Fabrication and characteristics of alumina-iron functionally graded materials

被引：0
|
作者：
He, Zeming [1 ]
Ma, J. [2 ]
Tan, G.E.B. [3 ]
机构：
[1] Fuel Cells and Solid State Chemistry Division, Risø National Laboratory for Sustainable Energy, Technical University of Denmark (DTU), Frederiksborgvej 399, DK-4000 Roskilde, Denmark
[2] School of Materials Science and Engineering, Nanyang Technological University (NTU), Nanyang Avenue, Singapore, 639798, Singapore
[3] DSO National Laboratories, 20 Science Park Drive, Singapore, 118230, Singapore
来源：
Journal of Alloys and Compounds | 2009年 / 486卷 / 1-2期
关键词：
In the present work; five-layered alumina-iron functionally graded materials (FGMs) were fabricated via a simple route of die pressing and pressureless sintering. The shrinkage differences among the layers in the FGM were minimized by particle size selection and processing control. The microstructure and the composition of the prepared component were studied; and its flexural strength; fracture toughness; and fracture energy were tested and evaluated. The relative density and the Vickers hardness of each layer in the graded material were also measured. The correlation between microstructure and composition and mechanical properties was discussed. Flat; crack-free; and relatively high-density gradient components were obtained from this work. Compared to monolithic alumina ceramic; the remarkable improvement on fracture toughness and fracture energy of the investigated graded material system was achieved due to the toughening effect of iron and the crack deflection at the weak interfaces. This work provides a cost-effective manner to fabricate ceramic-metal gradient composites for armor applications. © 2009 Elsevier B.V. All rights reserved;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
Journal article (JA)
引用
收藏
页码：815 / 818
相关论文
共 50 条
  • [21] On fabrication of functionally graded thermoelectric materials by spark plasma sintering
    Bulat, L. P.
    Drabkin, I. A.
    Novotel'nova, A. V.
    Osvenskii, V. B.
    Parkhomenko, Yu N.
    Pshenai-Severin, D. A.
    Sorokin, A. I.
    Nefedova, I. A.
    TECHNICAL PHYSICS LETTERS, 2014, 40 (11) : 972 - 975
  • [22] On fabrication of functionally graded thermoelectric materials by spark plasma sintering
    L. P. Bulat
    I. A. Drabkin
    A. V. Novotel’nova
    V. B. Osvenskii
    Yu. N. Parkhomenko
    D. A. Pshenai-Severin
    A. I. Sorokin
    I. A. Nefedova
    Technical Physics Letters, 2014, 40 : 972 - 975
  • [23] Fabrication of short-Cf/SiC functionally graded materials
    Li, R
    Shen, Q
    Zhang, LM
    FUNCTIONALLY GRADED MATERIALS VII, 2003, 423-4 : 253 - 256
  • [24] Theoretical design of sedimentation applied to the fabrication of functionally graded materials
    Yang, ZM
    Zhang, LM
    Shen, Q
    Gong, DR
    METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE, 2003, 34 (05): : 605 - 609
  • [25] Theoretical design of sedimentation applied to the fabrication of functionally graded materials
    Zhongmin Yang
    Lianmeng Zhang
    Qiang Shen
    Daoren Gong
    Metallurgical and Materials Transactions B, 2003, 34 : 605 - 609
  • [26] Freeze-form extrusion fabrication of functionally graded materials
    Leu, Ming C.
    Deuser, Bradley K.
    Tang, Lie
    Landers, Robert G.
    Hilmas, Gregory E.
    Watts, Jeremy L.
    CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2012, 61 (01) : 223 - 226
  • [27] FEA-based design and fabrication of functionally graded materials
    Shin, Ki-Hoon
    Cheong, Seong-Kyun
    EXPERIMENTAL MECHANICS IN NANO AND BIOTECHNOLOGY, PTS 1 AND 2, 2006, 326-328 : 1681 - +
  • [28] Fabrication of tungsten/iron functionally graded materials by resistance sintering under ultra-high pressure
    Qu, Dan-Dan
    Zhou, Zhang-Jian
    Tan, Jun
    Beijing Keji Daxue Xuebao/Journal of University of Science and Technology Beijing, 2011, 33 (07): : 852 - 855
  • [29] Glass-alumina functionally graded materials produced by plasma spraying
    Cannillo, V.
    Lusvarghi, L.
    Manfredini, T.
    Montorsi, M.
    Siligardi, C.
    Sola, A.
    LAYERED, FUNCTIONAL GRADIENT CERAMICS, AND THERMAL BARRIER COATINGS: DESIGN, FABRICATION AND APPLICATIONS, 2007, 333 : 227 - +
  • [30] Two-Step Sintering of Alumina/Zirconia Functionally Graded Materials
    Arantes, V. L.
    Neto, A. L. P.
    Silveira, S.
    PRAKTISCHE METALLOGRAPHIE-PRACTICAL METALLOGRAPHY, 2018, 55 (05): : 303 - 318
12345