High pressure injection technique for hypochlorite treatment of polysulfone hollow fibre membranes

被引:0
|
作者
Zarrebini, Mohammed [1 ]
Saghafi, Reza [2 ]
Semnani, Dariush [1 ]
Mahmoudi, Mohammad Reza [3 ]
机构
[1] Department of Textile Engineering, Isfahan University of Technology, Isfahan, Iran
[2] Textile Engineering Group, Department of Engineering, University of Bonab, Bonab, Iran
[3] Center for Technical Textiles, School of Design, University of Leeds, Leeds, United Kingdom
来源
关键词
Dry-wet spinning process - High-pressure injection - Hollow fibre - Hydraulic permeability - Hypochlorite treatment - Image processing technique - Poly vinyl pyrrolidone - Water flux;
D O I
暂无
中图分类号
学科分类号
摘要
High pressure injection technique for hypochlorite treatment of polysulfone hollow fibre membranes has been developed. This technique allows injection of the hypochlorite solution into the channel of the fibres at a high pressure. The effect of this treatment on water flux of the membranes is studied. The results are compared with the water flux of identical membranes subjected to traditional hypochlorite treatment. Concentrated polymer solution containing polysulfone (PSf) /poly-vinyl pyrrolidone (PVP-K90)/N-Methyl-2-pyrrolidone (NMP) in weight ratio of 15/5/80 together with two types of bore fluids have been used for the production of two types of hollow fibre membranes via dry-wet-spinning process. Distilled water and mixture of NMP/ distilled water are used as bore fluids. Atomic force microscopic analysis and image processing technique (SEM microphotographs) have been employed to investigate performance of PSf hollow fibres treated with the traditional and high pressure injection techniques in relation to the composition of bore fluid. It is observed that in general both treatment methods result in the increase in water flux of the hollow fibres due to elimination of PVP (polyvinyl pyrrolidone) swelling and alteration in pore size and pore distribution. The rate of increase in water flux in the membranes treated by high pressure injection technique is found to be higher in comparison to traditionally treated membranes. It is also found that the membranes produced using a mixture of NMP/ distilled water as bore fluid exhibit a higher rate of flux increase than those produced using distilled water. High pressure injection technique yields to production of highly permeable membranes. In addition, it is found that the composition of bore fluid controls the performance of the membranes subjected to hypochlorite treatment. © 2015, National Institute of Science Communication and Information Resources (NISCAIR). All right reserved.
引用
收藏
页码:405 / 413
相关论文
共 50 条
  • [41] A model for fibre washout during high injection pressure resin transfer moulding
    Bodaghi, Masoud
    Simacek, Pavel
    Advani, Suresh G.
    Correia, Nuno C.
    JOURNAL OF REINFORCED PLASTICS AND COMPOSITES, 2018, 37 (13) : 865 - 876
  • [42] Influences of internal coagulant composition on microstructure and properties of porous YSZ hollow fibre membranes for water treatment
    Zhang, Xiaozhen
    Hu, Jianping
    Chang, Qibing
    Wang, Yongqing
    Zhou, Jian-er
    Zhao, Tiangui
    Jiang, Yuhua
    Liu, Xingqin
    SEPARATION AND PURIFICATION TECHNOLOGY, 2015, 147 : 337 - 345
  • [43] Fabrication of High Flux Polysulfone/Mesoporous Silica Nanocomposite Ultrafiltration Membranes for Industrial Wastewater Treatment
    Ali, Mohamed E. A.
    Shahat, Ahmed
    Ayoub, Tamer Irfan
    Kamel, Rasha M.
    BIOINTERFACE RESEARCH IN APPLIED CHEMISTRY, 2022, 12 (06): : 7556 - 7572
  • [44] Treatment of wastewater containing volatile organics using hollow fibre PDMS-polysulfone membrane system: recovery of organics and water reclamation
    Rajai, Bhavika H.
    Kansara, Ankit M.
    Singh, Puyam S.
    CURRENT SCIENCE, 2016, 111 (03): : 517 - 523
  • [45] Multi-walled carbon nanotubes (MWNTs)/polysulfone (PSU) mixed matrix hollow fiber membranes for enhanced water treatment
    Yin, Jun
    Zhu, Guocheng
    Deng, Baolin
    JOURNAL OF MEMBRANE SCIENCE, 2013, 437 : 237 - 248
  • [46] Preparation of polysulfone-polyamide thin film composite hollow fiber nanofiltration membranes and their performance in the treatment of aqueous dye solutions
    Maurya, S. K.
    Parashuram, K.
    Singh, P. S.
    Ray, P.
    Reddy, A. V. R.
    DESALINATION, 2012, 304 : 11 - 19
  • [47] ANALYSIS OF MEMBRANE-STRUCTURE AND SOLUTE TRANSPORT THROUGH POLYSULFONE HIGH-FLUX HEMODIALYSIS HOLLOW-FIBER MEMBRANES
    NGUYEN, TD
    JIMENEZ, PF
    SOLOMON, BA
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 1994, 207 : 112 - PMSE
  • [48] H2S absorption at high pressure using hollow fibre membrane contactors
    Faiz, Rami
    Li, K.
    Al-Marzouqi, M.
    CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION, 2014, 83 : 33 - 42
  • [49] Copolyimide asymmetric hollow fiber membranes for high-pressure natural gas purification
    Shalabi, Yasser A.
    Yahaya, Garba O.
    Choi, Seung-Hak
    Alsamah, Abdulkarim
    Hayek, Ali
    JOURNAL OF APPLIED POLYMER SCIENCE, 2023, 140 (21)
  • [50] Experimental characterization of voids in high fibre volume fraction composites processed by high injection pressure RTM
    Bodaghi, M.
    Cristovao, C.
    Gomes, R.
    Correia, N. C.
    COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2016, 82 : 88 - 99