A self-calibration method of non-contact voltage measurement based on impedance transformation

被引：0
|
作者：
Huang R. [1 ]
Suo C. [1 ]
Zhang W. [2 ]
Zhu J. [1 ]
Zou X. [2 ]
机构：
[1] College of Science, Kunming University of Science and Technology, Kunming
[2] College of Mechanical and Electrical Engineering, Kunming University of Science and Technology, Kunming
来源：
Yi Qi Yi Biao Xue Bao/Chinese Journal of Scientific Instrument | 2023年 / 44卷 / 03期
关键词：
capacitive coupling; impedance transformation; non-contact; self-calibration; voltage measurement;
D O I：
10.19650/j.cnki.cjsi.J2210805
中图分类号：
学科分类号：
摘要：
For the application of capacitance-coupled non-contact voltage measurement, the coupling capacitance between probe and wire is affected by wire diameter, wire insulation material and relative position deviation. It is difficult to determine the voltage division relation and the voltage cannot be reconstructed. In this article, a self-calibration method of non-contact voltage measurement based on impedance transformation is proposed to realize the self-calibration of sensor gain in practical measurement. Firstly, the basic principle of capacitive coupling voltage measurement is introduced, from which the problems exist and the self-calibration method based on impedance transformation is proposed. Then, the influence of calibration accuracy on system parameters is analyzed by simulation and the principle of parameter selection is given. On this basis, the sensor probe and the circuit topology are developed. Finally, the accuracy test, anti-interference ability test and scene adaptability test of the sensor prototype are carried out. The accuracy test shows that the maximum relative error of voltage amplitude is 0. 59%, and the phase relative error is 0. 76% . The anti-jamming ability test shows that the coaxial probe has good shielding effect on the surrounding coupling electric field. The scenario adaptability test shows that the maximum relative error is 1. 24% when different types of circuits are tested. © 2023 Science Press. All rights reserved.
引用
收藏
页码：137 / 145
页数：8
相关论文
共 25 条
  • [11] WANG J G, ZHAO P CH, WANG Q, Et al., Research on dual-differential Ddot overvoltage sensor based on the inverse problem of electric field, Proceedings of the CSEE, 40, 16, pp. 5363-5373, (2020)
  • [12] WALCZAK K, SIKORSKI W., Non-contact high voltage measurement in the online partial discharge monitoring system, Energies, 14, 18, (2021)
  • [13] ZHANG X H, PANG BO, LIU Y X., Review on detection and analysis of partial discharge along power cables, Energies, 14, (2021)
  • [14] LU W SH, YOU R, ZHOU Y, Et al., Non-intrusive current monitoring microsystem based on monolithic TMR magnetic sensors, Chinese Journal of Scientific Instrument, 41, 6, pp. 1-9, (2020)
  • [15] ZHOU X, WU X T, ZHOU T H, Et al., A novel topology study of TMR sensor arrays for current measurement, High Voltage Electronics, 58, 6, pp. 228-236, (2022)
  • [16] WARWICK J., Fluke T6 electrical testers with fieldsense technology[J], Electrical India, 57, 10, pp. 82-82, (2017)
  • [17] XIE X L, LIU Y D, SUN P, Et al., Intelligent voltage sensors for distribution lines based on capacitive voltage division method, Chinese Journal of Scientific Instrument, 17, 5, pp. 1000-1009, (2016)
  • [18] CHEN Y Q, WU G M, ZHANG W B, Et al., Fast transient overvoltage measurement based on electric field, Journal of Sensing Technology, 30, 3, pp. 385-390, (2017)
  • [19] WANG L Z, ZHANG W B, TAN X Y, Et al., Research and experiments on an external miniaturized VFTO measurement system, Sensors, 20, 1, (2020)
  • [20] YANG P F, WEN X L, CHU Z Z, Et al., Non-intrusive DC voltage measurement based on resonant electric field microsensors, Journal of Micromechanics & Microengineering, 31, 6, pp. 1-12, (2021)
123