Numerical Simulation of Gas-Liquid-Solid Three-Phase Erosion in a Gas Storage Tank Tee

被引:0
|
作者
Ren, Zongxiao [1 ]
Zhang, Chenyu [1 ]
Fan, Zhaoyang [1 ]
Ren, Yanfei [1 ]
机构
[1] Xian Shiyou Univ, Coll Petr Engn, Xian 710065, Peoples R China
基金
中国国家自然科学基金;
关键词
gas storage; salt; tee; gas-liquid-solid three-phase; erosion; PLUGGED TEES;
D O I
10.3390/lubricants13010039
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The objective is to address the issue of gas-carrying particles generated by erosion wear problems in the transportation process of gas storage reservoir pipelines. In accordance with the principles of the multiphase flow theory, the particle discrete phase model, high temperature, high pressure, water volume fraction, and other pertinent factors, this paper presents a three-phase gas-liquid-solid erosion mathematical model of a three-way gas storage reservoir. The effects of temperature, pressure, water content volume fraction, gas extraction, particle mass flow rate, and particle size on the tee's erosion location and erosion rate were investigated based on this model. The findings indicate that, as the pressure and temperature decline, the maximum erosion rate of the tee exhibits a decreasing trend. Gas storage reservoir water production is relatively low, and its maximum erosion rate of the tee exerts a negligible influence. Conversely, the maximum erosion rate of the tee is significantly influenced by the gas extraction rate, exhibiting an exponential relationship with the maximum erosion rate and the rate of gas extraction. It was observed that, when the volume of gas extracted exceeded 70 x 104 m3/d, the maximum erosion rate of the tee exceeded the critical erosion rate of 0.076 mm/a. The maximum erosion rate of the tee caused by the sand mass flow rate remained relatively constant. However, the maximum erosion rate of the tee exhibited a linear correlation with the salt mass flow rate and the maximum erosion rate. The maximum erosion rate of the tee is greater than the critical erosion rate of 0.076 mm/a when the gas extraction volume is greater than 37.3 x 104 m3/d and the salt mass flow rate is greater than approximately 25 kg/d. As the sand and salt particle sizes increase, the maximum erosion rate of the tee initially rises, then declines, and finally stabilizes. The findings of this study offer valuable insights into the mechanisms governing tee erosion under elevated temperatures and pressures within storage reservoirs.
引用
收藏
页数:19
相关论文
共 50 条
  • [31] Modeling and simulation of gas-liquid-solid three-phase flow in under-balanced drilling operation
    Ghobadpouri, Saeed
    Hajidavalloo, Ebrahim
    Noghrehabadi, Amin Reza
    JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING, 2017, 156 : 348 - 355
  • [32] Gas entrainment and holdup characteristics in a modified gas-liquid-solid down flow three-phase contactor
    Sivaiah, Mekala
    Parmar, Rajeev
    Majumder, Subrata Kumar
    POWDER TECHNOLOGY, 2012, 217 : 451 - 461
  • [33] Numerical Simulation of Gas-Solid Two-Phase Erosion for Elbow and Tee Pipe in Gas Field
    Hong, Bingyuan
    Li, Yanbo
    Li, Xiaoping
    Ji, Shuaipeng
    Yu, Yafeng
    Fan, Di
    Qian, Yating
    Guo, Jian
    Gong, Jing
    ENERGIES, 2021, 14 (20)
  • [34] Study on the Characteristics of Gas-Liquid-Solid Three-Phase Unstable Flow in the Aeration Tank Driven by the Inverted Umbrella Aerator
    Liu, Tianwang
    Dong, Liang
    Guo, Jinnan
    Liu, Houlin
    Dai, Cui
    IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING, 2024, 48 (03) : 935 - 955
  • [35] Numerical analysis of gas-liquid-solid erosion characteristics of the oil and gas multiphase pump
    Li, Zhiqin
    Wei, Xiuting
    Yi, Zuyao
    Ma, Ze
    Yu, Yuelong
    Wang, Wenying
    ENGINEERING FAILURE ANALYSIS, 2024, 157
  • [36] CFD SIMULATION OF THREE PHASE GAS-LIQUID-SOLID FLOW IN HORIZONTAL PIPES
    Sultan, Rasel A.
    Rahman, Mohammad Aziz
    Zendehboudi, Sohrab
    Kelessidis, Vassilios C.
    PROCEEDINGS OF THE ASME FLUIDS ENGINEERING DIVISION SUMMER MEETING, 2017, VOL 1C, 2017,
  • [37] Simulation of Gas-Liquid-Solid Three-Phase Flow Process and Particle Removal Characteristics in Liquid Chamber of Scrubbing Tower
    Sun, Y.
    Jiang, J.
    Li, J.
    Jiang, B.
    Zhang, L.
    He, D.
    Kang, Q.
    Yang, N.
    Tantai, X.
    Xiao, X.
    JOURNAL OF ENGINEERING THERMOPHYSICS, 2020, 29 (03) : 477 - 491
  • [38] Simulation of Gas-Liquid-Solid Three-Phase Flow Process and Particle Removal Characteristics in Liquid Chamber of Scrubbing Tower
    Y. Sun
    J. Jiang
    J. Li
    B. Jiang
    L. Zhang
    D. He
    Q. Kang
    N. Yang
    X. Tantai
    X. Xiao
    Journal of Engineering Thermophysics, 2020, 29 : 477 - 491
  • [39] Dispersion Characteristics of Liquid in a Modified Gas-Liquid-Solid Three-Phase Downflow Bubble Column
    Sivaiah, Mekala
    Majumder, Subrata Kumar
    PARTICULATE SCIENCE AND TECHNOLOGY, 2013, 31 (03) : 210 - 220
  • [40] DEVELOPMENT AND ELABORATION OF NUMERICAL METHOD TO SIMULATE GAS-LIQUID-SOLID THREE-PHASE FLOWS BASED ON MPS METHOD
    Takahashi, Ryohei
    Yamamoto, Makoto
    PROCEEDINGS OF THE ASME/JSME/KSME JOINT FLUIDS ENGINEERING CONFERENCE, 2015, VOL 1A, SYMPOSIA, PT 2, 2016,