Preparation by melt mixing and characterization of isotactic polypropylene/SiO2 nanocomposites containing untreated and surface-treated nanoparticles

被引：1

作者：

Bikiaris, Dimitris N. ^{[1
]}

Papageorgiou, George Z. ^{[1
]}

Pavlidou, Eleni ^{[2
]}

Vouroutzis, Nikolaos ^{[2
]}

Palatzoglou, Paraskevas ^{[3
]}

Karayannidis, George P. ^{[1
]}

机构：

[1] Laboratory of Organic Chemical Technology, Department of Chemistry, Aristotle University of Thessaloniki, 541 24 Thessnloniki, Macedonia, Greece

[2] Department of Physics, Aristotle University of Thessaloniki, 541 24 Thessaloniki, Macedonia, Greece

[3] Karina ABEE Plastics Industry, New Santa Kilkis, 545 00 Kilkis, Macedonia, Greece

来源：

Journal of Applied Polymer Science | 2006年 / 100卷 / 04期

关键词：

In the present study two series of isotactic polypropylene (iPP)/SiO 2 nanocomposites containing 1; 2.5; 5; 7.5; and 10 wt % SiO 2 nanoparticles were prepared by melt-mixing on a twin-screw corotating extruder. In the first series untreated fumed silica nanoparticles were used; whereas in the second nanoparticles were surface-treated with dimethyldichlorosilane. In both cases; the average size of the primary nanoparticles was 12 nm. Tensile and impact strength were found to increase and to be affected mainly by the type and content of silica nanoparticles. A maximum was observed; corresponding to samples containing 2.5 wt % SiO2. These findings are discussed in light of the SEM and TEM observations. By increasing the amount of nanoparticles; large aggregates of fumed silica could be formed; which may explain the reduction of mechanical properties with higher concentrations of SiO2. However; it was found that surface-treated nanoparticles produced larger aggregates than did those derived from untreated nanoparticles; despite the increased adhesion of the iPP matrix; as was postulated from yield strength. This behavior negatively affected mechanical properties. In addition; an effort was made to determine if toughening theories; mainly the critical interparticle distance for rubber toughening or composites; also might be applicable in nanocomposites. From DSC measurements it was demonstrated that silica nanoparticles acted as effective nucleating agents; increasing the crystallization rate and the degree of crystallinity of iPP. © 2006 Wiley Periodicals; Inc;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Journal article (JA)

引用

页码：2684 / 2696

共 50 条

[31] Preparation and Characterization of Functionalized SiO2 Nanoparticles with Cross linking Structure
Li, Minghua
Zou, Ziqiang
Ding, Ming
Tian, Changan
Zhang, Yunran
Wang, Xin
ASIAN JOURNAL OF CHEMISTRY, 2014, 26 (06) : 1797 - 1799
[32] Preparation of TiO2 nanoparticles on the surface of SiO2 in binary liquids
Jiang, X
Wang, T
Wang, YW
COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2004, 234 (1-3) : 9 - 15
[33] Overall thermal conductivity of unidirectional hybrid polymer nanocomposites containing SiO2 nanoparticles
M. J. Mahmoodi
M. K. Hassanzadeh-Aghdam
R. Ansari
International Journal of Mechanics and Materials in Design, 2019, 15 : 539 - 554
[34] Overall thermal conductivity of unidirectional hybrid polymer nanocomposites containing SiO2 nanoparticles
Mahmoodi, M. J.
Hassanzadeh-Aghdam, M. K.
Ansari, R.
INTERNATIONAL JOURNAL OF MECHANICS AND MATERIALS IN DESIGN, 2019, 15 (03) : 539 - 554
[35] Preparation and characterization of ZnO nanoparticles coated and modified by SiO2 and SiO2/Al2O3
Xue, Tao
Nie, Deng-Pan
Zeng, Shu
Huaxue Gongcheng/Chemical Engineering (China), 2007, 35 (11): : 46 - 49
[36] The investigation of the friction and wear properties of surface-treated carbon fiber/SiO2 reinforced PMMA composites
Cai Chilan
Zhu Jin
SURFACE AND INTERFACE ANALYSIS, 2018, 50 (02) : 133 - 137
[37] Preparation and Characterization of Hybrid Nanocomposites Containing Polyethylene Oxide Segments and SiO2 Through a Dual-curing Process
Li, Zhenjiang
Wang, Ning
Liang, Wei
Liu, Tianshi
Zhang, Lin
JOURNAL OF MACROMOLECULAR SCIENCE PART B-PHYSICS, 2013, 52 (11): : 1508 - 1520
[38] Compatibilisation effect of PP-g-MA copolymer on iPP/SiO2 nanocomposites prepared by melt mixing
Bikiaris, Dimitrios N.
Vassiliou, Alexandos
Pavlidou, Eleni
Karayannidis, George P.
European Polymer Journal, 2005, 41 (09): : 1965 - 1978
[39] Compatibilisation effect of PP-g-MA copolymer on iPP/SiO2 nanocomposites prepared by melt mixing
Bikiaris, DN
Vassiliou, A
Pavlidou, E
Karayannidis, GP
EUROPEAN POLYMER JOURNAL, 2005, 41 (09) : 1965 - 1978
[40] The surface modification and characterization of SiO2 nanoparticles for higher foam stability
Choi, Mansoo
Choi, Wang-Kyu
Jung, Chong-Hun
Kim, Seon-Byeong
SCIENTIFIC REPORTS, 2020, 10 (01)

← 1 2 3 4 5 →