Numerical Simulation of the Influence of Soluble Salt on Evaporation Characteristics of Desulfurization Wastewater Droplet in High Temperature Flue Gas

被引：0

作者：

Xiong G. ^{[1
]}

Wu H. ^{[1
]}

Li S. ^{[2
]}

Yao Q. ^{[2
]}

机构：

[1] School of Resources Environmental and Chemical Engineering, Nanchang University, Nanchang, 330031, Jiangxi Province

[2] Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Tsinghua University, Haidian, Beijing

来源：

Zhongguo Dianji Gongcheng Xuebao/Proceedings of the Chinese Society of Electrical Engineering | 2020年 / 40卷 / 16期

基金：

中国国家自然科学基金;

关键词：

Desulfurization wastewater; Evaporation in flue gas; Salt content; Salt crust; Salt-containing droplet;

D O I：

10.13334/j.0258-8013.pcsee.200076

中图分类号：

学科分类号：

摘要：

In order to study the influence of soluble salts on the evaporation characteristics of desulfurized wastewater in high temperature flue gas, the theoretical model of pure water droplet evaporation was revised, a theoretical model of Salt-containing droplet evaporation was established, and with different salt content was calculated salt shell formation time, shell formation particle size, salt shell thickness, heat transfer rate, evaporation rate, and complete evaporation time during the evaporation of desulfurization wastewater droplets in high temperature flue gas. The results show that as the salt content of the droplet increases, both the initial shell formation and stable shell formation sizes increase, and the thickness of the salt shell increases. The salt shell layer on the surface of the droplet will increase the temperature of the droplets inside it, as the salt concentration of the droplet increases, and the time required for the droplet to completely evaporate decreases; the larger the particle size of the droplets of the desulfurized wastewater, the thicker the thickness of the salt shell layer formed on the surface. The salt crust formed by crystallization of soluble salt in the desulfurization wastewater, which is beneficial to the heat and mass transfer during evaporation, and can avoid direct contact between the corrosive desulfurization wastewater inside the salt crust and flue surface and related equipment. © 2020 Chin. Soc. for Elec. Eng.

引用

页码：5239 / 5247

页数：8

共 24 条

[21] Sadafi M H, Jahn I, Stilgoe A B, Et al., Theoretical and experimental studies on a solid containing water droplet[J], International Journal of Heat and Mass Transfer, 78, pp. 25-33, (2014)
[22] Sadafi M H, Jahn I, Stilgoe A B, Et al., A theoretical model with experimental verification for heat and mass transfer of saline water droplets[J], International Journal of Heat and Mass Transfer, 81, pp. 1-9, (2015)
[23] Handscomb C S, Kraft M., Simulating the structural evolution of droplets following shell formation, Chemical Engineering Science, 65, 2, pp. 713-725, (2010)
[24] Liu Lu, Wang Mo, Liu Yan, Et al., Heat and mass transfer characteristics of evaporation and salt crystallization process of a saline droplet during depressurization, CIESC Journal, 66, 7, pp. 2426-2432, (2015)

← 1 2 3 →