A New Order Tracking Method for Fault Diagnosis of Gearbox under Non-Stationary Working Conditions Based on In Situ Gravity Acceleration Decomposition

Rotational speed measuring is important in order tracking under non-stational working conditions. However, sometimes, encoders or coded discs are not easy to mount due to the limited measurement environment. In this paper, a new in situ gravity acceleration decomposition method (GAD) is proposed for rotational speed estimation, and it is applied in the order tracking scene for fault diagnosis of a gearbox under non-stationary working conditions. In the proposed method, a MEMS accelerometer is locally embedded on the rotating shaft or disc in the tangential direction. The time-varying gravity acceleration component is sensed by the in situ accelerometer during the rotation of the shaft or disc. The GAD method is established to exploit the gravity acceleration component based on the linear-phase finite impulse response (FIR) filter and complete ensemble empirical mode decomposition with adaptive noise (CEEMDAN) methods. Then, the phase signal of time-varying gravity acceleration is derived for rotational speed estimations. A motor-shaft-disc experimental setup is established to verify the correctness and effectiveness of the proposed method in comparison to a mounted encoder. The results show that both the estimated average and instantaneous rotational speed agree well with the mounted encoder. Furthermore, both the proposed GAD method and the traditional vibration-based tacholess speed estimation methods are applied in the context of order tracking for fault diagnosis of a gearbox. The results demonstrate the superiority of the proposed method in the detection of tooth spalling faults under non-stationary working conditions.