Effect of welding processes on ferrite content, microstructure and mechanical properties of super duplex stainless steel 2507 welds

Super duplex stainless steel (SDSS) plates of 6 mm thickness have been welded using tungsten inert gas, activated tungsten inert gas, electron beam welding and friction stir welding processes. Among these, in the first two, melting and solidification of material occurs slowly whereas, it is faster in electron beam welding process and no melting occurs in friction stir welding. Macro and microstructural studies, hardness surveys, tensile tests and percentage of ferrite content were compared for all the welds. The ferrite-austenite phase balance is 50 % each, with electron beam weld metal at about 65 % ferrite. This showed the hardness of the weld metal and heat affected zones to be higher than base metal. The weldment joint efficiencies are more than 90 %. The fracture location is found to be in the weld metal for tungsten inert gas and activated tungsten inert gas weld, in the nugget for friction stir welds and in the base metal for electron beam welds. The ductility of electron beam weld joints is 32 % while it is around 20 % for the others. The preferred order while choosing the welding process should be activated tungsten inert gas welding, tungsten inert gas welding, electron beam welding, and friction stir welding.