Study on the curing performance and microscopic action mechanism of OPC-MCA curing agent on shield waste muck

被引:0
|
作者
Zhang H. [1 ]
Wang W. [2 ]
Deng S. [3 ]
He H. [1 ]
Liu T. [1 ,4 ]
机构
[1] Shandong Provincial Key Laboratory of Marine Environment and Geological Engineering, Ocean University of China, Qingdao
[2] School of Resources and Safety Engineering, Central South University, Changsha
[3] School of Marine Earth Sciences, Ocean University of China, Qingdao
[4] Laboratory for Marine Geology, Qingdao Marine Science and Technology Center, Qingdao
基金
中国国家自然科学基金;
关键词
CT scan; curing agent; mechanical properties; reaction mechanism; shield waster muck;
D O I
10.11817/j.issn.1672-7207.2024.04.020
中图分类号
学科分类号
摘要
A new shield waste muck modification material, OPC-MCA, was prepared by adding ground granulated blast-furnace slag(GGBS), fuel gas desulfurization gypsum(FGDG), calcium aluminate powder, quicklime, and alum to ordinary Portland cement P.O42.5(OPC). Firstly, the optimal ratio of each raw material in OPC-MCA was determined through orthogonal experiments. Then, the shield waste muck generated from the Chengnan Cross-river Tunnel Project in Wuhu City was treated with OPC-MCA and OPC at various dosages ranging from 10% to 40%, and the compressive strength at different curing times(3, 7 and 28 d) was tested. Furthermore, the microstructure, pore and crack characteristics, and mineral composition of the solidified waste muck specimens were observed and analyzed using scanning electron microscope(SEM), industrial CT system, and X-ray diffraction(XRD). The results show that the optimal material ratio of OPC-MCA is 51% OPC, 32% GGBS, 8% FGDG, 5% calcium aluminate powder, 3% quicklime, and 1% alum. OPC-MCA exhibits stronger curing ability on the Wuhu shield waste muck compared to OPC, especially at low dosages. The increase in dosage and curing time results in higher strength and brittleness of the specimens, and some specimens exhibit tensile failure. Calcium aluminium silicate hydrate(C-A-S-H) and monosulfate(AFm), which are not detected in the OPC cured specimens, are detected in the OPC-MCA cured specimens, and the ettringite(AFt) content is also higher. Under the same dosage, the proportion of larger-sized pores as well as the total volume of pores in OPC-MCA cured specimens are smaller than those in OPC cured specimens. © 2024 Central South University of Technology. All rights reserved.
引用
收藏
页码:1492 / 1508
页数:16
相关论文
共 39 条
  • [31] ZHU Zheyu, WANG Zhongping, ZHOU Yue, Et al., In-situ study on micro-nano structure of Portland cement hydration products, Journal of the Chinese Ceramic Society, 49, 8, pp. 1699-1705, (2021)
  • [32] KUMAR S, KUMAR R, BANDOPADHYAY A, Et al., Mechanical activation of granulated blast furnace slag and its effect on the properties and structure of Portland slag cement, Cement and Concrete Composites, 30, 8, pp. 679-685, (2008)
  • [33] XIA Zhongfeng, WANG Zhoufu, LIU Hao, Et al., Research progress on conversion process and regulation of hydrates of calcium aluminate cement, Journal of the Chinese Ceramic Society, 50, 12, pp. 3323-3336, (2022)
  • [34] QIAN Jueshi, YU Jincheng, SUN Huaqiang, Et al., Formation and function of ettringite in cement hydrates, Journal of the Chinese Ceramic Society, 45, 11, pp. 1569-1581, (2017)
  • [35] KELZENBERG A L, TRACY S L, CHRISTIANSEN B J, Et al., Chemistry of the aqueous phase of ordinary Portland cement pastes at early reaction times, Journal of the American Ceramic Society, 81, 9, pp. 2349-2359, (1998)
  • [36] CHEAH C B, TAN L E, RAMLI M., Recent advances in slag-based binder and chemical activators derived from industrial by-products-A review, Construction and Building Materials, 272, (2021)
  • [37] ZHENG Henggen, WANG Weihua, QIU Xinyi, Et al., Mechanical properties of fracture-grouted prefabricated sandstone after thermal-acid coupling treatment: an experimental study, Construction and Building Materials, 411, (2024)
  • [38] LI Sichen, YANG Junjie, WU Yalei, Et al., Research on tensile characteristics of cement-treated soft soil, Journal of Central South University(Science and Technology), 53, 7, pp. 2619-2632, (2022)
  • [39] JTG/T F20—2015. Technical guidelines for construction of highway roadbases