Influence of chemical composition on the conductivity and on some mechanical properties of Mg-doped Cu-Si alloy

被引：3

作者：

Nnakwo K.C. ^{[1
]}

Mbah C.N. ^{[1
]}

Ude S.N. ^{[2
]}

机构：

[1] Department of Metallurgical and Materials Engineering, Enugu State University of Science and Technology, P. M. B 01660, Agbani

[2] Department of Metallurgical and Materials Engineering, University of Nigeria, Nsukka

来源：

Journal of King Saud University - Engineering Sciences | 2020年 / 32卷 / 05期

关键词：

Conductivity; Ductility; Grains; Magnesium; Silicon; Strength;

D O I：

10.1016/j.jksues.2019.03.005

中图分类号：

学科分类号：

摘要：

This study discussed the influence of chemical composition on the conductivity and on some mechanical properties of Mg-doped Cu-Si alloy. The structural changes accompanying variations of the alloy chemical composition was investigated using Carl ZEISS Scanning Electron Microscope (SEM) (EVO/NA10) and Energy Dispersive Spectroscopy (EDS). The study also discussed the implication of structural changes on the electromechanical behavior. The results obtained were analyzed statistically using one-factor response surface method (RSM-Design Expert software) to evaluate the level of significance of magnesium addition on Cu-3Si-Mg ternary alloy properties. The SEM results revealed fine grains in the Mg-doped Cu-3Si alloy. The study recorded improvement of properties: average ductility of 25.1%, UTS of 285 MPa; hardness of 318 BHN and average electrical conductivity of 53.9% IACS. The statistical analysis indicated that magnesium significantly improved all the tested properties haven recorded P-values < 0.05. The result of optimization revealed Cu-3Si-0.837 Mg as the optimal composition. © 2019 The Authors

引用

页码：287 / 292

页数：5

共 50 条

[41] Microstructure and Mechanical Properties of Ultrafine Quaternary Al-Cu-Si-Mg Eutectic Alloy
Cai, Qing
Cantor, Brian
Tong, Vivian S.
Wang, Feng
Mendis, Chamini L.
Chang, Isaac T. H.
Fan, Zhongyun
METALS, 2022, 12 (01)
[42] Effects of Cr Addition on the Microstructure and Mechanical Properties of an Al-Si-Cu-Mg Alloy
Sun, Fengshan
Wen, Xin
Sun, Shuaifei
Lu, Yuanyuan
Xiao, Wenlong
Ma, Chaoli
MATERIALS, 2024, 17 (14)
[43] Effect of Zr Content on Microstructure and Mechanical Properties of Al-Mg-Si-Cu Alloy
Sun, Y. P.
Zhou, X. H.
Xu, W. B.
He, J. M.
Wang, W. X.
HIGH PERFORMANCE STRUCTURAL MATERIALS, 2018, : 401 - 406
[44] Microstructure and mechanical properties of spray deposited Al-Si-Fe-Cu-Mg alloy
Harbin Institute of Technology, Harbin 150001, China
不详
Jinshu Xuebao, 3 (252):
[45] The Effect of Thixoforming Process on The Microstructures and Mechanical Properties of Al-Si-Cu-Mg Alloy
Samat, Saziana
Omar, Mohd Zaidi
Mohamed, Intan Fadhlina
Aziz, Ahmad Muhammad
JURNAL KEJURUTERAAN, 2018, 1 (06): : 1 - 7
[46] Sintering Behaviour and Mechanical Properties of Al-Cu-Mg-Si-Sn Aluminum Alloy
Padmavathi, C.
Upadhyaya, Anish
TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS, 2011, 64 (4-5) : 345 - 357
[47] Structure and Mechanical Properties of Al–Cu–Mg–Si Alloy Prepared by Selective Laser Melting
I. G. Brodova
A. N. Klenov
I. G. Shirinkina
E. B. Smirnov
N. Yu. Orlova
Physics of Metals and Metallography, 2021, 122 : 1220 - 1227
[48] Microstructural development and mechanical properties of interrupted aged Al-Mg-Si-Cu alloy
Buha, J.
Lumley, R. N.
Crosky, A. G.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2006, 37A (10): : 3119 - 3130
[49] Influence of cryogenic thermal treatment on mechanical properties of an Al-Cu-Mg alloy
Araghchi, M.
Mansouri, H.
Vafaei, R.
MATERIALS SCIENCE AND TECHNOLOGY, 2018, 34 (04) : 468 - 472
[50] Influence of Zr on the microstructure and mechanical properties of an Al-Zn-Mg-Cu alloy
Yang, Shoujie
Xie, Youhua
Dai, Shenglong
Yan, Minggao
2006 BIMW: 2006 BEIJING INTERNATIONAL MATERIALS WEEK, PTS 1-4: MAGNESIUM, 2007, 546-549 : 1069 - +

← 1 2 3 4 5 →