Harmonizing color measurements in dentistry using translucent tooth-colored materials

被引:0
|
作者
Tango, Rubens Nisie [1 ]
Volpato, Claudia Angela Maziero [2 ]
Santos, Karina Felix [3 ]
Cesar, Paulo Francisco [3 ]
Paravina, Rade Dusan [4 ]
机构
[1] Sao Paulo State Univ, Inst Sci & Technol, Sch Dent, Dept Dent Mat & Prosthodont, Ave Eng Francisco Jose Longo,777,Sao Jose Dos Camp, BR-12245320 Sao Paulo, SP, Brazil
[2] Univ Fed Santa Catarina, Dept Dent, Sch Dent, R Delfino Conti,1240, BR-88040535 Florianopolis, SC, Brazil
[3] Univ Sao Paulo, Fac Dent, Dept Biomat & Oral Biol, Ave Prof Lineu Prestes,2227, BR-05508000 Sao Paulo, SP, Brazil
[4] Univ Texas Sch Dent Houston, Dept Restorat Dent & Prosthodont, 7500 Cambridge St, Houston, TX 77054 USA
关键词
Color measurement; Spectrophotometry; Calibration; Psychophysics; PERFORMANCE;
D O I
10.1186/s12903-024-03935-1
中图分类号
R78 [口腔科学];
学科分类号
1003 ;
摘要
BackgroundSince color measurements are relative, the discrepancy among different instruments is alarmingly high. This multicenter study evaluated the effectiveness of instrument calibration and inter-instrument harmonization of different spectrophotometers with the same optical geometry using tooth-colored, translucent dental materials.MethodsThe coordinating center (CC) spectrophotometer was calibrated using the NPL Ceram Series II set. Two sets of 10 specimens, labeled 1 to 10 and I to X (10 mm in diameter and 1 mm thick), were tested at CC and three research sites (RS1, RS2, and RS3) using the same d/8 degrees optical geometry spectrophotometers. Calibration factors were calculated for each material and site to obtain the average calibration factors for sets 1-10, set I-X, and the combination of both. The differences among the non-corrected and corrected reflection values were calculated using CIEDE2000 (DeltaE00) and CIELAB (DeltaEab) color difference formulas and were submitted to ANOVA and Tukey test (alpha = 0.05).ResultsA significant decrease of color differences between non-corrected as compared to corrected measurements was recorded for all CC-RS and RS-RS comparisons. The reduction of DeltaE00 values between non-corrected and corrected for CC-RS1, CC-RS2, and CC-RS3 were 83.1%, 77.2%, and 73.6%, respectively. The corresponding DeltaE00 values for RS1-RS2, RS1-RS3, and RS2-RS3 comparisons, indirectly compared in the experiment, were 84.2%, 82.8%, and 68.5%, respectively. There was a significant reduction of DeltaE00 and DeltaEab color difference for all combined RS pairs and each of three RS pairs, corrected with one of two specimen sets calibration factors separately.ConclusionsCalibration and harmonization of color measurements in dentistry using tooth-colored, translucent restorative materials significantly decreased measurement discrepancies between the coordinating center and research sites and among pairs of research sites.
引用
收藏
页数:6
相关论文
共 50 条
  • [31] In vitro surface and color changes of tooth-colored restorative materials after sport and energy drink cyclic immersions
    Tanthanuch, Saijai
    Kukiattrakoon, Boonlert
    Thongsroi, Thanyathorn
    Saesaw, Premkamol
    Pongpaiboon, Naphat
    Saewong, Supharadee
    BMC ORAL HEALTH, 2022, 22 (01)
  • [32] In vitro surface and color changes of tooth-colored restorative materials after sport and energy drink cyclic immersions
    Saijai Tanthanuch
    Boonlert Kukiattrakoon
    Thanyathorn Thongsroi
    Premkamol Saesaw
    Naphat Pongpaiboon
    Supharadee Saewong
    BMC Oral Health, 22
  • [33] SEM INVESTIGATION OF INVIVO PERFORMANCE OF 12 TOOTH-COLORED RESTORATIVE MATERIALS
    FLYNN, M
    JOURNAL OF DENTAL RESEARCH, 1976, 55 : B191 - B191
  • [34] Color change of tooth-colored restorative materials bonded to silver diamine fluoride-treated dentine: a systematic review
    Sabbagh, Sedigheh
    Movahhed, Taraneh
    Bagheri, Hossein
    Sadeghi, Masoumeh
    Shahid, Saroash
    Mohammadi, Homeira
    BMC ORAL HEALTH, 2024, 24 (01):
  • [35] Temperature mediated coefficient of dimensional change of dental tooth-colored restorative materials
    Sidhu, SK
    Carrick, TE
    McCabe, JF
    DENTAL MATERIALS, 2004, 20 (05) : 435 - 440
  • [36] Changes in the mechanical properties of tooth-colored direct restorative materials in relation to time
    Saygili, G
    Sahmali, S
    Demirel, F
    POLYMERS FOR ADVANCED TECHNOLOGIES, 2003, 14 (09) : 616 - 622
  • [37] Effect of Heat on the Fluorescence Properties of Tooth-Colored Restorative Materials and Their Forensic Implications
    Kiran, Ramya
    Chapman, James
    Tennant, Marc
    Forrest, Alexander
    Walsh, Laurence J.
    JOURNAL OF FORENSIC SCIENCES, 2019, 64 (06) : 1698 - 1706
  • [38] Comparative Evaluation of Hardness and Elasticity Modulus of Tooth-Colored Materials for Dental Restoration
    Ghiorghe, Cristina Angela
    Iovan, Gianina
    Carlescu, Vlad
    Istrate, Bogdan
    Pancu, Galina
    Andrian, Sorin
    REVISTA DE CHIMIE, 2017, 68 (11): : 2623 - 2627
  • [39] The effect of periodontal prophylaxis procedures on the surface properties of tooth-colored restorative materials
    Acikgoz-Alparslan, Ece
    Buyukgoze-Dindar, Mediha
    Tekbas-Atay, Meltem
    SURFACE TOPOGRAPHY-METROLOGY AND PROPERTIES, 2022, 10 (02)
  • [40] Effects of bleaching gels on the surface microhardness of tooth-colored restorative materials in situ
    Yu, Hao
    Li, Qing
    Hussain, Manal
    Wang, Yining
    JOURNAL OF DENTISTRY, 2008, 36 (04) : 261 - 267