Optimization of Heat Transfer in Solar-Powered Biodiesel Reactors Using Alumina Nanofluids: A Combined Experimental and Numerical Study

被引:1
|
作者
Hathal, Mustafa M. [1 ,2 ]
Mohsen, Osama A. [2 ,3 ]
Majdi, Hasan Sh [2 ,4 ]
Hasan, Basim O. [2 ,5 ]
机构
[1] Univ Pannonia, Chem Engn & Mat Sci Doctoral Sch, H-8200 Veszprem, Hungary
[2] Sci Soc Energy Studies & Res, Baghdad 10011, Iraq
[3] Univ Anbar, Chem & Petrochem Engn Dept, Anbar 31002, Iraq
[4] Al Mustaqbal Univ, Chem Engn & Petr Ind Dept, Hilla 51001, Iraq
[5] Nahrain Univ, Dept Chem Engn, Baghdad 10011, Iraq
关键词
biodiesel thermal reactor; solar system; nanofluid; computational fluid dynamics (CFD); TRANSFER ENHANCEMENT; SYSTEMS;
D O I
10.18280/ijht.410601
中图分类号
O414.1 [热力学];
学科分类号
摘要
The challenge posed by waste cooking oil (WCO) accumulation in sewage systems necessitates innovative solutions. This study presents an investigation into enhancing biodiesel production from WCO by augmenting heat absorption using oil-alumina nanofluids in a plug flow reactor powered by photovoltaic (PV) solar cells. Nanofluids with varying alumina concentrations (0%, 0.1%, 0.5%, and 2%) were examined. The investigation comprised two phases: Initially, nanoparticles were visualized via transmission electron microscopy (TEM), followed by the determination of nanofluid physical properties, including thermal conductivity, density, viscosity, and heat capacity. Subsequently, these properties were integrated into a finite element method (FEM) numerical simulation of the solar reactor using COMSOL Multiphysics. The study further involved design of experiments, regression analysis, and optimization techniques to elucidate the relationship between absorbed heat (Qc), oil flow rate (q), and nanoparticle volume percent (fi). The results indicate that an oil flow rate (q) of 0.0000173 m(3)/s and a nanoparticle volume percent (fi) of 2% significantly enhance heat absorption by approximately 43%. This research not only addresses the accumulation of WCO in sewage systems but also proposes a novel method to reduce fouling by utilizing biodiesel production. The findings underscore the efficiency of oil-alumina nanofluids in a plug flow solar reactor and the impact of varying nanoparticle concentrations on heat absorption. The physical properties of the nanofluid and its performance in the solar reactor are meticulously documented. Furthermore, the study delineates optimal operational conditions, resulting in a substantial increase in heat absorption. These insights are instrumental in developing sustainable waste oil management strategies and leveraging renewable energy sources within sewage systems.
引用
收藏
页码:1397 / 1406
页数:10
相关论文
共 50 条
  • [11] Performance characterization of a solar-powered shell and tube heat exchanger utilizing MWCNTs/water-based nanofluids: An experimental, numerical, and artificial intelligence approach
    Said, Zafar
    Rahman, Shek
    Sharma, Prabhakar
    Hachicha, Ahmed Amine
    Issa, Salah
    APPLIED THERMAL ENGINEERING, 2022, 212
  • [12] Numerical and experimental investigation of heat transfer enhancement in a microtube using nanofluids
    Salman, B. H.
    Mohammed, H. A.
    Kherbeet, A. Sh.
    INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2014, 59 : 88 - 100
  • [13] Experimental and Numerical Analysis of Convective Heat Transfer of Alumina Nanofluids Under Laminar Flow Regime
    Rehman, Hafizur
    Nine, Md. J.
    Afrianto, Handry
    Kim, J. H.
    Chung, Hanshik
    Jeong, Hyomin
    JOURNAL OF COMPUTATIONAL AND THEORETICAL NANOSCIENCE, 2013, 10 (10) : 2305 - 2311
  • [14] Computational study of Cattaneo-Christov heat flux on cylindrical surfaces using CNT hybrid nanofluids: A solar-powered ship implementation
    Obalalu, A. M.
    Salawu, S. O.
    Memon, M. Asif
    Olayemi, O. A.
    Ali, Mohamed R.
    Sadat, R.
    Odetunde, C. B.
    Ajala, O. A.
    Akindele, A. O.
    CASE STUDIES IN THERMAL ENGINEERING, 2023, 45
  • [15] Experimental assessment of heat and mass transfer characteristics of solar-powered adiabatic liquid desiccant dehumidifier and regenerator
    Oyieke, Andrew Y. A.
    Inambao, Freddie L.
    INTERNATIONAL JOURNAL OF LOW-CARBON TECHNOLOGIES, 2020, 15 (04) : 477 - 495
  • [16] Experimental Study on Heat Transfer Characteristics of Thermosyphon Using Nanofluids
    Lee, Moo Yeon
    Cho, Chung Won
    Lee, Ho Seong
    Won, Jong Phil
    Lim, Taek Kyu
    TRANSACTIONS OF THE KOREAN SOCIETY OF MECHANICAL ENGINEERS B, 2012, 36 (11) : 1073 - 1079
  • [17] Numerical study on heat transfer characteristics of thermosyphon heat pipes using nanofluids
    Huminic, Gabriela
    Huminic, Angel
    ENERGY CONVERSION AND MANAGEMENT, 2013, 76 : 393 - 399
  • [18] Numerical Study of Influence of Nanofluids on the Optimization of Heat Transfer in Immersion Cooling Systems
    Makaoui, Abdelilah
    Admi, Youssef
    Moussaoui, Mohammed Amine
    Mezrhab, Ahmed
    PROCESSES, 2025, 13 (03)
  • [19] Experimental study of convective heat transfer of alumina oxide nanofluids in triangle channel with uniform heat flux
    Sahim, Kaprawi
    Puspitasari, Dewi
    Nukman
    Frontiers in Heat and Mass Transfer, 2021, 16
  • [20] EXPERIMENTAL STUDY OF CONVECTIVE HEAT TRANSFER OF ALUMINA OXIDE NANOFLUIDS IN TRIANGLE CHANNEL WITH UNIFORM HEAT FLUX
    Sahim, Kaprawi
    Puspitasari, Dewi
    Nukman
    FRONTIERS IN HEAT AND MASS TRANSFER, 2021, 16