Hydrogen diffusion kinetics in dual-phase (DP 980) steel: The role of pre-strain and tensile stress

被引:8
|
作者
Reddy, Kallem Shekar [1 ]
Govindaraj, Yoganandan [1 ,2 ]
Neelakantan, Lakshman [1 ]
机构
[1] Indian Inst Technol Madras chennai, Dept Met & Mat Engn, Corros Engn & Mat Electrochem Lab, Chennai 600036, India
[2] Hokkaido Univ, Div Mat Sci & Engn, Sapporo 0608628, Japan
关键词
Dual-phase steel; Hydrogen permeation; Pre-strain; In-situ tensile stress; Hydrogen trapping; PLASTIC-DEFORMATION; PIPELINE STEEL; MECHANICAL-PROPERTIES; DISLOCATION DENSITY; MARTENSITIC STEEL; PERMEATION; EMBRITTLEMENT; BEHAVIOR; TRANSPORT; MICROSTRUCTURE;
D O I
10.1016/j.electacta.2022.141727
中图分类号
O646 [电化学、电解、磁化学];
学科分类号
081704 ;
摘要
The current study investigates the influence of pre-strain (un-strained, 3 %, and 6 % engineering strain) and in-situ tensile stress (50 %, 110 %, and 125 % of the yield stress (YS)) on the hydrogen diffusion and trapping behaviour in DP 980 steel. Electrochemical hydrogen permeation tests were conducted using a custom-built Devanathan-Stachurski (DS) cell integrated with a horizontal tensometer. The results showed that the value of apparent diffusion coefficient (Dapp) decreased from 5.4 +/- 0.1 to 3.8 +/- 0.029 x 10- 7 cm2 s-1, while trap density (NT) and sub-surface hydrogen concentration (Capp) increased from 1.08 +/- 0.01 to 1.58 +/- 0.012 x 1021 cm-3, 2.70 +/- 0.13 to 3.27 +/- 0.10 x 10-4 mol H cm-3, respectively for unstrained and 6 % pre-strain conditions. This is due to increased dislocation density in ferrite and martensite. Hydrogen permeation tests under tensile stress (in-situ) revealed that the applied elastic stress of 50 % of YS showed a slight increase in Dapp and a decrease in NT values. This is due to an increase in the interstitial space between the atoms at applied elastic load favouring hydrogen diffusion. The plastic tensile stress of 110 % of YS showed the highest value of steady-state permeation current density iss (169 +/- 10.6 mu A cm-2). It could be due to an expanded lattice of martensite accommodating more hydrogen because of its elastic deformation. The tensile stress of 125 % of YS results in a significant reduction in Dapp (2.86 x 10-7 cm2 s-1) and an increase in Capp (5.52 x 10-4 mol H cm-3) and NT (2.11 x 1021 cm -3) as a result of plastic deformation in ferrite and martensite. The decay transient studies revealed that the applied elastic tensile stress enhances the rate of desorption of diffusible hydrogen, increasing lattice diffusion coefficient DL. The plastic pre-strain and plastic tensile stress resulted in slower desorption, lower DL, and an increase in reversible trap density.
引用
收藏
页数:17
相关论文
共 50 条
  • [41] Effect of Warm Rolling on Laminated Ultra-fine Grained Dual-phase Microstructure and Tensile Properties of DP590 Steel
    Su Y.-F.
    Li H.-J.
    Xu X.-N.
    Ye Q.-B.
    Dongbei Daxue Xuebao/Journal of Northeastern University, 2023, 44 (03): : 357 - 362and369
  • [42] Investigation on micromechanism of ferrite hardening after pre-straining with different strain rates of dual-phase steel
    Chen, Yongnan
    Wu, Zhicheng
    Wu, Gang
    Wang, Nan
    Zhao, Qinyang
    Luo, Jinheng
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 802
  • [43] STUDIES ON KINETICS OF STRAIN AGING IN NB, TI, V-BEARING HSLA STEELS AND A DUAL-PHASE STEEL
    PANDA, AK
    GANGULY, RI
    MISRA, S
    STEEL RESEARCH, 1992, 63 (03): : 131 - 136
  • [44] Quantification of Large Deformation with Punching in Dual Phase Steel and Change of its' Microstructure - Part III: Micro-tensile Behavior of Pre-strained Dual-phase Steel
    Ogata, Shinya
    Mine, Yoji
    Takashima, Kazuki
    Ohmura, Takahito
    Shuto, Hiroshi
    Yokoi, Tatsuo
    TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 2016, 102 (05): : 260 - 267
  • [45] Digital image correlation and infrared measurements to determine the influence of a uniaxial pre-strain on fatigue properties of a dual phase steel.
    Munier, R.
    Doudard, C.
    Calloch, S.
    Weber, B.
    ICEM 14: 14TH INTERNATIONAL CONFERENCE ON EXPERIMENTAL MECHANICS, VOL 6, 2010, 6
  • [46] Numerical modeling and experimental study of thermally induced residual stress in the direct diode laser heat treatment of dual-phase 980 steel
    Kong, Fanrong
    Santhanakrishnan, S.
    Kovacevic, Radovan
    INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2013, 68 (9-12): : 2419 - 2430
  • [48] Microstructure, Tensile, and Low-Stress Abrasive Wear Properties of a New High Silicon Dual-Phase Cast Steel
    Vahidian, Amene
    Abbasi, Majid
    INTERNATIONAL JOURNAL OF METALCASTING, 2024,
  • [49] Numerical modeling and experimental study of thermally induced residual stress in the direct diode laser heat treatment of dual-phase 980 steel
    Fanrong Kong
    S. Santhanakrishnan
    Radovan Kovacevic
    The International Journal of Advanced Manufacturing Technology, 2013, 68 : 2419 - 2430
  • [50] Quantification of Large Deformation with Punching in Dual Phase Steel and Change of its Microstructure-Part III: Micro-tensile Behavior of Pre-strained Dual-phase Steel
    Ogata, Shinya
    Mine, Yoji
    Takashima, Kazuki
    Ohmura, Takahito
    Shuto, Hiroshi
    Yokoi, Tatsuo
    ISIJ INTERNATIONAL, 2016, 56 (11) : 2084 - 2092