Partial Load Analysis of Turbo Electric Propelling Fans Using Superconducting Motors

被引：0

作者：

Terao, Yutaka ^{[1
]}

Ishida, Yusuke ^{[1
]}

Ohsaki, Hiroyuki ^{[1
]}

Okai, Keiichi ^{[2
]}

Taguchi, Hideyuki ^{[2
]}

机构：

[1] Univ Tokyo, Dept Adv Energy, Kashiwa, Chiba 2778561, Japan

[2] Japan Aerosp Explorat Agcy JAXA, Aeronaut Technol Directorate, Chofu, Tokyo 1828522, Japan

来源：

AIAA PROPULSION AND ENERGY 2021 FORUM | 2021年

关键词：

D O I：

暂无

中图分类号：

V [航空、航天];

学科分类号：

08 ; 0825 ;

摘要：

This paper deals with the partial load analysis of the aircraft propulsion systems using two kinds of superconducting motors designed considering both the rolling take-off (RTO) and the aerodynamic design point (ADP). Combined analysis using superconducting motor design and fan design was carried out for employing partial superconducting motors (PSCMs) and fully superconducting motors (FSCMs). The analysis results show that over 16 kW/kg output density is available with employing the FSCMs under less 10 fans and over 1.45 fan pressure ratio; And that the propulsion systems using PSCMs also have potential to reach around 15 kW/kg under limited system conditions. Moreover, it was found that the SCMs can fly with the efficiency of almost 97-98% not only on the ground but also at an altitude of 30,000 ft.

引用

页数：12

共 50 条

[41] Fault detection and diagnosis using vibration signal analysis in frequency domain for electric motors considering different real fault types
Ribeiro Junior, Ronny Francis
Areias, Isac Antonio dos Santos
Gomes, Guilherme Ferreira
SENSOR REVIEW, 2021, 41 (03) : 311 - 319
[42] Impact of load shedding philosophies on bulk electric system reliability analysis using sequential Monte Carlo simulation
Wangdee, W
Billinton, R
ELECTRIC POWER COMPONENTS AND SYSTEMS, 2006, 34 (03) : 355 - 368
[43] Experimental Analysis and Feasibility Study of 1400 CC Diesel Engine Car Converted Into Hybrid Electric Vehicle by Using BLDC Hub Motors
Gupte, Sudhir
4 INTERNATIONAL CONFERENCE ON ADVANCES IN ENERGY RESEARCH (ICAER 2013), 2014, 54 : 177 - 184
[44] FPGA-Based Broken Bars Detection on Induction Motors Under Different Load Using Motor Current Signature Analysis and Mathematical Morphology
de Jesus Rangel-Magdaleno, Jose
Peregrina-Barreto, Hayde
Manuel Ramirez-Cortes, Juan
Gomez-Gil, Pilar
Morales-Caporal, Roberto
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT, 2014, 63 (05) : 1032 - 1040
[45] Spatiotemporal Load-Analysis Model for Electric Power Distribution Facilities Using Consumer Meter-Reading Data
Shin, Jin-Ho
Yi, Bong-Jae
Kim, Young-Il
Lee, Heon-Gyu
Ryu, Keun Ho
IEEE TRANSACTIONS ON POWER DELIVERY, 2011, 26 (02) : 736 - 743
[46] Electric Load Forecast Using Combined Models with HP Filter-SARIMA and ARMAX Optimized by Regression Analysis Algorithm
Cui Herui
Peng Xu
Mu Yupei
MATHEMATICAL PROBLEMS IN ENGINEERING, 2015, 2015
[47] All-Electric Warship Load Demand Model for Power and Energy System Analysis Using Exogenously Initiated Threats
Stevens, John D.
Opila, Daniel F.
Oh, Eun S.
Zivi, Edwin L.
2017 IEEE ELECTRIC SHIP TECHNOLOGIES SYMPOSIUM (ESTS), 2017, : 486 - 492
[48] Using the Method of Harmonic Distortion Analysis in Partial Discharge Assessment in Mineral Oil in a Non-Uniform Electric Field
Aydogan, Alper
Atalar, Fatih
Ersoy Yilmaz, Aysel
Rozga, Pawel
ENERGIES, 2020, 13 (18)
[49] Non-intrusive load monitoring using low sampling-rate data for electric energy substitution demand analysis
Zhong, Lijun
Zhou, Xiaoqin
Gu, Xihua
Zhou, Ziyu
Sheng, Yinbo
Zheng, Ronghao
Dianli Xitong Baohu yu Kongzhi/Power System Protection and Control, 2021, 49 (17): : 147 - 153
[50] Static Load Simulation Analysis on chassis of Electric Mini Bus Integrated with the Support Frame of Removable Battery Pack by Using FEA
Sukmaji, I. C.
Anwar, M.
Diharjo, K.
Hapid, A.
Kaleg, S.
4TH INTERNATIONAL CONFERENCE ON INDUSTRIAL, MECHANICAL, ELECTRICAL, AND CHEMICAL ENGINEERING, 2019, 2097

← 1 2 3 4 5 →