Effects of the preparation conditions on ethylene/vinyl acetate membrane morphology with the use of scanning electron microscopy

被引：0

作者：

Sadeghi, M. ^{[1
]}

Mousavi, S.A. ^{[2
]}

Hashemi, M. Y. Motamed ^{[2
]}

Chenar, M. Pourafshari ^{[3
]}

Azad, R. Roosta ^{[2
]}

机构：

[1] Chemical Engineering Department, Faculty of Engineering, Tarbiat Modarres University, Tehran, Iran

[2] Department of Chemical and Petroleum Engineering, Sharif University of Technology, Tehran, Iran

[3] Chemical Engineering Department, Faculty of Engineering, Ferdowsi University of Mashhad, Mashhad, Iran

来源：

Journal of Applied Polymer Science | 2007年 / 105卷 / 05期

关键词：

In this research; the effects of preparation conditions; including the coagulation bath temperature; polymer solution composition; preliminary drying time; and thickness of cast polymeric films; on the morphology of ethylene/vinyl acetate copolymer membranes were investigated with scanning electron microscopy and nitrogen gas permeability tests. Flat sheet membranes were prepared through a thermal-wet phase-inversion method. Scanning electron microscopy pictures showed asymmetric structures for some of the membranes. It was also observed that the porosity of the membranes decreased with an increase in the temperature of the coagulation bath and the solvent evaporation period. When the concentration of the polymer solution was increased from 5 to 12 wt %; the nucleation and growth of the solvent-rich phase replaced the nucleation and growth of the polymer-rich phase. With an increase in the thickness of the cast polymeric films; the number of macrovoids increased in the membranes. The nitrogen gas permeability of the developed membranes was in good agreement with the scanning electron microscopy results. © 2007 Wiley Periodicals; Inc;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Journal article (JA)

引用

页码：2683 / 2688

共 50 条

[31] Study on the Morphology and Properties of Metallocene Polyethylene and Ethylene/Vinyl Acetate Blends
Tan, H.-M. (hmtan@bit.edu.cn), 1600, John Wiley and Sons Inc. (91):
[32] Study on the morphology and properties of metallocene polyethylene and ethylene/vinyl acetate blends
Wu, T
Li, Y
Zhang, DL
Liao, SQ
Tan, HM
JOURNAL OF APPLIED POLYMER SCIENCE, 2004, 91 (02) : 905 - 910
[33] The effects of boundary conditions on dopant region imaging in scanning electron microscopy
Ferroni, M.
Merli, P. G.
Morandi, V.
Microscopy of Semiconducting Materials, 2005, 107 : 475 - 478
[34] In situ electron microscopy of Braille microsystems: photo-actuation of ethylene vinyl acetate/carbon nanotube composites
Czanikova, Klaudia
Krupa, Igor
Racko, Dusan
Smatko, Vasilij
Campo, Eva M.
Pavlova, Ewa
Omastova, Maria
MATERIALS RESEARCH EXPRESS, 2015, 2 (02)
[35] Electron-beam irradiation effects on poly(ethylene-co-vinyl acetate) polymer
Kumar, H. G. Harish
Mathad, R. D.
Sarma, K. S. S.
Sanjeev, Ganesh
Haramagatti, C. R.
RADIATION EFFECTS AND DEFECTS IN SOLIDS, 2011, 166 (03): : 198 - 207
[36] Preparation and use of energy-filtered imaging in scanning transmission electron microscopy
Rennekamp, R
Bauer, HD
Suenaga, K
Wetzig, K
EUROPEAN JOURNAL OF CELL BIOLOGY, 1997, 74 : 25 - 25
[37] Scanning electron microscopy assessment of the Descemet membrane interface during DMEK graft preparation
Cabrerizo, Javier
Forshaw, Thomas
Rodriguez-Aierbe, Clara
Garrido-Fierro, Jesus
SCIENTIFIC REPORTS, 2018, 8
[38] Scanning electron microscopy assessment of the Descemet membrane interface during DMEK graft preparation
Javier Cabrerizo
Thomas Forshaw
Clara Rodriguez-Aierbe
Jesus Garrido-Fierro
Scientific Reports, 8
[39] Forensic use of scanning electron microscopy
Ditrich, H
EUROPEAN JOURNAL OF CELL BIOLOGY, 1997, 74 : 68 - 68
[40] Morphology and fracture behaviour of poly(vinyl chloride)/ethylene-vinyl acetate copolymer blends
Liu, Ying
Xie, Bang-Hu
Yang, Wei
Zhang, Wei-qin
Feng, Jian-min
Yang, Ming-Bo
POLYMER TESTING, 2007, 26 (03) : 388 - 395

← 1 2 3 4 5 →