An output-only unbiased minimum variance state estimator for linear systems

被引:1
|
作者
Didyk, Martin Masanes [1 ]
Hassanabadi, Mohsen Ebrahimzadeh [2 ]
Azam, Saeed Eftekhar [1 ]
机构
[1] Univ New Hampshire, Dept Civil & Environm Engn, Durham, NH 03824 USA
[2] Univ Sydney, Sch Civil Engn, Sydney, NSW 2006, Australia
关键词
Output -only filtering; Unbiased estimation; Minimum variance; Stochastic system identification; KALMAN FILTER; INPUT;
D O I
10.1016/j.ymssp.2024.111204
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
This study proposes a novel filtering method for unbiased minimum variance state estimation. A key challenge in the development of digital twinning and system identification of operational civil infrastructure is the difficulties associated with measurement of the often nonstationary, and stochastic unknown input to the system, e.g. traffic, earthquake, and wind loads. Herein a novel algorithm is presented for an unbiased output-only state estimation for linear state space systems with direct feedthrough. In this paper, the problem of state estimation for discrete time systems with unknown input, where no previous assumption is made regarding the probability distribution of the input, is addressed. In this regard, a two-stage output-only filter is proposed. The unbiasedness of the estimation is demonstrated, and the error covariance propagation over time is derived. It is shown that the unknown input of the system can be subsequently reconstructed via the system matrices, the measured responses, and the estimated state vector. A closed-form solution is provided for the parameters associated with pseudo-inverse in gain calculations to ensure the numerical stability of the filter. Three case studies including simulated and laboratory experiments for verification, validation, and cross comparison of the proposed method are presented. The first case study corresponds to a simulated shear building subjected to two different load time histories, a parametric sinusoidal load, and an earthquake ground acceleration. The second case study shows the results for a simulated experiment on a steel railway bridge subjected to a concentrated load. The third case study corresponds to a laboratory shear building subjected to ground motion and observed through accelerometers. The results of the experiments show a good agreement between the "true response" and the filter state estimation. Moreover, the proposed method is compared against a state-of-the-art algorithm.
引用
收藏
页数:24
相关论文
共 50 条
  • [41] Performance analysis of the blind minimum output variance estimator for carrier frequency offset in OFDM systems
    Yang, Feng
    Li, Kwok H.
    Teh, Kah C.
    EURASIP JOURNAL ON APPLIED SIGNAL PROCESSING, 2006, 2006 (1)
  • [42] The harmonic probing method for output-only nonlinear mechanical systems
    Oscar Scussel
    Samuel da Silva
    Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2017, 39 : 3329 - 3341
  • [43] DETERMINING MINIMUM NUMBER OF REQUIRED ACCELEROMETER FOR OUTPUT-ONLY STRUCTURAL IDENTIFICATION OF FRAMES
    Davoodi, M. R.
    Neya, B. Navayi
    Mostafavian, S. A.
    Nabavian, S. R.
    Jahangiry, GH. R.
    7TH IOMAC: INTERNATIONAL OPERATIONAL MODAL ANALYSIS CONFERENCE, 2017, : 279 - 282
  • [44] Output-Only Identification of Nonlinear Systems Via Volterra Series
    Scussel, Oscar
    da Silva, Samuel
    JOURNAL OF VIBRATION AND ACOUSTICS-TRANSACTIONS OF THE ASME, 2016, 138 (04):
  • [45] Output-only damping estimation of friction systems in ambient vibrations
    Friis, T.
    Katsanos, E. I.
    Tarpo, M.
    Amador, S.
    Brincker, R.
    PROCEEDINGS OF INTERNATIONAL CONFERENCE ON NOISE AND VIBRATION ENGINEERING (ISMA2018) / INTERNATIONAL CONFERENCE ON UNCERTAINTY IN STRUCTURAL DYNAMICS (USD2018), 2018, : 2989 - 2999
  • [46] The harmonic probing method for output-only nonlinear mechanical systems
    Scussel, Oscar
    da Silva, Samuel
    JOURNAL OF THE BRAZILIAN SOCIETY OF MECHANICAL SCIENCES AND ENGINEERING, 2017, 39 (09) : 3329 - 3341
  • [47] Damage identification of output-only systems by means of genetic algorithms
    Betti, Michele
    Biagini, Paolo
    Facchini, Luca
    PROCEEDINGS OF THE 8TH INTERNATIONAL CONFERENCE ON STRUCTURAL DYNAMICS, EURODYN 2011, 2011, : 2257 - 2264
  • [48] Damage localization in output-only systems: A flexibility based approach
    Bernal, D
    Gunes, B
    PROCEEDINGS OF IMAC-XX: STRUCTURAL DYNAMICS VOLS I AND II, 2002, 4753 : 1185 - 1191
  • [49] Comparison of output-only methods for condition monitoring of industrials systems
    Rutten, C.
    Nguyen, V. -H.
    Golinval, J. -C.
    9TH INTERNATIONAL CONFERENCE ON DAMAGE ASSESSMENT OF STRUCTURES (DAMAS 2011), 2011, 305