Martensites in austenitic stainless steel welded explosively

被引:0
|
作者
Yamashita, Tadayoshi [1 ]
Onzawa, Tadao [2 ]
机构
[1] Department of Physics, National Defense Academy, Yokosuka,239, Japan
[2] Department of Mechanical Engineering for Production, Tokyo Institute of Technology, Tokyo,152, Japan
关键词
Austenitic stainless steel - Electron diffraction - High resolution transmission electron microscopy - Platelets - Welding;
D O I
10.1093/oxfordjournals.jmicro.a050205
中图分类号
学科分类号
摘要
The morphology of induced and a martensites and the concentration of a' martensite in austenitic stainless steel (j-phase) welded explosively have been investigated by means of X-ray difiractometer measurement and transmission electron microscopy, a' martensite is hardly detected in the region near a welded interface. With Increasing distance from the interface the volume percent of a' martensite increases to the greatest value (several %) and then decreases monotonically. Selected area electron diffraction patterns have revealed the existence of*crystals as well as a' crystals in a y matrix. Thin platelets are separated by thin y platelets, and these platelets compose a band. Many parallel bands are distributed in a y crystal and a' crystals are formed by -A and y-a' transformations both inside and outside the bands. In the a' crystals there are dislocations of high density but no deformation twins. © 1980 Oxford University Press. All rights reserved.
引用
收藏
页码:32 / 37
相关论文
共 50 条
  • [21] Comparison of corrosion behavior on laser welded austenitic stainless steel
    Gnanarathinam, A.
    Palanisamy, D.
    Manikandan, N.
    Devaraju, A.
    Arulkirubakaran, D.
    MATERIALS TODAY-PROCEEDINGS, 2021, 39 : 649 - 653
  • [22] Cavitation erosion of martensitic and austenitic stainless steel welded coatings
    Santa, J. F.
    Blanco, J. A.
    Giraldo, J. E.
    Toro, A.
    WEAR, 2011, 271 (9-10) : 1445 - 1453
  • [23] Microstructures in Friction Stir Welded 304 Austenitic Stainless Steel
    H. Kokawa
    S. H. C. Park
    Y. S. Sato
    K. Okamoto
    S. Hirano
    M. Inagaki
    Welding in the World, 2005, 49 (3-4) : 34 - 40
  • [24] HE-BLISTERS ON WELDED AUSTENITIC STAINLESS-STEEL
    YAMANE, T
    HIRAMATSU, N
    HIRAO, K
    TANABE, T
    IMOTO, S
    ARATA, Y
    JOURNAL OF MATERIALS SCIENCE LETTERS, 1985, 4 (11) : 1359 - 1360
  • [25] Microstructure and phase constitution in the bonding zone of explosively welded tantalum and stainless steel sheets
    Paul, H.
    Miszczyk, M. M.
    Chulist, R.
    Prazmowski, M.
    Morgiel, J.
    Galka, A.
    Faryna, M.
    Brisset, F.
    MATERIALS & DESIGN, 2018, 153 : 177 - 189
  • [26] Microstructure and corrosion resistance of dissimilar welded joints between duplex stainless steel and austenitic stainless steel
    Wang, Shaogang
    Li, Yan
    Zhai, Weiguo
    ADVANCED MATERIALS FOR APPLIED SCIENCE AND TECHNOLOGY II, 2012, 570 : 43 - 51
  • [27] Corrosion properties in friction stir welded 304 austenitic stainless steel
    Park, S.H.C.
    Sato, Y.S.
    Kokawa, H.
    Okamoto, K.
    Hirano, S.
    Inagaki, M.
    Welding Research Abroad, 2006, 52 (04): : 1 - 6
  • [28] Microstructural Heterogeneity and Mechanical Properties of a Welded Joint of an Austenitic Stainless Steel
    Munoz, Jairo Alberto
    Dolgach, Egor
    Tartalini, Vanina
    Risso, Pablo
    Avalos, Martina
    Bolmaro, Raul
    Cabrera, Jose Maria
    METALS, 2023, 13 (02)
  • [29] Corrosion Properties in Friction Stir Welded 304 Austenitic Stainless Steel
    S. H. C. Park
    Y. S. Sato
    H. Kokawa
    K. Okamoto
    S. Hirano
    M. Inagaki
    Welding in the World, 2005, 49 (3-4) : 63 - 68
  • [30] Investigation on the resistance spot-welded austenitic/ferritic stainless steel
    Mohammad Hosein Bina
    Mostafa Jamali
    Morteza Shamanian
    Hamed Sabet
    The International Journal of Advanced Manufacturing Technology, 2014, 75 : 1371 - 1379