Waveform impact on thermo-mechanical fatigue crack growth of a non-crystallizing rubber: Experimental observation and numerical simulation

被引：7
|
作者：
Liu, Chen [1 ,2 ]
Gu, Bochao [2 ]
Wang, Feng [3 ]
Lu, Bo [3 ]
Liu, Fengzhu [3 ]
Liu, Jun [1 ]
Lu, Yonglai [1 ,2 ]
Zhang, Liqun [1 ,2 ]
Li, Fanzhu [1 ,2 ]
机构：
[1] Beijing Univ Chem Technol, State Key Lab Organ Inorgan Composites, Beijing 100029, Peoples R China
[2] Beijing Univ Chem Technol, Key Lab Beijing City Preparat & Proc Novel Polymer, Beijing 100029, Peoples R China
[3] Shandong Linglong Tyre Co LTD, Yantai 265406, Shandong, Peoples R China
来源：
COMPOSITES PART B-ENGINEERING | 2023年 / 255卷
基金：
中国国家自然科学基金;
关键词：
Rubber; Thermo-mechanical; Fatigue crack growth; Pulse waveform; Finite element analysis; NATURAL-RUBBER; HEAT BUILDUP; TEMPERATURE; BEHAVIOR; PROPAGATION; MECHANISM; LIFE; TIP;
D O I：
10.1016/j.compositesb.2023.110604
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
Compared with the sine waveform, the pulse waveform load is more in line with the real service condition of tire. It was investigated the effect of two pulse waveform loads on the thermo-mechanical fatigue crack growth rate (FCGR) of filled styrene-butadiene rubber and explained the underlying mechanism. The fatigue test and infrared thermal imaging test revealed that the shorter the pulse excitation time, the higher the heat build-up and the faster the FCGR. The underlying mechanism was explained by an established thermo-mechanical coupling method, and it was pointed out that the faster FCGR under high-frequency loading condition resulted from higher hysteresis energy rather than higher strain energy. The Parallel Rheological Framework model could not explain this phenomenon well.
引用
收藏
页数：9
相关论文
共 50 条
  • [31] A coupled numerical and experimental study on thermo-mechanical fatigue failure in SnAgCu solder joints
    Erinc, M.
    Schreurs, P. J. G.
    Geers, M. G. D.
    EUROSIME 2007: THERMAL, MECHANICAL AND MULTI-PHYSICS SIMULATION AND EXPERIMENTS IN MICRO-ELECTRONICS AND MICRO-SYSTEMS, PROCEEDINGS, 2007, : 707 - +
  • [32] Hold-time effect on the thermo-mechanical fatigue crack growth behaviour of Inconel 718
    Moverare, Johan J.
    Gustafsson, David
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (29-30): : 8660 - 8670
  • [33] Fatigue crack growth modeling in the metallization of power semiconductors under cyclic thermo-mechanical loading
    Springer, Martin
    Nelhiebel, Michael
    Pettermann, Heinz E.
    2016 17TH INTERNATIONAL CONFERENCE ON THERMAL, MECHANICAL AND MULTI-PHYSICS SIMULATION AND EXPERIMENTS IN MICROELECTRONICS AND MICROSYSTEMS (EUROSIME), 2016,
  • [34] Thermo-Mechanical Fatigue Cycle Damage Mechanism and Numerical Simulation of GH4169 Superalloy
    Zhang Lu
    Yu Zhiwei
    Zhang Leicheng
    Jiang Rong
    Song Yingdong
    ACTA METALLURGICA SINICA, 2023, 59 (07) : 871 - 883
  • [35] Estimation of thermo-mechanical fatigue crack growth using an accumulative approach based on isothermal test data
    Kraemer, Karl Michael
    Mueller, Falk
    Oechsner, Matthias
    Riva, Andrea
    Dimaggio, Dalila
    Vacchieri, Erica
    Poggio, Eleonora
    INTERNATIONAL JOURNAL OF FATIGUE, 2017, 99 : 250 - 257
  • [36] Improvement of thermo-mechanical and fatigue crack growth resistance of tire sidewall compound by introducing syndiotactic polybutadiene
    Sen, Amit Kumar
    Chanda, Jagannath
    Shee, Biswajit
    Mazumder, Amrita
    Dasgupta, Mridul
    Ghosh, Prasenjit
    Mukhopadhyay, Rabindra
    JOURNAL OF APPLIED POLYMER SCIENCE, 2022, 139 (28)
  • [37] Improvement of thermo-mechanical and fatigue crack growth resistance of tire sidewall compound by introducing syndiotactic polybutadiene
    Sen, Amit Kumar
    Chanda, Jagannath
    Shee, Biswajit
    Mazumder, Amrita
    Dasgupta, Mridul
    Ghosh, Prasenjit
    Mukhopadhyay, Rabindra
    Journal of Applied Polymer Science, 2022, 139 (28):
  • [38] An Integrated Creep, Crack Growth and Thermo-mechanical Fatigue Model for WLCSP Assemblies Soldered with SAC 405
    Limaye, Paresh
    Vandevelde, Bart
    Vandepitte, Dirk
    Verlinden, Bert
    2009 IEEE 59TH ELECTRONIC COMPONENTS AND TECHNOLOGY CONFERENCE, VOLS 1-4, 2009, : 704 - +
  • [39] Modelling of the thermo-mechanical material behaviour of rubber-like polymers - Micromechanical motivation and numerical simulation
    Reese, S
    Wriggers, P
    CONSTITUTIVE MODELS FOR RUBBER, 1999, : 13 - 21
  • [40] On the mechanistic difference between in-phase and out-of-phase thermo-mechanical fatigue crack growth
    Norman, V
    Stekovic, S.
    Jones, J.
    Whittaker, M.
    Grant, B.
    INTERNATIONAL JOURNAL OF FATIGUE, 2020, 135
12345