Mechanism of alumina-enhanced sintering of fine zirconia powder: Influence of alumina concentration on the initial stage sintering

被引：0

作者：

Matsui, Koji ^{[1
]}

Yamakawa, Takanori ^{[2
]}

Uehara, Masato ^{[2
]}

Enomoto, Naoya ^{[2
]}

Hojo, Junichi ^{[2
,3
]}

机构：

[1] Tokyo Research Laboratory, Tosoh Corporation, Kanagawa 252-1123, Japan

[2] Department of Applied Chemistry, Faculty of Engineering, Kyushu University, Fukuoka 819-0395, Japan

[3] American Ceramic Society

来源：

Journal of the American Ceramic Society | 2008年 / 91卷 / 06期

关键词：

The isothermal shrinkage behavior of 2.9 mol% Y2O 3-doped ZrO2 powders with 0-1 mass% Al2O 3 was investigated to clarify the effect of Al2O 3 concentration on the initial sintering stage. The shrinkage of the powder compact was measured at constant temperatures in the range of 950-1050C. The Al2O3 addition increased the densification rate with increasing temperature. The values of apparent activation energy (nQ) and apparent frequency-factor term (β 0n); where n is the order depending on the diffusion mechanism; were estimated at the initial sintering stage by applying a sintering-rate equation to the isothermal shrinkage data. The diffusion mechanism changed from grain-boundary diffusion (GBD) to volume diffusion (VD) by Al2O3 addition and both nQ and β0n increased with increasing Al2O3 concentration. The kinetic analysis of the sintering mechanism suggested that the increase of densification rate by Al2O3 addition largely depends on the increase of β0n; that is; the increases of n with GBDVD change and β0 with an increase in Al2O3 content; although the nQ also increases with Al2O3 addition. This enhanced sintering mechanism is reasonably interpreted by the segregated dissolution of Al2O 3 at ZrO2 grain boundaries. © 2008 The American Ceramic Society;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Journal article (JA)

引用

页码：1888 / 1897

共 50 条

[41] Influence of magnesia on sintering stress of alumina
Ikegami, Takayasu
Iyi, Nobuo
Sakaguchi, Isao
CERAMICS INTERNATIONAL, 2010, 36 (03) : 1143 - 1146
[42] Optimization sintering of zirconia/alumina functionally graded material
Gasik, MM
Zhang, BS
FUNCTIONALLY GRADED MATERIALS VII, 2003, 423-4 : 183 - 186
[43] Study of the alumina sintering process with a low zirconia content
Orlovska, M.
Hulek, L.
Baca, L.
Kovar, V
Tomanova, K.
Kitzmantel, M.
Janek, M.
Neubauer, E.
CERAMICS INTERNATIONAL, 2022, 48 (02) : 2736 - 2743
[44] OBSERVATIONS CONCERNING THE INITIAL SINTERING OF ALUMINA.
APPADOO, G.J.J.
FRYER, G.M.
1982, V 81 (N 4): : 116 - 118
[45] SINTERING OF SOL SPRAYED ALUMINA-ZIRCONIA COMPOSITES
BALAGOPAL, N
KUMAR, CS
DAMODARAN, AD
WARRIER, KGK
KRISHNAN, KS
JOURNAL OF MATERIALS SCIENCE LETTERS, 1994, 13 (11) : 784 - 786
[46] Sintering and fracture toughness of alumina-zirconia composites
Biswas, NC
Chaudhuri, SP
INDIAN JOURNAL OF ENGINEERING AND MATERIALS SCIENCES, 1998, 5 (05) : 307 - 311
[47] Colloidal Processing and Sintering of Alumina and Zirconia Fine Particles Using New Microbial Dispersant
Sakka Y.
Matsumoto T.
Moriyoshi Y.
Funtai Oyobi Fummatsu Yakin/Journal of the Japan Society of Powder and Powder Metallurgy, 2023, 70 (02): : 112 - 115
[48] Effect of alumina added by mechanical mixing and co-doping on the densification mechanisms of zirconia nanoparticles at the initial stage of sintering
Danilenko, I.
Lakusta, M.
Loladze, L.
Volkova, G.
Popov, I.
Glazunova, V.
Konstantinova, T.
RESULTS IN PHYSICS, 2020, 19
[49] Hybrid microwave sintering of Zirconia Toughened Alumina in a multimode cavity - Influence of the content of 3 mol% yttria stabilized zirconia and sintering configurations
Khalile, Nouhaila
Petit, Clemence
Meunier, Christophe
Valdivieso, Francois
OPEN CERAMICS, 2023, 14
[50] Sintering behavior of sol-gel-derived alumina and alumina-zirconia minispheres
Chandradass, J.
Balasubramanian, M.
MATERIALS AND MANUFACTURING PROCESSES, 2006, 21 (08) : 804 - 809

← 1 2 3 4 5 →