Effect of nonuniform inlet flow distribution on suction performance of centrifugal pumps (1st report, experimental results)

被引：0

作者：

Tanaka, Sadashi

Mase, Masahiro

Ueyama, Toshiharu

Sudou, Sumio

机构：

来源：

Nippon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B | 1988年 / 54卷 / 503期

关键词：

Cavitation; -; Pumps--Inlets;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

The flow in various types of suction casings of multi-stage centrifugal pumps is investigated experimentally, and is compared with the suction performance. The results show that the symmetrical bend type casing has poor suction performance because of distorted inflows at the impeller inlet section, while better suction performance is obtained from the volute type casing which has fairly good flow distribution. It is clarified that the suction performance is affected by the velocity distortion, especially in the circumferential direction, and the incipient cavitation is related with the local incidence angle of the impeller blade.

引用

页码：1693 / 1697

共 50 条

[21] PULSATILE FLOW IN A 90 degree BRANCHED TUBE. (1ST REPORT, EXPERIMENTAL STUDY ON THE FLOW RATIO AND BRANCHING LOSSES FOR TURBULENT FLOW).
Ikeda, Ryuji
Goto, Fumiaki
Shoji, Yoshitaka
Nippon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B, 1986, 52 (481): : 3166 - 3170
[22] CYCLE PERFORMANCE OF TOTAL FLOW TURBINE SYSTEMS (1st REPORT, UTILIZATION OF SATURATED HOT WATER.
Akagawa, Koji
Fujii, Terushige
Ohta, Junichi
Takagi, Shigeo
Nippon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B, 1986, 52 (480): : 3052 - 3058
[23] In-situ measurement of in-plane temperature distribution in a single-cell polymer electrolyte fuel cell by thermograph (1st Report, effect assessment of gas flow rate at inlet and gas channel pitch of separator on in-plane temperature distribution and power generation performance)
Nishimura A.
Shibuya K.
Morimoto A.
Tanaka S.
Hirota M.
Nakamura Y.
Kojima M.
Narita M.
Nihon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B, 2010, 76 (762): : 342 - 351
[24] EFFECT OF EXTERNAL FACTORS ON PERIODOMORPHOSIS IN A JULID MILLIPEDE CYLINDROIULUS-NITIDUS (VERH) - 1ST EXPERIMENTAL RESULTS
SAHLI, F
COMPTES RENDUS DE L ACADEMIE DES SCIENCES SERIE III-SCIENCES DE LA VIE-LIFE SCIENCES, 1983, 296 (01): : 89 - 91
[25] Combined free and forced convection for laminar pulsating flow in horizontal tube (1st report, axial velocity distribution)
Nippon Kikai Gakkai Ronbunshu B Hen, 582 (388-392):
[26] FLOW STRUCTURE OF ANNULAR-MIST TWO-PHASE FLOW IN TUBE BENDS (1ST REPORT, DISTRIBUTION OF ENTRAINED LIQUID FLOW RATE).
Fujii, Terushige
Akagawa, Koji
Kutsuna, Hiroaki
Yamada, Takuji
Kishimoto, Koji
Memoirs of the Faculty of Engineering, Kobe University, 1982, (29): : 189 - 201
[27] PERFORMANCE OF PELTON-TYPE TURBINE DRIVEN BY GAS-LIQUID TWO-PHASE FLOW - (1ST REPORT, EXPERIMENTAL STUDY OF FUNDAMENTAL CHARACTERISTICS).
Akagawa, Koji
Asano, Yoshihiro
Bulletin of the JSME, 1986, 29 (247): : 106 - 112
[28] FLOW SIMULATION OF FORCED-FLOW BOILING WITH AIR-WATER 2-PHASE FLUIDS - (1ST REPORT, ON DISTRIBUTION OF BUBBLES)
SEKOGUCHI, K
KAWAKAMI, Y
NISHIKAWA, K
BULLETIN OF THE JSME-JAPAN SOCIETY OF MECHANICAL ENGINEERS, 1976, 19 (128): : 187 - 194
[29] Wind turbine blade flow and noise prediction by large-scale LES (1st report, validation with experimental blade flow data)
Fleig, Oliver
Iida, Makoto
Suzuki, Masami
Arakawa, Chuichi
Nihon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B, 2005, 71 (701): : 177 - 183
[30] Investigation for secondary flow and loss generation mechanisms within centrifugal impeller by using rotating curved duct (1st report, influence of rossby number)
Department of Mechanical Engineering, Hosei University, 3-7-2 Kajino-cho, Koganei-shi, Tokyo, 184-8584, Japan
Nihon Kikai Gakkai Ronbunshu, B, 2008, 1 (111-120):

← 1 2 3 4 5 →