[3] Univ Sydney, Sch Elect & Informat Engn, Sydney, NSW 2006, Australia
基金
中国国家自然科学基金;
关键词
Rotational magnetostriction; Non -oriented silicon steel sheets; Strain gauge; ELECTRICAL STEELS; POWER LOSS; WAVE;
D O I
10.1016/j.jmmm.2023.170566
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Extensive numerical analyses and experimental tests have shown that while major regions of magnetic cores in electromagnetic devices, such as transformers and rotating electric machines, are dominated by the alternating magnetic fields, the rotating magnetic fields exist in the corner joints of multi-phase transformers and the yoke area behind the teeth of rotating electric machines. These magnetic fields cause core losses due to hysteresis and eddy currents, mechanical vibration and acoustic noises due to magnetostriction. Many studies have been re-ported in the literature on alternating and rotational core losses and alternating magnetostriction, but not so much on rotational magnetostriction, especially in non-oriented (NO) silicon steel sheets. The vibration and noise caused by rotational magnetostriction are much higher than those caused by alternating magnetostriction. This paper reports the development of a magnetostriction measurement system consisting of a 2D symmetrical single sheet tester (SST) and resistance strain gauges. The selection considerations of resistance strain gauges are summarized. The alternating and rotational magnetostriction characteristics of a NO silicon steel, B35A300 (0.35 mm), are measured. Because the rotating magnetic field in the stator is not always ideally circular but more often elliptical, the magnetostriction under elliptical magnetizations with different axis ratios is also measured. The magnetostriction anisotropy of the NO steel sheet is observed and analyzed. The elongation and contraction under alternating, circular and elliptical rotating magnetizations with different axis ratios are discussed. The results can provide data support for calculating and designing multi-phase transformers and rotating electric machines under different types of magnetizations. The research can provide theoretical and practical guidance for mitigating mechanical vibration and acoustic noise caused by magnetostriction.
引用
收藏
页数:8
相关论文
共 50 条
  • [21] Manufacture and application of a Cr-free insulation coat for non-oriented silicon steel sheets
    XU Yunpeng
    LIU Xiandong
    LI Dengfeng
    YANG Yongjie
    CHEN Zhuolei
    [J]. Baosteel Technical Research, 2013, 7 (01) : 9 - 11
  • [22] NON-ORIENTED ELECTRICAL SHEETS
    BRISSONNEAU, P
    [J]. JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 1984, 41 (1-3) : 38 - 46
  • [23] Analytical model for magnetic anisotropy of non-oriented steel sheets
    Martin, Floran
    Singh, Deepak
    Belahcen, Anouar
    Rasilo, Paavo
    Haavisto, Ari
    Arkkio, Antero
    [J]. COMPEL-THE INTERNATIONAL JOURNAL FOR COMPUTATION AND MATHEMATICS IN ELECTRICAL AND ELECTRONIC ENGINEERING, 2015, 34 (05) : 1475 - 1488
  • [24] Importance of punching and workability in non-oriented electrical steel sheets
    Kurosaki, Yousuke
    Mogi, Hisashi
    Fujii, Hiroyasu
    Kubota, Takeshi
    Shiozaki, Morio
    [J]. JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 2008, 320 (20) : 2474 - 2480
  • [25] Modeling of magnetization curves in non-oriented electrical steel sheets
    Kaido, Chikara
    [J]. IEEJ Transactions on Fundamentals and Materials, 2011, 131 (06) : 466 - 471
  • [26] Cyclic deformation behavior of non-oriented electrical steel sheets
    Gottwalt-Baruth, Albin
    Kubaschinski, Paul
    Waltz, Manuela
    Voelkl, Rainer
    Glatzel, Uwe
    Tetzlaff, Ulrich
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2023, 886
  • [27] Static and dynamic rotational losses in non-oriented electrical steel
    Zurek, Stan
    [J]. PRZEGLAD ELEKTROTECHNICZNY, 2009, 85 (01): : 89 - 92
  • [28] Non-oriented silicon steel recrystallization texture study
    Cunha, MA
    Paolinelli, SC
    [J]. TEXTURES OF MATERIALS, PTS 1 AND 2, 2002, 408-4 : 779 - 784
  • [29] Development of non-oriented thin silicon steel strip
    State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004, China
    [J]. Kang T'ieh, 2007, 2 (60-63):
  • [30] Study on source of inclusions in non-oriented silicon steel
    Wang, An-Ren
    Yang, Shu-Feng
    He, Bi-Fei
    Li, Jian-Min
    Li, Shi-Qi
    [J]. Gongcheng Kexue Xuebao/Chinese Journal of Engineering, 2016, 38 : 181 - 186