Single-pole ground selection method for DC distribution networks based on zero-mode current correlation

被引：0
|
作者：
Zuo P. [1 ]
Qin W. [1 ]
Xia F. [2 ]
Chen X. [1 ]
Yang L. [1 ]
机构：
[1] Shanxi Key Laboratory of Power System Operation and Control, Taiyuan University of Technology, Taiyuan
[2] State Grid Jinzhong Taigu District Power Supply Company, Jinzhong
来源：
Dianli Xitong Baohu yu Kongzhi/Power System Protection and Control | 2022年 / 50卷 / 13期
关键词：
correlation; distribution system; modular multilevel converter; unipolar earth fault; zero mode current;
D O I：
10.19783/j.cnki.pspc.211262
中图分类号：
学科分类号：
摘要：
The most common fault of a flexible DC distribution system is the single-pole grounding fault. After the occurrence of such a fault, the system will have voltage imbalance between the fault and non-fault poles. This poses a threat to the safe and stable operation of the system, and demonstrates the need for the speed and reliability of the protection scheme. This paper first analyzes the fault current characteristics of a flexible DC distribution system after a single-pole grounding fault, and then verifies the correlation of zero-mode current components at both ends of the line when the fault occurs. Finally, a single-pole grounding line selection scheme based on the correlation of zero-mode current at both ends of the line is proposed. This protection scheme makes full use of the inherent transient characteristics of the system after failure and does not need to use boundary elements to construct boundary characteristics. A modular multilevel converter (MMC)-based electromagnetic simulation model of a flexible DC distribution system is built on a real time digital simulator (RTDS) to verify the effectiveness of the scheme. The results show that the proposed route selection scheme can identify fault lines quickly and reliably, and has a strong capability to withstand transition resistance, noise and transmission delay, and is not affected by AC side faults. © 2022 Power System Protection and Control Press. All rights reserved.
引用
收藏
页码：86 / 96
页数：10
相关论文
共 31 条
  • [11] LI Zhenxing, WANG Lu, TAN Hong, Et al., New criterion for pilot protection of UHVDC transmission lines based on U-I characteristic, Smart Power, 48, 10, pp. 16-23, (2020)
  • [12] CHU Xu, SUN Jinchen, Analysis of single-pole fault unbalanced current and improvement of a differential protection scheme for HVDC transmission lines, Power System Protection and Control, 49, 2, pp. 47-56, (2021)
  • [13] LIN Jun, WEI Tianjing, JIANG Hongliang, Et al., A differential protection method for distribution network with 5G mobile communication, Electric Power Information and Communication Technology, 19, 10, pp. 20-29, (2021)
  • [14] AZIZI S, SANAYE-PASAND M, ABEDINI M, Et al., A traveling-wave-based method ology for wide-area fault location in multiterminal DC systems, IEEE Transactions on Power Delivery, 29, 6, pp. 2552-2560, (2014)
  • [15] HUANG Dachao, LI Haifeng, XU Canxiong, Et al., Faulted traveling wave characteristics of parallel hybrid multi-terminal DC lines under unipolar-bipolar hybrid operation mode, Guangdong Electric Power, 33, 4, pp. 48-57, (2020)
  • [16] FARHADI M, MOHAMMED O A., Event-based protection scheme for a multiterminal hybrid DC power system, IEEE Transactions on Smart Grid, 6, 4, pp. 1658-1669, (2015)
  • [17] BUCHER M K, FRANCK C M., Contribution of fault current sources in multiterminal HVDC cable networks, IEEE Transactions on Power Delivery, 28, 3, pp. 1796-1803, (2013)
  • [18] NING Lianying, TAI Nengling, ZHENG Xiaodong, Et al., Research on MMC-HVDC transmission line protection scheme based on one terminal transient current, Proceedings of the CSEE, 37, 17, pp. 5010-5017, (2017)
  • [19] YU Xiuyong, XIAO Liye, LIN Liangzhen, Et al., Single-ended fast fault detection scheme for MMC-based HVDC, High Voltage Engineering, 44, 2, pp. 1-8, (2018)
  • [20] ZHANG Chenhao, SONG Guobing, DONG Xinzhou, A non-unit adaptive traveling wave protection method for high impedance faults, Proceedings of the CSEE, 40, 11, pp. 3548-3557, (2020)
1234