Evaluation Index of Disturbance Superposition Degree in Multi-layer Penetration Acceleration Signal

被引：0
|
作者：
Ma M. [1 ]
Li R. [1 ]
Niu L. [1 ,2 ]
机构：
[1] Xi'an Institute of Electromechanical Information Technology, Xi'an
[2] Science and Technology on Electromechanical Dynamic Control Laboratory, Xi'an
来源：
Binggong Xuebao/Acta Armamentarii | 2022年 / 43卷 / 01期
关键词：
Disturbance signal; Evaluation index; Penetration fuze; Superposition degree;
D O I：
10.3969/j.issn.1000-1093.2022.01.003
中图分类号：
学科分类号：
摘要：
The evaluation indexes of layer and inter-layer coefficients for the signal superposition degree is presented to solve lack of measurement criterion of inter-layer superposition in multi-layer penetration acceleration signal. The test and simulated signals are segmented by penetration layers. The layer and inter-layer coefficients of acceleration signal for each layer are calculated by subtracting every amplitude of signal points by former one and summing the absolute values of difference values. The larger the two sets of evaluation indexes are, the more severer the superposition degree is. The calculated results of test and simulated signals are used to demonstrate the efficiency of evaluation indexes. The calculated results of layer and inter-layer coefficients in 3 sets of data show that the layer and inter-layer coefficients are smaller if the disturbance superposition degree is lower, and vice versa. One set of data is extracted from the calculated results of evaluation indexes of acceleration signal for two detonation control circuits in one penetration warhead, and the calculated deviation is less 5%. The calculated result is consistent to the results of qualitative analysis and spectral analysis. The experimental results show that the layer and inter-layer coefficients are efficient for evaluating the disturbance superposition degree in multi-layer penetration acceleration signal. © 2022, Editorial Board of Acta Armamentarii. All right reserved.
引用
收藏
页码：20 / 28
页数：8
相关论文
共 18 条
  • [11] ZHANG S, WU H J, HUANG F L., Resistance model of rigid projectile penetrating into the reinforced concrete target, Acta Armamentarii, 38, 11, pp. 2081-2092, (2017)
  • [12] MAN X F, ZHANG H, MA S J, Et al., Study of physical simulation experiment of penetration fuze layer-count burst point control, Acta Armamentarii, 35, 10, pp. 1556-1561, (2014)
  • [13] ZHANG D M, GAO S Q, LI S Z., Study on impact transfer characteristics of projectile system during penetration, Journal of Ordnance Equipment Engineering, 41, 12, pp. 27-34, (2020)
  • [14] DENG J J, ZHANG X F, LIU C, Et al., Research on penetration of asymmetrically grooved nose projectile into concrete target, Acta Armamentarii, 39, 7, pp. 1249-1258, (2018)
  • [15] WU H J, HUANG F L, WANG Y N, Et al., Experimental investigation on projectile nose eroding effect of high-velocity penetration into concrete, Acta Armamentarii, 33, 1, pp. 48-55, (2012)
  • [16] WU G, FENG S S, DONG Y X, Et al., Experimental study on penetration effects of projectiles with different hardnesses on thick target plate, Acta Armamentarii, 31, pp. 260-263, (2010)
  • [17] KANG J X, LI K J, SONG P., The virtual testing technique of hard-target penetration fuse, Journal of Projectiles, Rockets, Missiles and Guidance, 22, 4, pp. 28-31, (2002)
  • [18] ZHANG Z A, CHEN H J., Research on the key technology for hardware-in-the-loop simulation of hard target penetration fuze, Computer Simulation, 25, 3, pp. 17-20, (2008)
12