Laboratory Study of Geotextiles Performance on Reinforced Sandy Soil

被引:0
|
作者
Brahim Abdelkader [1 ]
Arab Ahmed [1 ]
Belkhatir Mostéfa [1 ]
Shahrour Isam [2 ]
机构
[1] Laboratory of Materials Sciences and Environment Civil Engineering Department,Hassiba Ben Bouali University of Chlef
[2] Laboratory of Civil Engineering and Geo-Environment (LGCGE),University of Lille 1
关键词
sand; triaxial; geotextile; drained; method of preparation; strength;
D O I
暂无
中图分类号
TU531.7 [建筑用织物(土工织物)];
学科分类号
0805 ; 080502 ; 081304 ;
摘要
This paper presents the results of triaxial tests conducted for the investigation of the influence of geotextiles on stress-strain and volumetric change behaviour of reinforced sandy soil. Tests were carried out on loose sandy soil. The experimental program includes drained compression tests on samples reinforced with different values of both geotextiles layers(Ng) and confining pressure(σ′c). Two methods of preparation were used: air pluviation(AP) and moist tamping(MT). Test results show that the geotextiles induce a quasi-linear increase in the stress deviator(q) and volume contraction in the reinforced sand. Method of preparation significantly affects the shear strength; samples prepared by the air pluviation method and mobilized deviator stresses are significantly higher than those prepared by moist tamping method. Geotextiles restrict the dilation of reinforced sandy soil and consequently the contraction increases. The mobilized friction angle increases with increasing number of layers and decreases with increasing initial confining pressure. Samples prepared by moist tamping present mobilized friction angles significantly lower than those prepared by air pluviation method. For samples prepared by the air pluviation method, the secant modulus at ε1=1% and 5% decreases with increasing geotextile layers; those prepared by the moist tamping method, secant modulus at ε1=1% and 5% increases with increasing number of geotextile layer sand confining pressure. From 10% axial strain, secant modulus increases with increasing inclusions of geotextile layers.
引用
收藏
页码:1060 / 1070
页数:11
相关论文
共 50 条
  • [31] Laboratory Study on Reinforced Expansive Soil with Granular Pile Anchors
    Abbas, H. O.
    INTERNATIONAL JOURNAL OF ENGINEERING, 2020, 33 (07): : 1167 - 1172
  • [32] Study on grassroots-reinforced soil by laboratory triaxial test
    Chen Chang-fu
    Liu Huai-xing
    Li Ya-ping
    ROCK AND SOIL MECHANICS, 2007, 28 (10) : 2041 - 2045
  • [33] Study on grassroots-reinforced soil by laboratory triaxial test
    Institute of Geotechnical Engineering, Hunan University, Changsha 410082, China
    Rock Soil Mech, 2007, 10 (2041-2045):
  • [34] Predicting the Allowable Settlement of Reinforced Soil Foundations: A Laboratory Study
    Venkatesh Buragadda
    Eswara Reddy Orekanti
    Geotechnical and Geological Engineering, 2024, 42 : 2271 - 2291
  • [35] A study on the deformation behavior of laboratory geosynthetics reinforced soil walls
    Won, M. S.
    Kim, Y. S.
    Lee, K. J.
    GEOSYNTHETICS IN CIVIL AND ENVIRONMENTAL ENGINEERING, 2008, : 291 - +
  • [36] A Laboratory Study on the Performance of Geosynthetic Reinforced Asphalt Overlays
    Obando-Ante J.
    Palmeira E.M.
    International Journal of Geosynthetics and Ground Engineering, 2015, 1 (1)
  • [37] Behavior of Pyramidal Shell Foundations on Reinforced Sandy Soil
    Sawsan, Hassan A.
    Madhat, Al-Soud S.
    Shahad, Mohammed A.
    GEOTECHNICAL AND GEOLOGICAL ENGINEERING, 2019, 37 (04) : 2437 - 2452
  • [38] Behavior of Pyramidal Shell Foundations on Reinforced Sandy Soil
    Sawsan A. Hassan
    Madhat S. Al-Soud
    Shahad A. Mohammed
    Geotechnical and Geological Engineering, 2019, 37 : 2437 - 2452
  • [39] Theory and experiment on bearing capacity of reinforced sandy soil
    Key Structure Engineering Lab., School of Civil Engineering and Architecture, Chongqing Jiaotong University, Chongqing 400074, China
    不详
    Yantu Gongcheng Xuebao, 2008, 1 (123-127):
  • [40] LABORATORY FOOTING TEST ON PARTIALLY SATURATED SANDY SOIL
    Nyuin, J. D.
    Noor, M. J. Md
    Ashaari, Y.
    Petrus, C.
    Albar, A.
    JURNAL TEKNOLOGI, 2016, 78 (5-5): : 57 - 61