Effects of CrC interlayer on tribocorrosion properties of DLC-coated TC4 alloy in a 0.9 wt% NaCl solution

In this study, DLC coatings with varying thicknesses of CrC interlayers were fabricated on the surface of TC4 alloy by regulating the flow rate of C2H2. The effects of the interlayer layer on the microstructure, mechanical properties, corrosion resistance, and tribocorrosion resistance of DLC coatings were systematically investigated. The results show that as the C2H2 flow rate increases, the CrC interlayer exhibits the structure transitions from columnar crystals to amorphous, resulting in improved hardness. The hardness of the CrC40 interlayer reaches 17.2 GPa, significantly higher than the 9.3 GPa of the Cr underlayer. The CrC interlayer notably enhances the mechanical properties and adhesion strength of DLC coatings. The corrosion current density of the CrC40/DLC coating is 3.07 x 10- 8 A/cm2, significantly lower than that of the DLC coating with only a Cr underlayer. Under high load conditions of 20 N, the tribocorrosion rate of the CrC40/DLC coating is reduced to 2.09 x 10- 7 mm3. (N.m)- 1, representing a significant decrease of 93.9 % compared to the DLC coating. The CrC40/DLC coating exhibits strong adhesion strength, appropriate internal stress and a relatively hard CrC40 interlayer, showing exceptional tribocorrosion resistance.