Influence of composition and temperature on distribution behavior of V, Ti and Si in HIsmelt

被引:4
|
作者
Zhang, Shu-shi [1 ]
Wang, Zhen -yang [1 ]
Hu, Peng [2 ]
Rao, Jia-ting [2 ]
Zong, Yan-bing [1 ]
Pang, Jing [1 ]
机构
[1] Univ Sci & Technol Beijing, Sch Met & Ecol Engn, Beijing 100083, Peoples R China
[2] State Key Lab Comprehens Utilizat Vanadium & Titan, Panzhihua 617000, Peoples R China
基金
中国博士后科学基金;
关键词
vanadium-titanium magnetite; HIsmelt; distribution behavior; efficient recycling; viscosity; BLAST-FURNACE; VANADIUM; SLAG; REDUCTION; VISCOSITY; PHASE; IRON; STRENGTH;
D O I
10.1016/S1003-6326(23)66374-5
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The effect of temperature and composition on the distribution behavior of V, Ti and Si in HIsmelt smelting vanadium-titanium magnetite was investigated, and the feasibility of HIsmelt smelting vanadium-titanium magnetite with natural basicity was evaluated. The thermodynamic calculations showed that higher FeO content and basicity, and lower C content and temperature are favorable for improving vanadium and titanium distribution ratio. However, reducing basicity and FeO content benefits the recovery of vanadium and titanium resources in hot metal and slag. It is proposed that in the HIsmelt smelting vanadium and titanium magnetite, the basicity is kept between 1.1 and 1.2, and the temperature is in the range of 1400-1450 celcius. The experimental results indicate that there are difficulties in HIsmelt smelting vanadium-titanium magnetite with natural basicity.
引用
收藏
页码:3835 / 3846
页数:12
相关论文
共 50 条
  • [41] The room temperature growth of Ti on sputter-cleaned Si(100): Composition and nanostructure of the interface
    Arranz, A
    Palacio, C
    SURFACE SCIENCE, 2005, 588 (1-3) : 92 - 100
  • [42] INFLUENCE OF SPUTTERING TEMPERATURE ON THE MIGRATION RESISTANCE OF SPUTTERED AL-SI AND AL-SI-TI METALLIZATION
    SCHLEMM, A
    STOCKINGER, H
    FELLINGER, J
    KOCH, D
    JAHNEL, F
    SIEMENS FORSCHUNGS-UND ENTWICKLUNGSBERICHTE-SIEMENS RESEARCH AND DEVELOPMENT REPORTS, 1985, 14 (05): : 255 - 261
  • [43] HIGH-TEMPERATURE DEFORMATION OF MODIFIED V-TI-CR-SI TYPE ALLOYS
    SATOU, M
    ABE, K
    KAYANO, H
    JOURNAL OF NUCLEAR MATERIALS, 1991, 179 : 757 - 761
  • [44] Influence of alloy composition and temperature on corrosion behavior of ODS ferritic steels
    Lee, J. H.
    Kasada, R.
    Kimura, A.
    Okuda, T.
    Inoue, M.
    Ukai, S.
    Ohnuki, S.
    Fujisawa, T.
    Abe, F.
    JOURNAL OF NUCLEAR MATERIALS, 2011, 417 (1-3) : 1225 - 1228
  • [45] Influence of composition and structural properties in the tribological behaviour of magnetron sputtered Ti-Si-C nanostructured thin films, prepared at low temperature
    Munteanu, D.
    Ionescu, C.
    Olteanu, C.
    Munteanu, A.
    Davin, F.
    Cunha, L.
    Moura, C.
    Vaz, F.
    WEAR, 2010, 268 (3-4) : 552 - 557
  • [47] Fretting fatigue behavior of Ti-6Al-4V at elevated temperature
    Jin, O
    Mall, S
    Sahan, O
    INTERNATIONAL JOURNAL OF FATIGUE, 2005, 27 (04) : 395 - 401
  • [48] Room Temperature Creep Behavior of Ti-6Al-4V Alloy
    Xi G.
    Qiu J.
    Lei J.
    Ma Y.
    Yang R.
    Cailiao Yanjiu Xuebao/Chinese Journal of Materials Research, 2021, 35 (12): : 881 - 892
  • [49] Thermodynamic modeling of the Ti–Al–V system over the entire composition and a wide temperature range
    Li, Kuizhang
    Fan, Guodong
    Zheng, Weisen
    Wang, Jingya
    Calphad: Computer Coupling of Phase Diagrams and Thermochemistry, 2024, 85
  • [50] A thermodynamic description of the C-Ti-V system over the whole composition and temperature ranges
    Zhang, Weibin
    Peng, Yingbiao
    Du, Yong
    Chen, Li
    Li, Yiwei
    Wang, Shequan
    Wen, Guanghua
    Xie, Wen
    INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS, 2015, 48 : 346 - 354