In-situ electrochemical analytical effect of aging treatment on stress corrosion behavior of Al-Zn-Mg-Cu aluminum alloy

被引:17
|
作者
Guo, Fuqiang [1 ]
Duan, Shuwei [2 ]
Pan, Yuzhe [1 ]
Wu, Dongting [1 ]
Matsuda, Kenji [3 ]
Wang, Tao [1 ]
Zou, Yong [4 ]
机构
[1] Shandong Univ, Sch Mat Sci & Engn, Key Lab Liquid Solid Struct Evolut & Proc Mat, Minist Educ, Jinan 250061, Peoples R China
[2] Yantai Univ, Coll Nucl Equipment & Nucl Engn, Yantai 264005, Peoples R China
[3] Univ Toyama, Fac Sustainable Design, Toyama 9308555, Japan
[4] Shandong Univ, Shandong Engn & Technol Res Ctr Modern Welding, Jinan 250061, Peoples R China
关键词
Al-Zn-Mg-Cu alloy; Precipitates; In-situ; Electrochemistry; Stress corrosion; HYDROGEN EMBRITTLEMENT; MECHANICAL PROPERTY; CRACKING BEHAVIOR; STRENGTH; MICROSTRUCTURE; EXFOLIATION; RESISTANCE;
D O I
10.1016/j.jmrt.2023.02.130
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The stress corrosion cracking (SCC) behavior of Al-Zn-Mg-Cu alloys in different aging treatment states was dynamically studied by slow strain rate tensile (SSRT) combining in -situ electrochemical impedance spectroscopy (EIS). By analyzing the influence of micro-structure and precipitation phase on stress corrosion resistance under different aging conditions, it was found that the stress corrosion process can be divided into three stages, the corresponding charge transfer resistance (Rct) shows three evolutionary patterns, with the maximum value occurred when the alloys were under the maximum stress. The regression re-aging (RRA) treatment obtained coarse and discrete grain boundary pre-cipitates (GBPs) with higher Cu content, which improved the SCC resistance of alloys significantly.(c) 2023 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).
引用
收藏
页码:5807 / 5820
页数:14
相关论文
共 50 条
  • [21] Effect of Nonisothermal Creep Aging on Mechanical Properties and Corrosion Resistance of Al-Zn-Mg-Cu Alloy
    Wang Lingjiao
    Li Xiaoqiang
    Pan Cunliang
    Zhu Dezhi
    Qu Shengguan
    Huang Xia
    RARE METAL MATERIALS AND ENGINEERING, 2023, 52 (03) : 867 - 875
  • [22] Effect of Deep Cryogenic Treatment on Wear and Corrosion Resistance of an Al-Zn-Mg-Cu Alloy
    Siyi Ma
    Su, Ruiming
    Wang, Kaining
    Yang, Yuping
    Qu, Yingdong
    Li, Rongde
    RUSSIAN JOURNAL OF NON-FERROUS METALS, 2021, 62 (01) : 89 - 96
  • [23] The effect of initial alloy temper on corrosion resistance for Al-Zn-Mg-Cu alloy
    Jiang, Yifu
    Xu, Siyang
    Gao, Shuang
    CORROSION SCIENCE, 2022, 209
  • [24] Investigation of homogenization treatment on new Al-Zn-Mg-Cu aluminum alloy
    Gong, Peng
    Zhang, Kun
    Dai, Sheng-Long
    Hangkong Cailiao Xuebao/Journal of Aeronautical Materials, 2009, 29 (05): : 33 - 38
  • [25] Enhancing the stress corrosion cracking resistance of a low-Cu containing Al-Zn-Mg-Cu aluminum alloy by step-quench and aging heat treatment
    Xie, Peng
    Chen, Songyi
    Chen, Kanghua
    Jiao, Huibin
    Huang, Lanping
    Zhang, Zhuo
    Yang, Zhen
    CORROSION SCIENCE, 2019, 161
  • [26] Electrochemical assessment of laser heat treatment of an Al-Zn-Mg-Cu alloy
    Wang, Kaining
    Su, Ruiming
    Liu, Tong
    Qu, Yingdong
    Li, Rongde
    MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION, 2020, 71 (03): : 374 - 381
  • [27] Effect of Mn and Zr on the Anisotropy of Al-Zn-Mg-Cu Aluminum Alloy
    Jiao H.
    Chen S.
    Chen S.
    Chen K.
    Chen, Kanghua (Khchen@csu.edu.cn), 2018, Cailiao Daobaoshe/ Materials Review (32): : 937 - 942
  • [28] Stress Corrosion Cracking in Al-Zn-Mg-Cu Aluminum Alloys in Saline Environments
    Holroyd, N. J. Henry
    Scamans, G. M.
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2013, 44A (03): : 1230 - 1253
  • [29] Stress Corrosion Cracking in Al-Zn-Mg-Cu Aluminum Alloys in Saline Environments
    N. J. Henry Holroyd
    G. M. Scamans
    Metallurgical and Materials Transactions A, 2013, 44 : 1230 - 1253
  • [30] HEAT TREATMENT TO REDUCE THE SUSCEPTIBILITY OF Al-Zn-Mg-Cu ALLOY TO STRESS CORROSION CRACKING.
    Ohnishi, Tadakazu
    Shiota, Hideaki
    Keikinzoku/Journal of Japan Institute of Light Metals, 1986, 36 (10): : 647 - 656