Comparing Different Montages of Transcranial Direct Current Stimulation in Treating Treatment-Resistant Obsessive Compulsive Disorder: A Randomized, Single-Blind Clinical Trial

Background: Transcranial direct current stimulation (tDCS) is a non-invasive brain stimulation for treatment-resistant obsessive compulsive disorder (OCD). We aim to compare the treatment outcomes of a newly developed dual-site cathodal tDCS method over the orbitofrontal cortex (OFC) and pre-supplementary motor area (pre-SMA) and two previously reported montages (cerebellum-OFC and pre-SMA) in patients with treatment-resistant OCD. Methods: Eighteen OCD patients were randomly assigned to receive twice-daily 2 mA/20 min sessions for 10 consecutive weekdays, with the active cathode placed on the cerebellum-OFC, bilateral pre-SMA, or OFC-pre-SMA tDCS. The primary outcome was the change in the Yale-Brown Obsessive Compulsive Scale (Y-BOCS). The resting electroencephalogram (EEG) was recorded to obtain the default mode network (DMN) via low-resolution electromagnetic tomography. Each patient received one-week and one-month follow-ups after two weeks of stimulation. Results: At the end of the stimulation, the Y-BOCS scores in the cerebellum-OFC, pre-SMA, and OFC-pre-SMA tDCS groups (n = 6 in each group) were decreased by 14.15 +/- 13.31, 7.4 +/- 9.59, and 20.75 +/- 8.70%, respectively, but no significant differences were found among the groups. In the OFC-pre-SMA tDCS group, OC symptoms significantly decreased by a mean of -20.75% immediately after the 20th tDCS session, and the improvement remained at 1 week and 1 month after tDCS. EEG source functional connectivity analyses revealed increased functional connectivity within the frontal network after OFC-pre-SMA tDCS, whereas decreased functional connectivity within the DMN was observed after cerebellum-OFC tDCS. Conclusions: Dual-site cathodal tDCS over the OFC and pre-SMA might be considered a potential montage to treat patients with treatment-resistant OCD. Future studies using randomized sham-controlled designs are needed.