Effect of Mg Addition on Nucleation of Intra-granular Acicular Ferrite in Al-killed Low Carbon Steel

被引:1
|
作者
Xiao-bing LI [1 ]
Yi MIN [1 ]
Zhe YU [1 ]
Cheng-jun LIU [1 ]
Mao-fa JIANG [1 ]
机构
[1] Key Laboratory for Ecological Metallurgy of Multimetallic Mineral(Ministry of Education) ,Northeastern University
基金
中国国家自然科学基金;
关键词
low carbon steel; inclusion; magnesium; intra-granular acicular ferrite; Mn-depletion zone;
D O I
暂无
中图分类号
TF769.4 [钢液真空处理];
学科分类号
080602 ;
摘要
To verify the formation behaviors and mechanisms of intra-granular acicular ferrite( IAF) grains nucleated by Mg-Al-O in low carbon steel,the steels containing different Mg contents were refined in a vacuum induction furnace. The effect of Mg addition on the formation of IAF structure in Al-killed low carbon steel was investigated by optical microscope( OM) and scanning electron microscope with energy dispersive X-ray spectroscope( SEM-EDX). It reveals that the IAFs are only detected in Mg-added steels,and the volume fraction of IAF increases with the Mg concentration from 8 × 10;to 26 × 10;. It shows that not only the MgO-Al;O;-MnS and MgO-Al;O;-P;O;particles are the effective nucleation sites for IAF,but also the pure MgO·Al;O;phase can promote the ferrite nucleation. A Mn-depletion zone( MDZ) is characterized adjacent to the MgO-Al;O;-MnS,which is believed to be one of the possible mechanisms to explain the IAF nucleation. The MDZ around the MgO-Al;O;-MnS inclusion would be induced by the Mn S precipitation on the inclusion. It seems that the ability of Mg-containing inclusions to induce the nucleation of ferrite might be attributed to a new mechanism,i. e.,the Prich zone formed on a few Mg-Al-O inclusions might be another factor for promoting the IAF formation.
引用
收藏
页码:415 / 421
页数:7
相关论文
共 50 条
  • [31] Effect of acicular ferrite on banded structures in low-carbon microalloyed steel
    Shi, Lei
    Yan, Ze-sheng
    Liu, Yong-chang
    Yang, Xu
    Zhang, Cheng
    Li, Hui-jun
    INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS, 2014, 21 (12) : 1167 - 1174
  • [32] Effect of acicular ferrite on banded structures in low-carbon microalloyed steel
    Lei Shi
    Ze-sheng Yan
    Yong-chang Liu
    Xu Yang
    Cheng Zhang
    Hui-jun Li
    International Journal of Minerals,Metallurgy and Materials, 2014, 21 (12) : 1167 - 1174
  • [33] Effect of acicular ferrite on banded structures in low-carbon microalloyed steel
    Lei Shi
    Ze-sheng Yan
    Yong-chang Liu
    Xu Yang
    Cheng Zhang
    Hui-jun Li
    International Journal of Minerals, Metallurgy, and Materials, 2014, 21 : 1167 - 1174
  • [34] Investigation on non-metallic inclusions in low carbon Al-killed steel in CSP process
    Wei, Jun
    Zhao, Guoyan
    Cai, Kaike
    Zhou, Yingchao
    Lu, Jianquan
    Gao, Yongping
    Kang T'ieh/Iron and Steel (Peking), 2004, 39 (SUPPL.): : 568 - 572
  • [35] Nozzle clogging behaviour of Ti-bearing Al-killed ultra low carbon steel
    Basu, S
    Choudhary, SK
    Girase, NU
    ISIJ INTERNATIONAL, 2004, 44 (10) : 1653 - 1660
  • [36] Evaluation of low carbon Al-killed/Cr-stabilized steel to be used in the automobile industry
    Mendoza, R
    Alanis, M
    Aramburo, G
    Serrania, F
    Juárez-Islas, JA
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2004, 368 (1-2): : 249 - 254
  • [37] Softening mechanism of low-carbon Al-killed steel strip produced by TSCR route
    Engineering and Research Center for Continuous Casting Technology, Central Iron and Steel Research Institute, Beijing 100081, China
    Kang T'ieh, 2006, 4 (66-70):
  • [38] Effect of Ca on the evolution of inclusions and the formation of acicular ferrite in Ti-Mg killed EH36 steel
    Liu, Zhen
    Song, Bo
    Mao, Jinghong
    IRONMAKING & STEELMAKING, 2021, 48 (09) : 1115 - 1122
  • [39] Effect of Temper Rolling on Tensile Properties of Low-Si Al-Killed Sheet Steel
    MA Qing-long1
    2. ColdStrip Factory of Lingyuan Iron and Steel Group Co Ltd
    Journal of Iron and Steel Research(International), 2009, 16 (03) : 64 - 67
  • [40] Effect of Temper Rolling on Tensile Properties of Low-Si Al-Killed Sheet Steel
    Ma Qing-long
    Wang Dong-cheng
    Liu Hong-min
    Lu Hai-ming
    JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL, 2009, 16 (03) : 64 - 67